flexural test 中文意思是什麼
-
A hundred and ninety - four test pieces are tested which involved six kinds of slenderness ratios and five cubic contents, and studies are done on the influence of cubic content and slenderness ratio to compressive strength, split strength and flexural strength of concrete, which lays the foundation of further study
完成了涉及6種長徑比和5種體積摻量的194個試件的試驗，對短切玄武巖纖維體積摻量、長徑比等因素對混凝土抗壓、劈拉、彎拉強度的影響進行研究，積累了大量的數據，為進一步研究奠定了基礎、積累了經驗。 -
Abstract : based on the analysis of the main failures discovered in pavement on steel deck plate and the demanding service condition of the pavement on steel deck, high - temperature rutting test, low - temperature bending test and controlled stress flexural fatigue test are used to study the performance of asphalt mixtures modified by epoxy resin including high - temperature stability, low - temperature cracking - resistance, and fatigue cracking - resistance, which are served to evaluate the modification effect of epoxy resin of different contents. with the addition of epoxy resin, all the three performances are improved greatly. however, when the amount of epoxy resin added is over a certain value, the modification effect will be stable with no extra benefit detected. finally, in terms of the properties of the three respects, 20 ?, 30 ?, 30 ? are given separately as the proposal adding contents
文摘:在分析鋼橋面鋪裝層主要病害和特殊工作環境的前提下，分別採用高溫車轍試驗、低溫小梁彎曲試驗和控制應力小梁彎拉疲勞試驗，研究了不同環氧樹脂摻量下的環氧樹脂改性瀝青混合料的高溫穩定性、低溫抗裂性和抗疲勞性能.試驗結果表明:環氧樹脂對這3個方面都有很大的改進效果，但改性效果和樹脂的添加量並不是一個無限遞增的關系，當添加量超過一定數值以後，改性的效果將趨于平穩.最後就高溫、低溫、疲勞3個方面分別提出環氧樹脂添加量為20 ? ， 30 ? ， 30 ?的建議值 -
Based on the analysis of the main failures discovered in pavement on steel deck plate and the demanding service condition of the pavement on steel deck, high - temperature rutting test, low - temperature bending test and controlled stress flexural fatigue test are used to study the performance of asphalt mixtures modified by epoxy resin including high - temperature stability, low - temperature cracking - resistance, and fatigue cracking - resistance, which are served to evaluate the modification effect of epoxy resin of different contents. with the addition of epoxy resin, all the three performances are improved greatly. however, when the amount of epoxy resin added is over a certain value, the modification effect will be stable with no extra benefit detected. finally, in terms of the properties of the three respects, 20 ?, 30 ?, 30 ? are given separately as the proposal adding contents
在分析鋼橋面鋪裝層主要病害和特殊工作環境的前提下，分別採用高溫車轍試驗、低溫小梁彎曲試驗和控制應力小梁彎拉疲勞試驗，研究了不同環氧樹脂摻量下的環氧樹脂改性瀝青混合料的高溫穩定性、低溫抗裂性和抗疲勞性能.試驗結果表明:環氧樹脂對這3個方面都有很大的改進效果，但改性效果和樹脂的添加量並不是一個無限遞增的關系，當添加量超過一定數值以後，改性的效果將趨于平穩.最後就高溫、低溫、疲勞3個方面分別提出環氧樹脂添加量為20 ? ， 30 ? ， 30 ?的建議值 -
Test method for metallic fibered concrete - measuring the flexural tensile strength limit of proportionality, residual
金屬纖維混凝土試驗方法.測量柔性抗拉強度 -
Test method for metallic fibered concrete - measuring the flexural tensile stength limit of proportionality, residual ; german version en 14651 : 2005
金屬纖維混凝土試驗方法.彎曲拉伸強度的測量 -
Test method for damping capacity of metallic damping materials - torsion pendulum method and flexural resonance method
金屬阻尼材料阻尼本領試驗方法扭擺法和彎曲共振法 -
Back - analysis method and computing program of damage parameters by the curve of stress - strain by uniaxial tension and compression test was made out. 5. by the damage evolving relation proposed the flexural process of the trisection specimens of wet - sieved and fully - graded concrete was numerically simulation
