fluid model 中文意思是什麼

fluid model 解釋
鈴模型
  • fluid : n 流體，液。 body fluid 體液。 cooling fluid 冷卻液。adj 1 流動的；流體的；液體的。2 容易[可]變動...
  • model : n 1 模型，雛型；原型；設計圖；模範；（畫家、雕刻家的）模特兒；樣板。2 典型，模範。3 （女服裝店僱...
  1. The rheological equations, derived from n - s equation in hydromechanics employing the newton fluid model and the bingham plastic model, demonstrate that damping force can be controlled by changing the magnetic field in the gaps. 4

    流變學方程表明：改變阻尼通道的磁場強度可以控制磁流變阻尼器的阻尼力，從理論上分析了磁路參數和阻尼通道的結構參數對磁流變阻尼器阻尼力的影響。
  2. Adopting two - dimensional incompressible, inviscid fluid model, some problems of flow - induced vibration are investigated

    摘要採用二維不可壓縮無粘流體模型，探討了板狀結構的流致振動問題。
  3. The processes of surface elevation, current velocity in the compound fluid model and suspended sediment concentration in the suspended sediment transport model are verified by observed data of many stations in flood / dry season and in spring / middle / neap tide

    復合流場模型的水位過程、流速過程，以及懸沙模型的含沙量過程則經過了洪、枯季及大、中、小潮的多個站點的實測過程驗證。
  4. Observed tidal harmonic constants in many stations are used to verify the astronomical tides in the compound fluid model. the wave model is tested by a set of wave flume data at first. then the results are compared by the actual processes of significant wave height in gauging stations

    其中復合流場模型中的天文潮利用眾多測站的實測調和常數進行驗證；波浪模型首先進行了水槽實驗的檢驗，然後在臺風過程中，進行了測站有效波高過程線的比較。
  5. In the second part of this paper, it makes a detailed analysis among fluid - model - based, smith - principle - based and two - pd - controllers - based by comparing to the method and application of control theory. then it gets the laws to keep the control loop stable. in order to analyze the dynamic and transient characters, three congestion control algorithms mentioned above have been carried out in the nist atm network simulator and the successful outcomes are brought out

    本論文對atm網路abr業務擁塞控制的控制理論演算法進行了總結，簡要分析了其優點和缺點；運用控制理論的分析方法和觀點對基於流體控制模型、史密斯預估控制模型和雙重比例微分控制模型三種擁塞控制演算法加以具體的分析，從而分析了怎樣確保控制環的穩定性；在nistatm網路模擬軟體中嵌入以上三種擁塞控制演算法，從而對演算法的動態和瞬態特性進行模擬分析，以此證明控制演算法的有效性；最後提出了今後atm網路abr業務擁塞控制演算法的發展趨勢。
  6. Firstly, based on the present research all over the world, a 3d quasi - single phase model is built together with k - equations. the special feature of this model is taking account of the influence of interaction between liquid and gas, that is to say, the influence of interphase drag force, lifting force perpendicular to the relative velocity, virtual mass force and gas or liquid volume fraction in the fluid field have been considered. a 3d two - fluid model is also built in order to describe more accurately the fluid flow on distillation trays by comparing the computational results of quasi - single phase mathematical model with of two - fluid mathematical model

    本文在國內外已有的研究基礎上，首先建立了以k - （封閉模型為基礎的三維擬單相流模型，該模型的特點在於充分考慮了氣液兩相間相互作用的影響，即計入了相間曳力、橫向升力、虛擬質量力和氣、液相含率對流場的影響；並建立了塔板三維雙流體模型，主要目的是通過對比擬單相流數學模型、雙流體數學模型的計算結果，建立能夠準確描述塔板上流體流動的數學模型。
  7. In order to calculate depth - averaged two - dimensional ( 2 - d ) suspended sediment transport under waves and currents in the yangtze estuary, a numerical model system is developed. four models, a 2 - d compound fluid model including wind, waves, tides and river runoff, a swan wave model, a wave - current bottom boundary layer model and a 2 - d suspended sediment transport model are integrated

    本文建立了一個用於波?流共同作用下長江口平面二維懸沙計算的數值模型系統，主要由四部分組成，即考慮風、浪、潮、徑流的二維復合流場模型、 swan海浪模型、波?流相互作用的底邊界層模型以及二維懸沙輸運模型。
  8. In the calculation, the energy deposited in aluminum by proton beams is first calculated by m - c simulation, then a 1 - d elastic - plastic fluid model is used to simulate the following thermal shock wave process as a result of thermal - mechanical effect by proton irradiation. the shape of proton is taken as a rectangle pulse with a width of 0. 1 microseconds, the energy flux o

    對於3mm的鋁材料，入射粒子束為矩形脈沖（脈寬為0 . 1 s ）的情況下，計算得到了電子束、質子束輻照引起鋁材料斷裂的能注量閾值與入射電子束、質子束能量的關系曲線，該曲線存在最小值，分別對應6mev的質子束的34 . 7j cm ~ 2和0 . 35mev電子束的42 . 1j cm ~ 2 。
  9. Using the two - stream fluid model, the linear dispersion relation is derived assuming a two - dimensional spatial geometry. two cases are considered, one is that the 2d spatial geometry is defined by the plane containing the two counterstreaming electron populations and the perturbation wave vector ( referred as the xy plane ), and the other is that the geometry is defined by the plane being vertical to the two counterstreaming electron populations ( referred as the yz plane )

