fine size 中文意思是什麼
fine size
解釋
細纖度（纖維）-
While working, the air with dust enters into the sedimentation chamber via wind entrance, dust with large size granule will fall because of sudden expand of the aeriform cubage, then the air will pass the water area of arc boards of the two sides to stir the water. then air with dust will be mixed with water forming water curtain at the exit, fine powder will be collected, purified air will be discharged by blower fans via breakwater and wind exit
工作時含塵空氣從進風口進入沉降室由於氣體的體積驟然膨脹，大顆粒粉塵沉集下來，然後空氣經過兩側弧形板間的水域並將水攪動含塵空氣與水充分混合在出口處形成水幕，較細的粉塵捕集下來，凈化后的空氣經擋水板和出風口由風機排走。 -
( 2 ) the properties of the material with finer andalusite particle size are superior to those of coarse particle size at lower temperature, but properties of material of fine and coarse particle size have little difference at higher temperature. this illustrates that the andalusite particle size can lower the sintering temperature and that it brings forth not remarkable influence on the property of the material when the material is sintered completely
（ 2 ）對于不同粒度的原料，在燒成溫度較低的情況下，粒度小的材料性能明顯高於粒度大的材料，但在燒成溫度較高的情況下，兩者差別不大，說明原料粒度減小能降低製品的燒結溫度，但在制品均完全燒結的情況下對材料性能影響不大。 -
The results show that there is anomalistic crystal whose size reaches nanometer grade in fine pvc ; the crystal structure is damaged by jet - milling, which induces the melting point of nanocrystal pvc decreases from 210 to 128. the nanocrystal pvc induces the decrease of plasicizing time and equilibrium torque and the increase of maximal torque, which show that the nanocrystal pvc have self - plasticization in pvc composites
通過sem 、 tem 、 ftir和dsc測試表明：氣流粉碎制得的pvc微粉中具有不規則納米晶體；氣流粉碎破壞了pvc的晶體結構，使納米晶pvc的熔點從210下降到128 ；納米晶pvc使體系塑化時間、平衡轉距的降低、最大轉距升高，具有自增塑作用。 -
At the same particle size, coarse or fine, performance is comparable.
只要顆粒相同，不管是粗的，還是細的，結果相同。 -
Nasb ： and with the showbread, and the fine flour for a grain offering, and unleavened wafers, or what is baked in the pan or what is well - mixed, and all measures of volume and size
呂震中本：管理陳設餅（或譯神前餅） 、素祭的細面酵薄餅、或是在煎盤上作的、或是用油調勻的，又管理各樣量器和尺度。 -
It is also used as adhesion agent to replace starch. pva is widely used in textile, paper making, building materials, packing, glass, and medicine. good character of service has been displaying when it is used as textile warp size, fabric finishing agent, reagent and additive in polymerization for industry of fine chemicals, adhesion agent for construction coating, and packing material film
聚乙烯醇是一種水溶性高分子聚合物，它具有化學性能穩定溶解性能良好粘著力大等優點，可用作聚合反應的乳化劑和分散劑，同時可取代澱粉等作為膠粘劑，廣泛應用於紡織造紙建築材料包裝玻璃醫藥等行業，在作為紡織用經紗漿料織物整理劑精細化工用聚合物助劑建築塗料用粘合劑以及製成薄膜後作為包裝材料等方面，日益顯示出其良好的使用性能。 -
It is also used as adhesion agent to replace starch. pva is widely used in textile, paper making, building materials, packing, glass, and medicine. sound character of service has been displaying when it is used as textile warp size, fabric finishing agent, reagent and additive in polymerization for industry of fine chemicals, adhesion agent for construction coating, and packing material film
聚乙烯醇pva是一種水溶性高分子聚合物，它具有化學性能穩定溶解性能良好粘著力大等優點，可用作聚合反應的乳化劑和分散劑，同時可取代澱粉等作為膠粘劑，廣泛應用於紡織造紙建築材料包裝玻璃醫藥等行業，在作為紡織用經紗漿料織物整理劑精細化工用聚合物助劑建築塗料用粘合劑以及製成薄膜後作為包裝材料等方面，日益顯示出其良好的使用性能。 -
Material composition of the particles according to size, can be divided into beach gravel beach ( pebble beach ), sand beaches and fine sand beaches
按組成物質顆粒的大小，海灘可分為礫石灘（卵石灘） 、粗砂灘和細砂灘。 -
By performing fourier transformation, the relationship between the turbulent intensity of the particle and that of the carrier fluid was obtained which makes clear that particle size, specific gravity, velocity gradient, and the characteristic frequency of energy - containing eddies are four basic influencing parameters. it is proven theoretically that under certain conditions, the stream - wise and transverse particle turbulent intensities exceed those of the carrier fluid. based on the equations of two - phase flow, the presence of fine sediment suspension is shown to attenuate the turbulent intensity of the water
通過對細小顆粒在剪切流場中運動方程的fourier分析，得到了顆粒脈動強度和流體脈動強度之間的定量關系，表明顆粒粒徑、顆粒密度、流速梯度以及紊動場含能旋渦的特徵頻率是影響顆粒脈動強度的主要因素，首次從理論上證明了在一定條件下，顆粒在縱、垂向的脈動強度均會超過相應的流體脈動強度，為已有的實測資料提供了合理的解釋。 -
