four-point loading 中文意思是什麼

four-point loading 解釋
四點載荷
  • four : n 1 四人小組;(套在車上的)四匹馬。2 四的記號;(骰子的)四點;(鐘點的)四時;四歲。3 〈pl 〉 ...
  • point : n 1 尖頭,尖端;尖頭器具;〈美國〉筆尖;接種針,雕刻針,編織針;小岬,小地角;【拳擊】下巴。2 【...
  • loading : n. 1. 裝貨。2. 裝載量;重量;載荷;(船隻等的)貨載。 3. 填充物,填料。4. 額外人壽保險。
  1. With the introduction of the liquid chemical loading and discharging system and how operating in zhenhai district, combining the recent statistics date of the port, the chapter analyzes the berth throughout, use - rate of berth, need of the storage area and point out the main problem now existing. chapter three combining the new project of the district analyzes the handling system layout entirely, meanwhile it builds four series of liquid chemical transfer - lines projects which fit the need of the future

    第二章主要對化工區的發展現狀進行了分析,在簡單的介紹了散裝液體化工品的裝卸工藝和化工區液化裝卸工藝的布局形式和運作方式的基礎上,結合港區現有的各類統計資料,通過對泊位通過能力,泊位利用率和區域貨運量等資料的分析研究,指出了目前化工區液化工藝布局中存在的主要問題,並提出了解決目前存在問題的基本思路。
  2. The authour investigate the dosing conditions and effect of the pac to the huanghe water - source, which includes the following four parts : the selection of the pac ; the confirmation of dosing scheme and effect of the pac ; the research of application of potassium permanganate in combination with pac ; the research of the pac ' s modification and the modified effectiveness. the experiment is mainly carried out on the pilot system in the jieyuan water plan of tianjin. the results of the reseach include the following : l ) the pac from zunhua plant is selected as the better carbon for the source water of tianjin through the experiment ; 2 ) through the pilot experiment we conclude that the pac ' s best adding point is the mixing tank and the better dose is 10mg / l, on which the codmn of filtered water can be decreased to 40 % and the effluent have no problem of odour and color ; 3the adsorbing experiment show that pac mainly adsorb the organic matters which molecular wt., distribution between 500 and 3000, and can adsorb organic matters whose molecular wt., distribution are bigger than 6000 if the dose of it is adequent ; 4 ) pac together with potassium permanganate can remove the organic matter more effectively than each of them alone, and reduce the rising trend of turbidity of the flotation ' s effluent due to adding pac ; 5 ) the thesis made a research on the surface properties and the adsorbing capability of the modified carbon by oxidizer : the modified carbon with 20 % h2o2 can remove more organic pollutants than the untreated one by 12 % when we add a higher dose of coagulant ; 6 ) the modification of reduction and loading metal ions are also sttldied, and drow the following conclusions : the modified carbon with 5 % ammonia can enhance the organic matter ' s removal effectiveness by 10 % to the tianjin source water than the untreated one, and the modified one with loading metal ion remove the organic matters from the tianjin source water better ( 8 % ) than the untreated one due to the strong affinity betwween the humic acid and copper ion

    本文的實驗主要是在天津芥園水廠的中試系統上完成的,論文的成果和結論主要包括: 1 )通過靜態實驗選定河北遵化活性炭廠生產的煤質炭為適合天津原水的炭種; 2 )中試實驗確定粉末活性炭的較佳投加點為混合池投加,較佳投加量為10mg l ,此時可使濾后水的cod _ ( mn )降低40 ,且可較好地控制濾后水的嗅味和色度; 3 )初步確定粉末活性炭對原水中有機物的吸附主要集中在分子量在500 - 3000范圍內,投量增大時可吸附部分分子量大於6000的有機物4 )中試實驗表明:粉末活性炭與高錳酸鉀聯用可取得較兩者單獨應用時對有機物更好的去除效果,且對因投加粉末活性炭而造成的氣浮出水濁度升高有一定的改善作用; 5 )研究並初步確定氧化改性對粉末活性炭表面性質和有機物的去除效果的影響:粉末活性炭的氧化改性會使其表面的酸性官能團大量增強,表面極性增加;經20的過氧化氫改性的活性炭在增大混凝劑投加量( fecl _ 3投量為15mg l )時對有機物的總體去除效果較原活性炭提高12 , 1次氯酸鈉改性活性炭對有機物的去除效果較原活性炭提高6 ; 6 )研究並初步確定還原改性、負載金屬離子對原水中有機物的去除效果的影響:經5氨水改性的活性炭可提高天津源水中有機物的去除率達到10 ;負載銅離子后的活性炭可提高對腐殖酸類物質的去除能力,一般可提高8左右。
  3. Standard test method for flexural strength of manufactured carbon and graphite articles using four - point loading at room temperature

    在室溫下用四點負荷法測定炭加工品及石墨製品撓曲強度的標準試驗方法
  4. The experiment method of double - edges four - point loading is used to analyze the mechanism of model facture of beton

    利用四點剪切加載的試驗方法分析了混凝土型斷裂的機理,發現混凝土型斷裂具有明顯的尺寸效應。
  5. Test method for flexural strength of manufactured carbon and graphite articles using four - point loading at room temperature

    在室內溫度條件下利用四點加載進行碳與石墨人造物撓曲強度試驗方法
分享友人