    對高能束流和電子迴流構成的雙流系統，建立冷等離子體流體模型，採用簡正模分析方法，分別考慮擾動波矢在平行於電流傳播方向的平面（記為xy平面）上和在垂直於電流傳播方向的平面（記為yz平面）上這兩種情況，推導了不穩定性的色散關系。
  10. For the case of transporting suspended fine sand, a single - fluid model is used to calculate the flow resistance by solving the navier - stokes equations. the computed agrees well with the measured. and for the case of transporting medium - sized sand, a two - layer model is used and the model produces a good agreement with the experiment data

    對管道輸送細沙懸移質的流場，採用單流體模型進行數值求解n - s方程，計算結果與實驗資料相吻合;對具有分層流動的中沙管道水力輸送，採用兩層代數模型進廳了計算分析，阻力損失的預測結果與實驗吻合較好;最後對管道輸送粗沙的阻力特性和運動機理進行了分析探索，提出了進一步研究的方向。
  11. In chapter two, according to n - s equation, considering the couple between liquid and solid, the double - fluid model is used to respectively set up momentum equations of two - phase fluids in condition of basic hypothesis, which are general equations of two - phase fluids. simplifying the equations in boundary layer, the momentum differential equations are required and the boundary conditions are given. in the same time, the simplifying equations and their solutions, in which solid grain satisfies in boundary layer

    第二章依據n - s方程，考慮到液、固之間的相間耦合，在基本假設條件下，採用雙流體模型，分別建立液、固兩相的動量方程，它是固液兩相流體的一般方程式；對其在邊界層流區內進行量級比較，得到邊界層動量微分方程並給出其邊界條件，同時也得到固體顆粒在邊界層內所滿足的簡化方程及其解的表達式。
  12. Abstract : a continuity wave model is put forward for the dispersion processof liquid - liquid two - phase system, by coupling mass and momentum conservation equations of two - fluid model. the conditions that result in a dispersion choke and the weak instability of a dispersion process are derived from the model. the phenomena of catastrophic inversion and transitional inversion are explained. the effect of drop size distribution on the maximum volume concentration of a emulsion is predicted using the model. according to the theory herein, emulsion inversion is the regime transition of liquid - liquid system due to the instablity of a dispersion process. the effect of drop size distribution on the maximum volume concentration of a liquid - liquid emulsion only occurs in a certain range of weber numbers

    文摘:以雙流體模型為基礎，通過質量守恆方程和動量守恆方程的耦合，提出了液-液兩相系中彌散傳質的連續波模型.由該模型得到彌散傳質過程阻塞和彌散傳質過程弱不穩定性產生的條件，計算了液滴尺寸及其分佈對乳化液極大堆砌分數的影響，解釋了劇變型乳化逆變和漸變型乳化逆變現象.研究結果表明，乳化逆變是由於彌散傳質過程的不穩定性而引起的懸浮體型態的改變，隨液滴尺寸多分散性的增大，極大堆砌分數增大；隨液滴平均尺寸的增大，多分散性對極大堆砌分數的影響減弱；當韋伯數足夠大時，液滴尺寸及其分佈對乳化液極大堆砌分數無影響
  13. The effect of wave radiation stress is considered in the compound fluid model. the value of bottom friction is offered by the wave - current bottom boundary layer model

    復合流場學模型中考慮了波浪輻射應力的作用，底摩擦由波?流相互作用邊界層模型提供。
  14. First, the present thesis gives theoretical investigations on the coaxial bwo using the linear fluid model

    首先，本論文採用線性理論模型研究了同軸相對論返波振蕩器的相互作用過程。
  15. The author puts forward using double pore model and two permeability model and triple medium models to represent its infiltrating fluid model and studies partly the infiltrating fluid. ( 2 ) various kind of test well curve form characteristic crevices - cave model on reservoir was studied. the test well curve of carbonate seam cave oil reservoir divides to 7 styles : homogeneity, double - pore, vertical - transmitting, compound, low - seepage, double - seepage and triple medium

    充分利用動態資料和靜態資料，結合塔河油田碳酸鹽巖儲層特徵，開展典型探井的試井分析研究，將碳酸鹽巖縫洞型油藏試井曲線劃分為7大類：均質儲層油藏、雙孔介質油藏（包括孔隙?裂縫介質油藏、裂縫?孔隙介質油藏） 、垂直導流型油藏、復合油藏、低滲型油藏、雙滲介質油藏和三重介質油藏。
  16. A general reynolds equation based on er fluid model is obtained, which can be easily extended to other non - newtonian fluids and this equation can provide theoretical basis for the hydrodynamic analysis of er journal bearings

    首次推導了基於電流變流體的潤滑問題廣義雷諾方程，並可擴展到其他非牛頓流體的潤滑問題，為進行基於電流變流體的滑動軸承流體動力潤滑分析提供了理論依據。
  17. The bed resistance is obtained by express of the single - fluid model for debris flow

    數學模型採用一種基於三角網格的顯式差分格式?有限節點法。
  18. Then, a pressure - based height field fluid model is proposed and the pressure to simulate the fluid surface height is justified

    在此基礎上給出基於壓力高度域的水流模型，並闡述了該模型的合理性。
  19. Based on the two - fluid model, the attenuation process of blast waves in sprays is simulated by using the eulerian - lagrangian method

    基於雙流體模型，利用euler - lagrange組合方法，對爆炸波在液霧中的衰減過程進行了數值模擬。
  20. We successfully apply the two - fluid model ( tfm ) to the study of two dimensional and three dimensional dense gas - solid flow characteristics. the results show some rules on the particle collisions and gas particle interactive influence of the vertical upward pipe

    在對高濃度氣固兩相流的研究中，成功的運用雙流體模型對兩維和三維垂直立管段進行了研究，揭示了垂直立管內的高濃度氣固流動的顆粒碰撞以及氣相和顆粒相的相互影響的一些規律。
分享友人
分享到 Line

分享到臉書