flame current 中文意思是什麼

flame current 解釋
電弧電流
  • flame : n 1 火焰；光輝，光芒；【火箭】火舌。2 熱情，激情。3 〈俚語〉愛人，情人。4 〈口語〉（電腦網路上的...
  • current : adj. 1. 通用的，流行的。2. 現在的，現時的，當時的。3. 流暢的；草寫的。n. 1. 水流；氣流；電流。2. 思潮，潮流；趨勢，傾向。3. 進行，過程。
  1. First the author introduces the design of the flame monitoring system based on pic16f877 mcu in details. the detector, ( ecadata company ’ s production ), si - photodiode, is used as the sensor. its photoelectric current output is proportional to input light ’ s energy

    經方案比較，決定選用基於火焰的紅外光譜輻射特性的火焰檢測原理，研製開發火焰監測系統，檢測元件選擇ecadata公司生產的紅外雪崩型硅光電二極體，光電二極體在接受紅外輻射時，其產生光電流的大小與入射光能量成正比。
  2. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性（壽命）試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  3. The results of mathematical simulation, which indicate the influence of flame plume length on temperature ( flame space temperature, metal level temperature, inside surface temperature at crown ) and on glass melt current in furnace were introduced and analyzed

    介紹並分析了火焰長度對窯內溫度（火焰空間溫度、液面溫度和窯頂內表面溫度）及對窯池內液流影響的數值模擬的結果。
  4. Numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation. it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source. the flame area which has developed from the fire source is an area of chemical reaction caused by combustion. even if grids in the vicinity of the fire source are made fine, it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface. therefore, we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results. it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall. the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume

    運用cfd進行數字模擬，以了解縱向通風隧道內熱煙氣流的特性.通過模擬發現對火源進行模擬非常重要，熱煙氣流特性受火源位置的影響很大，並且對火源模擬方法很敏感.火源生成的火焰區是燃燒引起的化學反應區域.即使火源附近的木垛排列完好，也很難在考慮這些化學反應條件下模擬熱生成區域.建議考慮縱向通風隧道內火焰形狀並對它進行數字模擬.模擬結果與試驗結果非常吻合.試驗證明，在縱向通風隧道內，熱煙氣流從靠近墻體火源處順風向隧道中心蔓延.數字模擬結果發現，火災羽流造成的螺旋上升空氣會在墻體和羽流之間形成一個渦流區
  5. Abstract : numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation. it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source. the flame area which has developed from the fire source is an area of chemical reaction caused by combustion. even if grids in the vicinity of the fire source are made fine, it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface. therefore, we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results. it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall. the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume

    文摘:運用cfd進行數字模擬，以了解縱向通風隧道內熱煙氣流的特性.通過模擬發現對火源進行模擬非常重要，熱煙氣流特性受火源位置的影響很大，並且對火源模擬方法很敏感.火源生成的火焰區是燃燒引起的化學反應區域.即使火源附近的木垛排列完好，也很難在考慮這些化學反應條件下模擬熱生成區域.建議考慮縱向通風隧道內火焰形狀並對它進行數字模擬.模擬結果與試驗結果非常吻合.試驗證明，在縱向通風隧道內，熱煙氣流從靠近墻體火源處順風向隧道中心蔓延.數字模擬結果發現，火災羽流造成的螺旋上升空氣會在墻體和羽流之間形成一個渦流區
  6. Firstly, the theories in laminar flow flame transmitting, gas jet current and flame stabilization are analyzed and the process of burning in burners and affected factors of flame stability is acquainted with, which can provide theoretical support to propose reconstructive plans

    首先，分析層流火焰傳播、氣體射流以及火焰穩定性理論，了解燃燒器中燃燒過程和火焰穩定性的影響因素，為下面改造方案的提出提供理論支持。
  7. Soft, flexible, flame retardant, high temperature resistance ( around 200 ), seal, tight in tolerance ( + / - 0. 1 ), low cost, ideal replacement of the current conductive foam

    柔軟，阻燃，耐溫，密封，尺寸公差小，完全可替代市面全方位導電泡棉。
  8. The current - carrying capacity of fire resistance and flame retardant pvc insulated wire and cable is same as that of ardinary wire and cable

    防火阻燃型聚氯乙烯絕緣電線線纜載流量和普通電纜相同。
  9. The mechanism of the flame retardation, current situation of the application and modification technology of magnesium hydroxide flame retardant are reviewed, and the trend of the development of magnesium hydroxide flame retardant is prospected

    摘要綜述了氫氧化鎂阻燃劑的阻燃機理，應用現狀，改性技術；展望了氫氧化鎂阻燃劑未來的發展趨勢。
  10. An attempt has been made in the paper at presenting a current development of flame - retardant polyamide textiles including the flame - retardant performance, action mechanism and evaluating methods. furthermore the trend of development in flame - retardant polyamide textiles is described

    本文介紹了阻燃聚酰胺纖維織物的國內外研究現狀，總結了聚酰胺纖維織物的阻燃改性方法、阻燃機理以及相關阻燃評價方法，並展望了阻燃聚酰胺纖維織物的發展前景。
分享友人
分享到 Line

分享到臉書