frame amplitude 中文意思是什麼
frame amplitude
解釋
幀幅度-
Based on extensive investigation of construction technique history of chinese ancient buildings, the structure method, structure developing history and seismic behavior of chinese ancient timber structure buildings are analyzed in several respects of the structural system and form. through a series of experiments on constituent parts of chinese ancient timber building structure, including the tests on the corbels and brackets called dougong subjected to low cyclic reversed loadings, the tests on the wooden frame using the tenon - mortise joints as connections of column and beam subjected to low cyclic reversed loadings, the tests on vibration isolation effect of friction and slippage between column footing and their socle base, and a series of shaking table tests on a chinese ancient timber structure palace building mode under artificial earthquake at serving conditions, destroyed conditions and reinforced conditions, many valuable results of structures such as moment - curvature hysteretic loops of dougong structure and tenon - mortise joints under low cyckc reversed loadings, the static function, the seismic performance, energy dissipation, vibration reduction, energy - loss mechanism, nechanicalmode and failure mode were studied. aplenty of valuable parameters of the structure system were obtained, such as the natural period of structure, vibration modes, damping ratio, factor of vibration isolation, oscillate amplitude of ineitial accebration, velocity and displacement, magnitude of slippage, and the mechanism of structure failure and collapse etc. based on these research, the complete analysis of ancient timber structure under earthquake were carried out in which including mechanism analysis method, calculating mode, strength analysis of members and joints, strengthening methods for serving damaged ancient timber structure buildings were also taken into account
依照宋代《營造法式》建造了抬梁式殿堂木結構構件及結構模型，對中國古代木結構中的典型構造如：柱腳在礎石頂面平擱簡支、柱架榫卯連接、柱高不越間之廣、側腳、生起、斗拱等的構造機理及結構功能進行了量化分析和實驗研究： （一）通過木柱石礎靜摩擦試驗，測定了柱腳與石礎古鏡面間的摩擦系數及摩擦力隨上部結構荷載變化的規律； （二）通過單柱承載力試驗，測定了古建築中木柱的受力變形特徵、破壞模式、及模型材料的變形模量、極限承載力、極限變形等參量； （三）通過柱架低周反復荷載試驗，測定了柱架的抗側移剛度、柱架恢復力特性及滯回曲線、榫卯張角剛度及其變化規律、柱架及榫卯的極限承載力和極限變形、及榫卯減振參數； （四）通過斗?低周反復荷載試驗和受壓試驗，測定了古建築木構件與木構件間摩擦系數，斗?抗側移剛度，斗?恢復力特性及滯回曲線，斗?抗壓極限承載力及受力變形規律； （五）通過抬梁式殿堂間架模型振動臺試驗，測定了殿堂木構架結構自振周期，地震反應振形、阻尼特性及阻尼比；按結構分層特點對柱腳、柱頭和斗?層上的屋蓋的地震反應採用多點同步測量，對柱根滑移、榫卯變形、斗?的變形、復位、耗能減振參數等進行了定量分析。 -
By computation and practical example of running machine, it is shown that the frame foundation under high - frequency machine should nut be designed in design principle of avoiding resonance, but should be designed in contral principle of vibration amplitude
摘要通過對工程實例的計算和機器的實際運行監測結果分析表明，在高轉速機器作用下的框架基礎按共振法控制的設計原則是不合理的，而應採用振幅法的控制設計原則。 -
We select fpga of type xc3s200 as hardware to design the coder and display the hardware resources inside, moreover study the method and steps of designing dsp, based on fpga, by using system generator, finally, it emphasizes the design process of multi - band excitation vocoder. we can work out the module of high pass filter and the module of low pass filter, module of divide frame, module of keynote rough estimate, module of keynote fine estimate, module of band - separated v / u judgment / verdict and module of band - separated amplitude estimate, by using simulink, ise and system generator
本文選用型號為xc3s200的fpga作為設計編碼器的核心硬體，介紹了其內部所含的硬體資源，並研究了利用systemgenerator基於fpga設計dsp的方法和步驟，最後，本文把重點放在多帶激勵語音編碼器的設計上，利用simulink ， ise和systemgenerator分別設計其中的高通低通濾波器模塊、分幀疊加模塊、基音粗估模塊、基音精細估計模塊、分帶v / u判決模塊、分帶幅度估計模塊。 -
Abstract : according to the deep analysis of the typical punching process, the loading charts and the amplitude - frequency curves of straight side cnc turret press frame are obtained. in the end the dynamic response of a typical process is calculated using modal superposition method by fem software marc and the static and dynamic stress of some nodes is compared as well
文摘:根據板料沖裁時的工作負荷圖確定了數控回轉頭壓力機的動載荷譜，並通過傅立葉展開，獲得了壓力機的幅頻譜，最後通過marc軟體採用模態疊加法計算了典型沖裁時機身的動態響應，分析了其動態特性，並對特徵點的動靜態應力進行了比較。 -
A symbol amplitude of a single - user in a multi - user system is approximated over the window of the frame and a perturbative correction value is calculated based upon a correlation or decorrelation matrix, which is determined by the delay spread of the signals
在多個使用者系統內的單一使用者的符號振幅系以該畫面的整個視窗來估算，並且系根據一個相關或解相關矩陣來估算，而該矩陣系由訊號的延遲分散來決定。 -
Firstly, three - phase static inverter under the space vector pulse width modulation ( svpwm ) is analyzed. then instantaneous control for three - phase static inverter is implemented in the synchronization frame through dq transform to get the information about amplitude and phase of output voltage
本文在對空間矢量脈寬調制（ svpwm ）方式下三相靜止變流器分析的基礎上，通過dq坐標變換提取輸出電壓幅值與相位的信息，實現在同步坐標下對三相靜止變流器的瞬時值控制。 -
Meanwhile, there is a kind of constraint, only the frequency constraint. the optimization design is computed to increase the first mode frequency. as the results, the first mode frequency is increased and the amplitude of the arm frame is cut down
選擇比值較大的結構參數為設計變量，以一階頻率為性能約束，進行了旨在提高一階固有頻率的優化設計，提高了泵車的一階固有頻率，使一階固有頻率盡可能高於油缸沖擊載荷的頻率，從而減小泵車臂架系統的振動幅度。
分享友人