friction roller 中文意思是什麼
friction roller
解釋
導纜器-
Specification for continuous mechanical handling equipment - safety requirements - unit loads : live roller conveyors with positive or friction drive
連續式機械裝卸設備規范.安全性要求.第14部分:成組貨件 -
After designing oil ditches on the surface of its arc - block, increase friction factor and make sure self - lock which solves above problem. do qualitative analysis to lower pair and one - way overrunning clutch and inner star - wheel - roller overrunning clutch by using self - made lever loader. the experiment shows : on the same condition, the deformation of new overrunning clutch ’ s surface contact with lower pair is smaller than the deformation of roller overrunning clutch ’ s line contact with higher pair and new overrunning clutch ’ s skid angle is smaller
對低副單向超越離合器的部件進行了加工製造，在超越離合器弧塊表面創新設計加工排油溝，增大摩擦系數，保證實現自鎖，解決了很多離合器工作過程中容易出現無法自鎖的問題;對低副單向超越離合器和內星輪滾柱超越離合器用自製杠桿加載器做了定性分析，實驗表明:相同條件下，新型離合器低副面接觸比滾柱離合器高副線接觸變形小、溜滑角小。 -
The bearing spot contact and the friction carries on after the analysis, has carried on the simulation to the bearing work process, from simply established sigin ball two race model to the complex distinction the roller conveyer, the single ball four roller conveyers and the circular roller conveyer single ball four roller conveyer steel wire roller conveyer ball bearing finite element models, introduced the modelling method in detail, the restraint and the load infliction method
在點接觸和摩擦分析的基礎上，對軸承的工作過程進行了模擬，按由簡單到復雜的研究步驟，分別建立起了單球雙滾道，單球四滾道和圓環形滾道單球四滾道的鋼絲滾道球軸承有限元模型，解決了建模模擬過程中實體模型的建立，約束和載荷的施加等一系列問題。 -
The contract stress on supporting roller and crawler board surface of three models of dong fang hong crawler tractor under three working conditions is gained by finte element analysis, as well as the stress distribution law and maximum stress which provide valuable referentce datum for resolving the problems of plastic deformation and friction wear between the supporting roller and crawler board
摘要對3種機型拖拉機的支重輪與履帶板之間的接觸應力分別在3種工況下進行了有限元分析，得出接觸應力分佈的規律及其最大值，為解決支重輪和履帶板的塑性變形問題及摩擦磨損行為分析提供了有價值的參考數據。 -
Overrunning clutch as output mechanism of pulse - type stepless transmission is friction roller - type mainly. because roller and output shaft contact with a higher pair, surface of output shaft appears groove mark obviously when repeated driving
脈動無級變速器的輸出機構? ?超越離合器，目前主要是摩擦滾柱式超越離合器，由於滾柱與輸出軸之間以高副接觸，往復驅動下輸出軸表面明顯出現溝痕。 -
Standard test method for measurement of web roller friction characteristics
測量卷材滾柱摩擦特性的標準試驗方法
分享友人