first harmonic current 中文意思是什麼

first harmonic current 解釋
基諧電流
  • first : adj 1 最初的，最早的。2 最上等的，第一流的。3 基本的，概要的。4 高音（調）的。n 1 最初，第一；第...
  • harmonic : n 1 【音樂】泛音；和聲。2 〈 pl 〉【數學】諧函數，調和函數。3 【物理學】諧波，諧音。adj 1 和睦的...
  • current : adj. 1. 通用的，流行的。2. 現在的，現時的，當時的。3. 流暢的；草寫的。n. 1. 水流；氣流；電流。2. 思潮，潮流；趨勢，傾向。3. 進行，過程。
  1. The way of taking one nth out of capacitor ' s the first harmonic capacitive reactance as its nth harmonic impedance is verified whit the data from tang7c. according to the approximately estimating method, the first harmonic impedance of 220kv system is calculated. on the basis of the models, this paper gives the harmonic equivalent circuit of substation and gives the b ( n ) function of the harmonic time n. when the capacitors has different combination, b ( n ) ' s value will also change, with the inputting local measurement data, the paper studies the series and parallel resonance at the substation, and deduces that the reason the capacitor ' s fuse of tang6c is frequently interrupted is that its capacitor current contains a large number of 5th harmonics, and that the reason the discharging pt of tang7c capacitor being exploded is also that the 7th and 9th harmonic currents are amplified

    據此，對該站進行了串聯諧振分析和並聯諧振分析，並結合測試數據和有關變電站的運行記錄，指出了導致該站電容器湯6c頻繁燒保險的主要原因是5次諧波電流含量偏高，引起湯7c放電pt爆炸也是因為7次和9次諧波電流被放大。針對這些導致湯陰變電站補償電容器故障的原因，提出了相應的諧波治理措施，包括針對湯6c電容器5次諧波電流含量偏高的原因，提出了停運湯6c電容器或者通過把湯sc電容器的部分容量併入湯6c電容器（湯sc其餘部分停運）以增加湯6c諧波承受能力的措施;針對# 2變低壓側7次和9次諧波電流被放大的現象，提出了在湯7c電容器上加裝一定百分比的串聯電抗器的措施。
  2. Have studied generator ground model mostly used in detail for middle and big domestic generator units. calculates and deduces fault current as grounding of single phase and third harmonic fault protection schemes. first time contributes overall knowledge about generator neutral grounding of distribution transformer with secondary resistor, in which considered inductance of the transformer to people

    針對大中型發電機的兩種主要接地方式進行了分析，進行了接地故障電流、三次諧波保護的計算推導，首次在接地變高阻接地方式有關公式推導中計入接地變感抗，從而使人們對接地變高阻接地認識更為全面。
  3. What have made a large amount of harmonic and high electro - magnetic interference ( emi ) has two reasons. the first reason is mainly the hard - switching pwm mode. the switch turns on at high voltage and turns off at high current in a short time ( ns ), which leads to a high du / dt and di / dt and emi

    其原因一是由於硬開關的pwm調節方式，電子開關速度很快（ ns數量級）在高電壓下導通，大電流下關斷，導致很高的du dt和di dt ，產生很強的尖峰脈沖，對周圍環境造成電磁干擾。
分享友人
分享到 Line

分享到臉書