The results indicated that, the fabrication process of ultra - fine grain material is mainly determined by the stress, rotate speed and the flux of cooling water. the grain refining and the hardening effect are mostly affected by the rotate speed and the flux of cooling water. compared with commercial ly12, the invalidate strength and the prolongation rate of the ultra - fine grain material are properly improved in the measurement of compression property ; and the abrupt change of the dilatability of the ultra - fine grain material at 500c is found ; also the phenomena of which the grain size of these microstructures is stable when annealed under 300c is observed
研究表明，採用本文提出的摩擦壓扭強變形區轉移法可以得到棒狀的超細晶材料，軸向壓力、扭轉速度和溫度是採用該方法制備超細晶材料的主控參數；試件的旋轉轉速和冷卻速度對變形區晶粒細化和硬化效果影響顯著；超細晶ly12的壓縮性能與淬火+自然時效狀態的ly12壓縮性能相比，斷裂強度和延伸率均有一定程度的增強；超細晶ly12的熱膨脹系數在550左右發生明顯的變化。 -
Methods of test for aluminium oxide - determination of fine particle size distribution method using electroformed sieves
氧化鋁試驗方法.第24部分:粒度分佈測定 -
Chemical analysis methods and determination of physical performance of alumina determination of the fine particle size distribution less than 60 m - method using electroformed sieves
氧化鋁化學分析方法和物理性能測定方法小於60 m的細粉末粒度分佈的測定濕篩法 -
The results show that the composites were more wear resistant than the matrix, contributing to the " volume effect " and " size effect ", the wear resistance increases with the particle content and size. the composite shows better wear resistance than high chromium cast iron material especially in low load and fine abrasive test condition. the results also indicate that the composite strengthened by ageing treatment was more wear resistant than as - cast composite
磨損試驗結果表明，鑄造碳化鎢顆粒增強cu - ni - mn合金基復合材料具有比較高的抗磨料磨損能力，而且其耐磨性隨著鑄造碳化鎢顆粒體積分數及尺寸的增大而提高，表現出了強烈的「體積效應」及「尺寸效應」 ，尤其是在低載荷、細磨料磨損條件下，復合材料表現出更好的而寸磨性，即使與高鉻鑄鐵（ cr28 ）相比也有很大程度的提高。 -
Lifting and lowering of the pringting arm of this machine is vertical, therefore, in case of half - tone printing, presence of screen wire and consistency of aberration are improved ; in case of spot printing, stability and uniformity of inking are enhanced ; fine adjustment and lock of the worktable is independent of each other, so positioning error caused by lock of the worktable can be controlled ; height and pressure of the printing blade and ink - returning blade can be stepless - regulated separately, which improver printing quality and service life of half - tone ; printing travel and half - tone fixing mechanism can be fast adjusted, which is suitable for printing area with different size
本機印刷大臂升降為垂直升隆式，網線版印刷時網線表現率為色差一致性得到提高，實地版印刷的施墨穩定性及均勻性得以加強；工作臺微調與鎖緊獨立，因工作臺鎖緊而帶來的定位誤差得以控制；印刷刀、回墨刀高度及壓力均可單獨無級調節，提高了印刷質量和網版的使用壽命，印刷行程和網版固定機構大小可快速調節，方便不同規格的印刷面積。 -
Test methods for pore size distribution of fine ceramic green body by mercury porosimetry
用水銀孔隙度測定法測定細陶瓷生坯的氣孔尺寸分佈的試驗方法 -
The article aims at meeting a successful weaving of pure cotton fine count and high density satin fabric on new - type air jet loom by using better sizing compatibility of pva, modified starch and acrylic size based adopting processing route of high - pressure & high - concentration & low - viscosity to improve sizing permeability and coverage, increase abrasion - proof, reduce hairiness and to clear shedding
摘要利用pva 、變性澱粉、丙烯漿料各組分之間良好的溶性，採用「兩高一低」上漿工藝路線，以改善漿紗的浸透與被覆增加耐磨，貼伏毛羽，提高開口清晰度，來滿足純棉高支高密貢緞織物在新型噴氣織機上的織造要求。 -
A specialized manufacturer of rhombic metallic mesh, kyowa kogyo can cope with orders for all kinds of rhombic metallic mesh materials including wire rod mesh net, etc. in particular, as a rare manufacturer that is capable off producing fine metallic mesh with a mesh size of 10 20mm, our technology is highly evaluated throughout the industry
本公司生產菱形金屬絲網，能滿足盤條，網眼等所有種類的菱形金屬絲網的製作。特別是，作為能生產1020的細網眼金屬絲網的少數廠家之一，這項技術也獲得了很高的評價。 -
The results indicated : 1 ) the friction interface can transfer continuously and stably with the imbalance cooling thermo - induce. ultra - fine grain column part can be prepared through it. and ultra - fine grain flat part can be obtained through jointing several ultra - fine grain strips in cooling friction stir processing 2 ) the refined grain size and the hardening result are mostly affected by the rotate speed, the friction press and the deformating temperature
實驗結果表明： （ 1 ）通過不平衡冷卻的熱誘導作用，實現了棒材摩擦界面的持續、穩定轉移，得到了棒狀超細晶組織；通過強冷攪拌摩擦工藝進行細晶帶合併，能夠得到板狀的超細晶組織。 -
The metallogenic elements decrease rapidly in quantity, and are concentrated in the fine size fraction, mainly in the form of sulfide facies
由於草甸發育，顆粒物質遷移受到抑止，水系碎屑沉積物僅出現在2 ~ 3級水系。 -
Abstract : throug analyzing on the separating process of qixing preparation plant, brought forward several recreate policy to improve separating fine size and reduce the capital, so as to increase economic efficient
文摘:通過對七星選煤廠分選工藝的分析，提出了幾個改進措施，以提高其分選精度，降低噸煤成本，提高經濟效益。
分享友人