flexural deformation 中文意思是什麼
-
Kongxi buried hill shows following features in the seismic profiles : the structures are asymmetric. there is flexural syncline on the east side and a monocline on the west side. asymmetric repetition of stratigraphic units is present in the drill wells and the dips of beds and faults are gentle. the permo - carboniferous system of both sides almost lie in the same slope and the events of cambrian or upper proterozoic are continuous from east to west. the phenomenas suggest that kongxi buried hill could be a thrust belt been traced which consists of reverse faults. the imbricate faults mainly effect pre - jurassic strata. there are obvious angular unconformity between jurassic - cretaceous system and paleozoic involved deformation of thrust. the thrust front in some place has cut off the beds of jurassic - cretaceous system. the structural style of the thrust structure changes along the strike of the kongxi buried hill
地震和鉆井資料揭露的孔西構造帶前第三系潛山的地質特徵可以歸納為：構造帶總體上不對稱構造帶內部有地層重復現象石炭二疊系地層的位置明顯高於兩側的同一地層的高度。用由34條向東傾斜的逆沖斷層組成的疊瓦扇構造模式能夠比較合理地解釋上述地質特徵。該帶向東傾斜的逆沖疊瓦狀斷層組主要影響前侏羅系地層，侏羅白堊系與捲入逆沖構造變形的古生界地層之間有明顯的角度不整合。 -
The deformation of the waffle slab can be calcu1ated by using the tab1es of two - - way so1id s1ab. but with a changing flexural rigidity coefficient, which was very c1ose to the test va1ue in the uncracked and cracked stages
根據試驗結果，用極限平衡法可以便捷和較為準確地求得雙向密肋樓蓋的極限平衡荷載；提出了利用雙向板表格計算雙向密肋樓蓋的變形。 -
The results show that pva - dfrccs can lighter the concrete, develop the compression / flexural / tensile splitting strength and flexural toughness, decrease the deformation of both dry shrinkage and autogeneous shrinkage and decrease the permeability of chloride ion. experimental results reveal as well that attapulgite can improve significantly properties of interface and optimize properties of dfrccs
研究結果表明這種新材料能夠減輕材料自重，增進材料的抗壓、抗折、劈裂抗拉和抗彎強度，較好地抑制纖維材料中的乾燥收縮和自收縮現象，提高纖維材料的氯離子抗滲性。 -
The influence of such parameters as axial load index, aspect ratio and percentages of lateral reinforcement, on seismic performance of reinforced concrete frame column in hong kong and analyses the distribution relationships of flexural deformation, shear deformation and slippage of longitudinal reinforcement in joint zone
根據試驗結果，討論了軸壓比、配箍率、剪跨比等參數對其抗震性能的影響，分析了水平荷載作用時塑性鉸區的彎曲變形、剪切變形和縱向鋼筋粘結滑移變形所產生的位移在框架柱總水平側移中所佔的比例及其變化規律。 -
Advanced technical ceramics. methods of testing monolithic ceramics. thermo - mechanical properties. determination of flexural creep deformation at elevated temperatures
高技術陶瓷.整體陶瓷的試驗方法.熱機械特性.在升溫條件下測定撓曲蠕變變形 -
Advanced technical ceramics - methods of testing monolithic ceramics - thermo - mechanical properties - determination of flexural creep deformation at elevated temperatures
高技術陶瓷.整體陶瓷的試驗方法.熱機械性能.用加溫法測定彎曲蠕變變形特性 -
The results of experiments shows that core column can increase flexural and shear resistant capacity and improve deformability and entirety of composite walls ; it is coordinate ductility of two composite walls joining wire or steels out - of - plane ; the seismic of composite walls joining with wire is fine than joining with steels ; the deformation of out - of - plane only affect the crack - loading, the ultimate carrying capacity and ductility in - plane nearly has no change
墻片試驗表明:芯柱可以增加復合墻體的抗彎和抗剪承載能力，改善墻體的變形能力和整體性;分別應用鋼絲網片和鋼筋連接的兩種復合墻體的平面外延性大致相同，內外葉墻協同工作良好;內外葉墻之間的連接提高了外葉墻砂漿層抗拉強度，同時也提高了復合墻體向外葉墻方向的抗推和抗拉承載力。 -
However, for small span - to - depth ratio coupling beams are counter flexural deep beams restrained at their two ends and points of contraflexure at the center of the span, the rules of their carrying forces and deformation are not like common deep beams
但是，小跨高比連梁屬于兩端被約束，反彎點在跨中的反對稱彎曲深梁，其受力和變形規律不同於一般深梁。 -
