generated noise 中文意思是什麼

generated noise 解釋
起發雜訊
  • generated : 產生的
  • noise : n 1 聲音,聲響。2 叫喊;嘈雜聲,噪音;喧鬧聲;吵鬧,騷動,騷擾。3 〈古語〉謠言,風聲。4 〈美國〉...
  1. A hydrid wind - generated noise model of normal mode and ray

    射線混合風關海洋環境噪聲模型
  2. This paper studies the mechanism generated from flow - noise in seawater pipeline, introduces controlling method of flow - noise, analyzes sound field characteristics of flow - noise in seawater pipeline system and the merits and demerits of measuring the flow - noise methods in and out of the pipeline. in our experiment, a test measuring device of seawater muffler is used in a measuring chamberlet to verify that a method of reverberation chamberlet is difficult to exactly measure the low frequency flow - noise in pipeline. at the same time the insertion lose of water muffler in the low frequency was measured by the measuring chamberlet method

    本文分析了海水管路系統內流噪聲的產生機理,介紹了流噪聲的控制方法;分析了海水管路系統中流噪聲的聲場特性以及流噪聲管內、管外測量方法的優缺點;通過海水消聲器試驗測量臺架,利用測量小室驗證了混響箱法難以準確測量海水管路系統中的低頻流噪聲;用測量小室對水消聲器在低頻段的插入損失進行了測量。
  3. Noise margin refers to the maximum noise voltage that can be added to the generated signal in a digital circuit before an undesirable change is caused in the circuit output

    噪聲極限就是指可以加在數字電路的正常信號上,而又不對正常輸出造成危害的最大噪聲。
  4. The submarine noise detected by sonar consists of two parts : propeller - generated hydro - dynamical noise, which can be greatly reduced by improving the submarine rear shape ; radiated noise from the submarine structure excited by the centrifugal forces ( moments ) of rotatory machine, which is more complicated and influenced by many factors

    聲納所探測的潛艇噪聲包括兩部分,一是螺旋槳運轉帶來的水動力噪聲,二是潛艇主機工作時產生的不平衡力和力矩引起潛艇結構振動,帶動流場振動從而輻射噪聲。通過改進潛艇尾部線型設計,已將水動力噪聲降到比較低的程度,而結構噪聲則復雜得多,與許多因素有關。
  5. According to the suh ' s theory of friction genesis and based on the change in topography with and without noise, it is assumed that the there is dynamic components of friction force in the area where uneven plowing grooves and pits or adhesive joined asperities are generated

    根據噪聲與磨痕形貌的關系,本文提出了新的摩擦噪聲形成機理:在不規則的犁溝和麻坑或粘著微凸體形成區域,摩擦力有動態成分。
  6. Analog synthesis often use low - pass filter to remove electronic audio generator generated by high - frequency noise

    模擬合成器常常使用低通濾波器來去除電子音頻發生器所產生的高頻噪聲。
  7. The complaints are mainly about noise generated when moving objects within the storage sites ; dust caused by vehicles entering and leaving the sites ; suspected storage of harmful waste on the sites ; and wastewater discharged from the sites

    投訴內容主要是存放場內搬運物品時發出的噪音,車輛出入產生的塵埃,也有懷疑場內存放危害性廢物,及從存放場中排出污水。
  8. More often than not the combustion noise refers to the noise radiated from the cylinder cap, piston, rod, crankshaft to the engine body propelled by the pressure vibration generated out of the combustion inside the cylinder

    燃燒噪聲和機械噪聲很難嚴格區分,通常將由於氣缸內燃燒所形成的壓力振動通過缸蓋、活塞-連桿-曲軸-機體向外輻射的噪聲稱之為燃燒噪聲。
  9. The noise generated from lairages can reach 100 dbs. acoustic facilities have been installed to contain the noise level

    牲口欄的噪音高達1 0 0分貝,故此,必須安裝隔音設施,以減低噪音外傳。
  10. In the train compartments, ambient temperatures and humidity will be set at appropriate levels, and a quiet environment will be created by the attenuation of noise generated by train operation

    車廂內的溫度及濕度將調校至適當的水平。列車行駛時發出的噪音也將透過紓緩措施而得以消減,從而創造出寧靜的環境。
  11. In chapter five to reconst ruct the three - dimensional object cubes, various deconvolution algorithms : nearest neighbor, inverse filtering and constrained iterative deconvolution are developed and applied to both computer generated and experimentally measured image cubes. the best results are obtained using an svd inverse fourier deconvolution algorithm with regularization for noise suppression

