flame intensity 中文意思是什麼
flame intensity
解釋
火焰強度-
Design should recognize that burner flame length shortens and intensity of radiation increases as pressure increases.
設計時必須認識到當壓力增加時火焰的長度縮短而輻射強度增加。 -
In the part of the transmitter, the pre - amplifier logarithmic amplifier, temperature complement circuit, anti - disturbing circuit, and v / i circuit, are discussed. the transmitter outputs 4 - 20ma. in the part of the displayer hardware design, the i / v convert circuit and the flame intensity signal processing circuit are introduced
在探頭的設計中，詳細介紹了前置對數放大器電路設計，在對數放大器加入了溫度補償電路和抗干擾電路，以保證測量精度和較大的量程，最後信號經電壓電流的轉換，得到4 - 20ma的標準信號作為探頭的輸出信號，進行遠傳。 -
This paper aims at the characteristics of thermal response of lpg vesse1 under high temperatue, conjoining the project of " study on transportation safety early - wdring system of lpg dangerous goods " supported by transportation departinen of china and the project of " mechanism study and numerical simulation of the explosion of lpg vessel " supported by science foundation of hubei province. the interdisciplinary research has been done among temperature field distribution of lpg vessel under flame surroundings, intensity calculation, crack propagation predication and mechanism of explosive accident, etc. three parts are analyzed and discussed
本文針對高溫環境下液化氣壓力容器的熱響應特性問題，結合交通部重點科技項目「液化氣體類危險品運輸安全預警系統的研究」和湖北省自然科學基金項目「液化氣容器爆炸機理研究及數值模擬」 ，對在火焰包圍下的液化氣壓力容器的溫度場分佈、強度計算、裂紋擴展預測以及爆炸事故機理等方面開展了多學科的交叉研究。 -
The research result shows that the influence of impressed electromagnetic field strengthen the gas explosion, and make the flame propagation speed, the flame propagation speed peak value and the overpressure peak value enlarged ; with the increase of electromagnetic field intensity, the effects on aggravating the gas explosion raise
研究結果表明：外加電磁場使瓦斯爆炸強度增加，使火焰速度、火焰速度峰值、壓力波超壓峰值增大，隨著電磁場強度增加，其對瓦斯爆炸加劇作用增強。 -
The gasoline flame radiation intensity and flicker frequency are both monitored to improve the system reliability. thus it is trusted “ flame on ” only under the case when the radiation intensity and flicker frequency are both above the threshold values ; otherwise it is treated as “ flame blowout ”. then the transmitter, the displayer and the software also are present
本設計中採用同時測量火焰輻射強度和燃燒時閃爍頻率的方式保證監測的可靠性，當頻率和強度均高於設定的閾值時，判定為「有火」 ;反之，判定為「無火」 。 -
The chemical reactions in the flame area are very complex. it is very difficult to measure the number density distribution of the particles ( atoms, ions and molecules ), so the relative intensity method is employed
由於固體推進劑燃燒區內發生的化學反應非常復雜，直接測量火焰區內的粒子（原子、離子以及分子等）數密度比較困難，因此選用相對強度法來進行計算。 -
The characters of the flame monitoring system are that, both flame intensity and frequency are measured fast and reliable, the intensity value, the frequency
另外，可通過鍵盤切換選擇顯示火焰燃燒強度值、頻率值、強度閾值、頻率閾值。
分享友人