fuel combustion method 中文意思是什麼

fuel combustion method 解釋
燃料燃燒法
  • fuel : n. 1. 燃料，柴炭。 ★指燃料種類時為可數名詞。2. 刺激物。vt. ,vi. （〈英國〉 -ll-）（給…）加[供給]燃料，（給船等）上煤，（給…）加油。-er 使用特製混合燃料的賽車。
  • combustion : n. 1. 燃燒，發火，點火。2. （有機體內營養料的）氧化。3. 騷動。
  • method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  1. Dcn test method for the determination of ignition delay and derived cetane number of diesel fuel oils by combustion in a constant volume chamber

    用等容室燃燒法測定柴油燃料油的滯燃期和導出十六烷值
  2. Standard test method for determination of ignition delay and derived cetane number of diesel fuel oils by combustion in a constant volume chamber

    通過在定容室內燃燒測定柴油燃料油的滯燃期和導出十六烷值的標準試驗方法
  3. The second method of changing engine operating parameters means, in essence, operating fuel lean to increase combustion.

    第二種改變發動機工作參數的方法的用意，本質上是用貧燃料來增加燃燒。
  4. A new method is put forward on thermodynamics combustion model to make imitating research on egr - a software is made to calculate the amount of no from the gasoline by connecting with the practical condition in our country, starting with thermodynamics and experiment at the same time make a system research to influence by the exhaust gas returning system on the gasoline, such as exhaust gas, fuel economy, and power, finally a new thought is afforded for optimizing all the egr parameter in chapter 6

    第五章採用上述診斷和預測模型對bj492q發動機進行了模擬計算和實驗研究，並探討了點火提前角、殘余廢氣系數、燃空比、壓縮比和火花塞位置對發動機性能的影響。第六章提出了基於熱力學燃燒模型對egr進行數值模擬的方法，系統地研究了車用汽油機加裝egr系統后對排放、油耗、功率的影響，並結合排放標準。提出了egr參數的全局優化的新思路。
  5. The secondary combustion, which has better controllability, and plays the most pivotal role on the overall performance of a strutjet, so the paper detailedly studied and analyzed the mechanism of fuel ' s atomization, the mechanism of fuel ' s spray burning, vital spray burning models and the combustion ' s controllability, combined with the author ' s practical investigation in the rbcc lab, finally, the author got a most simple and feasible method to control the spraying burning of liquid kerosene - - to set up an adjusting valve in the fuel pipeline

    文中重點對燃油的霧化機理、燃油的噴霧燃燒機理、主要的燃燒模型和燃燒過程的可控性，展開了詳細地分析研究，並結合在rbcc實驗室的實際研究，獲得了對燃油噴霧燃燒進行調節的最簡單、可行的方法，即在燃油管路上設置流量調節閥。於是燃燒組織問題轉化為對該調節閥的開度如何施加適當控制的問題。
  6. The experimental investigations were first conducted on diesel spray wall - impingement mixing process with or without a bump on a flat wall and in a combustion chamber by means of plif method in the self - made constant volume combustion spray simulation set - up which can reproduce the typical working conditions and high - pressure fuel injection of modern diesel engines. the simulation computation of a cfd code about them was then carried out

    首先在自行研製的、可以模擬現代柴油機典型工作環境及高壓燃油噴射特性的定容燃燒噴霧模擬裝置上用片狀激光誘導熒光法（ plif ）對平壁上、燃燒室內不設置和設置bump的柴油噴霧撞壁混合過程進行了試驗研究，然後又用cfd多維數值分析軟體對其進行了模擬計算。
  7. Saturation vapour pressure of internal combustion engine under actual operation conditions is expressed as the multinomial by using least square method, which facilitates the calculation of rectifying coefficient of engine output and fuel consumption as well as the fabrication of computer programme for such calculations

    摘要介紹了用最小二乘法擬合方法，將內燃機現場環境狀況下飽和蒸汽壓表示為多項式形式，為計算功率和燃油消耗率校正系數，並為此而編制計算機程序提供方便。
  8. The effect of secondary fuel nozzle location, the mass flow rate of secondary fuel and outlet area of ejectorjet were studied. the main results are : the geometry structure of ejectorjet can be compatible with other rbcc operation modes by secondary combustion organization ; the distribution of secondary fuel on ejectorjet cross section is significant for secondary combustion stability. spi combustion organization method is promising

    實驗研究了二次燃料噴注位置、二次燃料噴注量、后體出口面積對引射火箭性能的影響，得到的結論為：通過燃燒組織，引射火箭模態可以和其他工作模態（亞燃超燃）共用燃燒室而不需做大的幾何變化；二次燃料在引射火箭通道截面上的分佈對于引射火箭的穩定工作有重要意義。
  9. New design method and optimization research of fuel cam of internal combustion engine

    內燃機供油凸輪設計新方法與優化研究
  10. This paper prensents the method and system providing gasoline engine with lean fuel - air, analyses the influence on the engine performance when fuel - air is thinning, and proposes the principle of controlling steady combustion on edge of unsteady combustion, which has been validated by experiments

    介紹了供給汽油機稀混合氣的方法和系統；分析了混合氣逐步變稀時對汽油機性能的影響；提出了不穩定燃燒邊緣的穩定控制理論，並為臺架實驗所證實。
  11. Through utilizing the association rules to identify the fuel heating characteristics, the auto - tuning of the air / fuel ratio in the boiler combustion control can be realized. secondly, a thermodynamic system predictive control strategy based on the working regime identification online and multiple local linear models is presented, including a new working regime decomposition and identification method and the novel online multi - model combination and controller reconfiguration method

    提出了基於工況辨識的多線性模型多變量預測控制策略，其中包括熱力系統的工況區域劃分、辨識方法（基於運行數據信息採掘） ，以及在此基礎之上的全新的多模型融合、控制器重構策略。
分享友人
分享到 Line

分享到臉書