Based on the continuous damage theory, considering the shear effect, the high - order shearing, flexural and in - plane deformation coupling model is built ; through the nonlinear fem analysis of rc beams strengthened with frp, the damage theory and damage course is researched ; compared with experiment results, it shows that the model is effective ; the fem analysis software is prepared to provide simple and effective method for the engineering application ; using the soft the frp strengthened beams before and after damage is modeled so as to provide the theory base for engineering application
摘要基於連續損傷理論，考慮膠層的剪切效應，建立frp加固鋼筋混凝土梁的高階剪切彎曲及面內變形耦合模型，編制了有限元分析的軟體，進行非線性有限元分析；通過與已有的試驗結果進行對比，證明該模型的簡單，有效性；利用該軟體對未加固混凝土梁，初始進行加固的混凝土梁以及最大拉應變達到極限值時進行加固的混凝土梁等幾種情況進行數值模擬。 -
On the basis of relative researches in the world, according to the study status of steel - concrete composite slab, which would be widely used in modern bridge, modified equivalent inflexibility of steel - concrete composite slab was deduced by use of conversion section principle in this paper ; based in this, this paper put forwards the theory of ultimate flexural capacity of steel - concrete composite slab in consideration of slip effect, and introduces the practical simplified method for calculating flexural deformation of steel - concrete composite slab in consideration of the effect of steel studs and welded wire, and conclude that the methods in this paper is veracious and reliable, comparing with the traditional calculating mode ; morever, this paper put forwards the calculating theory and program of the effect analysis of creep and shrinkage to steel - concrete composite slab, using conversion elastic modulus principle, and testifies that the theory is right and the program is reliable and practical
本文在國內外研究成果的基礎上，針對壓型鋼板與混凝土組合板結構在現代橋梁建設中廣泛應用前景和研究現狀，利用換算截面法導出了壓型鋼板與混凝土組合板結構的修正等效慣性矩；在此基礎上，又推出了考慮壓型鋼板與混凝土之間的相對粘結滑移影響的壓型鋼板與混凝土組合板結構極限抗彎承載能力計算理論，並介紹了考慮栓釘、聯結件影響的壓型鋼板與混凝土組合板結構簡化實用撓曲變形計算公式，而且通過與傳統計算理論的分析比較，表明本文提出的計算理論公式的準確可靠性；此外，採用換算彈性模量比法著重提出了壓型鋼板與混凝土組合板結構的徐變、收縮效應分析的計算理論和程序，並通過實例分析計算證明了理論的正確性、程序的可靠性和實用性。 -
Research has been done on the calculating methods of lateral stiffness and bearing capacity of the frame. according to experimental studies, finite element analysis and theoretical analysis, it develops to calculate lateral stiffness of frame with special - shaped columns of greater height - width ratio by using frame with rigid zones, and considering shear deformation of beam and columns. without considering the torsion of the whole structure, assuming the special - shaped column in the rc frame is flexural failure under uniaxial eccentricity force, putting forward the calculation method of flexural strength of special - shaped columns and the shear strength in a story for r. c
對異形柱框架分別按普通框架和壁式框架進行分析，並與空間有限元分析結果和試驗結果進行比較，提出了異形柱框架結構側向剛度的計算方法；在整體結構不產生扭轉且異形柱為彎曲破壞的假定下，提出了異形柱的受彎承載力及受剪承載力計算公式；提出了根據異形柱框架結構的破壞機構確定其樓層受剪承載力的方法。 -
The calculation of flexural deformation of cold - formed steel - deck concrete floors
混凝土組合樓板撓曲變形計算 -
The paper deduced the deformation and flexural bearing capacity formula by the theory of elasticity - plasticity, ultimate - state method
本文分析研究中用彈性理論、彈塑性理論、極限狀態方法推導組合板受彎承載力和變形計算公式。 -
Experimental and finite element analysis of three point bending ( tpb ) test were conducted. it is found material ' s anisotropy of anisotropic materials and poission ' s ratio of isotropic materials all had influence on contact deformation between specimen and fixture. so it is wise to get flexural properties using four point bending test
4 .通過試驗和有限元分析發現，造成對三點彎曲試驗測得的三維編織復合材料的彎曲模量遠低於四點彎曲試驗結果的原因:材料的各向異性和泊松比對於三點彎曲試驗的壓頭和支座處的局部接觸變形影響很大 -
If the shear deformation of a bracing is considered to be small ( e. g., concrete core ) the bracing system was regarded as of flexural - type and if the flexural effect is considered to be small ( e. g. cross bracing in low rise frames ), the bracing system is regarded as of shear - type
當支撐體系的剪切變形跟彎曲變形相比很小時，支撐就被認為是彎曲型支撐（比如支撐為高層建築中的混凝土筒體） ，當彎曲變形跟剪切影響相比很小時則認為是剪切型支撐（比如交叉支撐） 。 -
The lateral deflections of bracing systems are composed of flexural and shear deformation in practical structures
在實際結構中支撐體系表現為彎剪綜合的特性。 -
Numerical modeling of flexural deformation of laneway in layered rock mass
層狀巖體巷道彎曲變形的有限元模擬
分享友人