5 .根據本文提出的損傷模型和損傷參量演化關系，分別對濕篩混凝土和全級配混凝土試件進行了三分點加載數值模擬。 -
The deformation of the waffle slab can be calcu1ated by using the tab1es of two - - way so1id s1ab. but with a changing flexural rigidity coefficient, which was very c1ose to the test va1ue in the uncracked and cracked stages
根據試驗結果，用極限平衡法可以便捷和較為準確地求得雙向密肋樓蓋的極限平衡荷載；提出了利用雙向板表格計算雙向密肋樓蓋的變形。 -
Through the dry and wet cycling experiment on unmarred beam and pre - cracked beam, the position of initial corrosion and influence of crack on the reinforcing bar corrosion are studied in this paper both the flexural bearing capacity performance and the material mechanical performance of the beams are studied on the test of full scale concrete beam a model of 3d fem is established to simulate the state of the actual full - sized rc beam and electronic accelerating test beams, computational results and test results are compared
通過對混凝土梁的干濕循環試驗，研究了在混凝土梁中的鋼筋初始銹蝕情況，以及不同寬度的裂縫對于鋼筋初始銹蝕的影響。通過對足尺銹蝕混凝土梁的試驗，研究了混凝土梁在海洋環境侵蝕作用下的材料性能的變化和抗彎承載能力的變化。 -
The basic theory and step of whole process analysis of reinforced concrete beam section flexural rigidity is stated, the realization program is worked out and the academic example is analyzed. 4. based on the static - state load test result of two practical projects, the application of the reinforced concrete beam system bridge structure disease examination and structure damage evaluation method is stated, and satisfaction result is gained
1 、綜述了當前混凝土橋梁結構檢測及損傷識別的各種方法體系，並簡要評價了各方法體系的應用與不足； 2 、論述了基於靜載試驗的梁分段剛度系統識別的基本原理，編制了實現程序，並進行了數值算例分析，提出基於本原理的梁橋結構損傷識別與結構評價方法體系； 3 、闡述了鋼筋混凝土梁截面抗彎剛度全過程分析的基本原理和方法步驟，編制了實現程序，並進行了相關算例分析； 4 、結合兩片工程實例梁的靜載試驗，詳述了梁橋結構損傷識別與結構評價方法的應用過程，得到了預期的效果。 -
Standard test methods for flexural bond strength of masonry
磚石工程彎曲粘結強度的標準試驗方法 -
The effects to beam for its normal section flexural capacity and rigidity and ductibility as well as other properties is discussed with different polypropylene fiber and different concrete strength by the bending test study herein on the reinforced concrete beams and the polypropylene fiber reinforced beams
本文通過對摻聚丙烯纖維砼配筋梁的試驗研究，分析討論了單筋矩形截面梁配筋率相同時，分別考慮聚丙烯纖維摻量和混凝土強度等級等因素對梁的正截面承載力、剛度及延性等幾個方面的影響。 -
Test methods for natural facing stones part 2 : dry and wet test methods for flexural strength
天然飾面石材試驗方法第2部分:乾燥水飽和彎曲強度試驗方法 -
Testing of rigid cellular materials ; flexural test
硬泡沫材料檢驗.抗彎試驗 -
Carbon fibre reinforced plastics - unidirectional laminates - flexural test parallel to the fibre direction
碳素纖維增強塑料.單向層壓塑料.與纖維方向平行的彎曲試驗 -
Aerospace series - glass fibre reinforced plastics - flexural test, three point bend method ; german version en 2746 : 1998
航空航天系列.玻璃纖維增強的塑料.繞曲試驗.三點彎曲 -
Tests relating to pavements. determination of the mechanical characteristics on material bound with hydraulic binders. part 4 : flexural test
路面試驗.水硬性粘結劑材料的機械性能測定.第4部分:撓性試驗 -
Glass fibre reinforced plastics - flexural test - three point bend method
玻璃纖維增強塑料.彎曲試驗.三點彎曲法 -
Aerospace series. glass fibre reinforced plastics. flexural test. three point bend method
航空航天系列.玻璃纖維增強塑料.撓性試驗.三點彎曲試驗法 -
Aerospace series. carbon fibre reinforced plastics. unidirectional laminates. flexural test parallel to the fibre direction
航天航空系列.碳纖維增強塑料.單向層壓板.平行於纖維方向的彎曲試驗
分享友人