force drying 中文意思是什麼
force drying
解釋
強制乾燥-
In this paper, the influence of cycles of drying and wetting on strength and deformation are studied by means of routine direct shear apparatus, triaxial apparatus and light consolidation apparatus which include : the influence of force of constraint on strength, the total stress strength of expansive soils with different saturation degree, the influence of cycles of drying and wetting on the total stress strength, the relation between saturation degree and compression modulus and that between saturation degree and void ratio, the influence of cycles of drying and wetting on the effective stress strength, the relation between saturation degree and generalized suction
本文利用常規直剪儀、三軸儀以及輕便固結儀，分別對非飽和膨脹土的強度和變形特性以及干濕循環對強度和變形的影響進行了一系列的試驗研究。以飽和度、干濕循環次數為變量，分別探求了外力約束對膨脹土強度的影響，不同飽和度膨脹土的總應力強度特性，干濕循環對非飽和膨脹土總應力強度的影響，飽和度與壓縮模量以及孔隙比的關系，干濕循環對飽和膨脹土有效應力強度指標的影響，廣義吸力與飽和度的關系，建議了一組計算非飽和膨脹土變形及強度特性的經驗公式。 -
Our factory increase a set of intensifier with non - grade - adjustable rating speed to form the intensive air drying, the wet material mixed with hot air fully by screw feeder in the intensifier and material surface is crashed into fine granules and moving to the outlet as well as drying, under rapid rotating hitting and pushing. in the long run, the materials get a further even drying in the dryer pulled by the wind force and those wet and weighty granules the wind force can not pull continue to be crashed, dried until they are pulled by the wind force into the dryer
我廠強化型氣流乾燥是在基本型上增加一套轉速可以無級調節的強化器組成，濕物料通過螺旋加料器進入強化器后和熱氣流充分混合，在飛速旋轉的擊刀擊碎和推進下，物料被破碎成細顆粒，在乾燥同時向出口移動，最後在風力吸引下進入乾燥管，進一步均勻乾燥，風力無法吸引的濕重顆粒繼續被擊碎、乾燥、直至能被風吸起進入乾燥管。 -
This paper researches the synthetical ore - forming feature of cu - ni sulfided mine of baimazai in jin ping county. this nine is the main force of ni manufacturer. it is exact to look for succeed resource because of the resource has been drying up
本文研究金平白馬寨銅鎳硫化礦綜合信息成礦特徵，該礦作為雲南鎳礦主力生產礦山，由於資源已盡枯竭，急需找尋接替資源。 -
The capillary force can be dropped through vacuum drying process, and compact film with thickness of 6 u m was obtained by low spinning speed and few plating times
鍍膜次數較高時膜內易產生斷層。採用真空乾燥制度后通過低速少次就可以獲得厚度約為6 m的緻密膜。 -
In the purification and drying field that requires the compressed air as a driving force, to obtain the clean compressed air with super low dew point, the absorption and drying process should be incorporated into the purification system of the compressed air
用於凈化與乾燥生產領域作為能源的壓縮空氣，需要在壓縮空氣凈化系統中增加吸附乾燥，方可達到超低露點的潔凈壓縮空氣。
分享友人