    第五章為了重建三維目標立方,發展了各種去卷積演算法:最近鄰、逆濾波和帶約束的迭代去卷積,並應用到計算機產生和試驗測量的圖像立方中,最好的結果是利用具有規則抑制噪聲的svd逆傅立葉變換去卷積演算法獲得的。
  12. To reduce the noise generated from delivery vehicles, a noise barrier wall 700m long and 3m high has been erected along the section of po wan road near the residential area. in addition, noise barrier walls of 2 - 4m high are erected along the slaughter house s perimeter

    為減低運肉車經過時所發出的噪音,在其中一段比較接近民居的寶運路設有約七百米長、三米高的隔音屏障,並於屠房周圍築起高兩至四米的隔音墻。
  13. If epd learns of an activity that will be held in an open - air venue and considers that the residents in the vicinity may be affected by excessive noise, it will send its staff to monitor the noise level generated by the activity. if necessary, epd will offer the organiser advice or take enforcement action under the noise control ordinance

    如環保署得悉某項活動會在露天場地舉行,並認為該項活動有可能產生過量噪音以致影響附近居民,該署便會派員監察該項活動所產生的噪音,並按需要向主辦者作出勸諭或根據《噪音管制條例》採取執法行動。
  14. Compared with dc - mhd propulsion, ac mode has no electrode and does n ' t apply electric field to fluid directly. thus it avoids the detriment and noise caused by the air bubble generated by electrolysis, and makes the ship more quietly. these characters will help to develop a more efficient ship thruster

    與直流磁流體推進相比,交流磁流體推進方式的最大特點就是沒有電極,因此沒有電極壽命問題,消除了電極表面壓降對推進器效率的影響,也沒有電機表面電化學過程產生的不良效應,如氣泡、電解質對海水的污染等。
  15. In addition, we designed the sensor to cancel out noise that might be generated by different components, from the pixel amplifier, which strengthens the signals, to the memory and switches

    我再補充一點,我們的設計使得傳感器可以補償其它部分可能產生的噪音,從放大信號的像素放大器到內存和轉換器等。
  16. The paper forms the three information measures into measure vector as the input of cmac - cerebellar model articulation controller neural network and proposes a method of edge detection based on information measures and cmac. the edge contours generated by this method is very legible. the method has a high runtime performance and improves the resistance to noise

    本文將圖像的三個信息測度作為分量組成邊緣特徵的測度向量,作為小腦模型神經元網路? cmac的輸入,提出一種基於信息測度和cmac網路的邊緣檢測方法,用該法得到的邊緣輪廓清晰,實時性好,並且抗噪能力有明顯提高:將上述邊緣檢測方法應用於無人值守變電站,提出一種瓷瓶裂紋故障監控方案。
  17. Taking the ffc ? 23a disk mill as a specimen model, the rotation noise generated from the interaction between fixed claws distributed on the outer and inner circle of the fixed claw plate and the corresponding moving claws has been separated in an experimental study by the modern analytic method of acoustic. thereby, a conclusion that the principal component of rotation noise in disk mill comes from the interaction between the fixed claws on the outer circle and the corresponding moving claws has been reached. in accordance with the above, modified noise reduction design for the structural parameters such as the number of claws on the fixed claw plate, shape of claws and the relative positions of the claws arranged on the outer circle and inner circle has been carried out

    本文以ffc ? 23a型爪式粉碎機為樣機,利用現代聲學測試分析手段對其工作時定齒盤內、外圈齒與相應動齒作用產生的旋轉噪聲進行了試驗分離研究,從而得出了爪式粉碎機旋轉噪聲的主要成分源自外圈定齒與其相互作用的動齒產生的噪聲,並以此為基礎,對定齒盤的齒數、齒形以及內、外圈齒的相對排列位置等結構參數進行了降噪改進設計,通過對比性試驗與分析,獲得了旋轉噪聲與上述結構參數間的關系,並取得了負載6 . 7db ( a )的良好降噪效果。
  18. In the first part of this paper, the theory of laser range and dds technology was introduced, the factors of influencing range precision were also analysed. at the same time, put forward in the paper, with using the fpga embedded technology, the wideband and high resolution sin modulating signals can be generated easily, then analysed the noise of the dds ; in the second part, the theory of phase measurement based on fft was analysed. in the phase range system, by using the fft operation, the resolution and sensibility of phase measurement can be enhanced ; then some circuits were designed and come true, also simulated and validated ; in last part, the improvement of the phase range system was brought forward, summarized and expected

    論文首先闡述了激光測距和調制信號源的基本原理,分析了影響測距精度的因素,指出應用dds技術可以實現寬帶、高精度的調制信號輸出,說明了引起dds輸出信號雜散的原因和解決的辦法;同時分析了應用fft運算實現信號相位提取的基本原理及設計方法,採用這種檢相技術,可以極大地提高測相精度與靈敏度;然後提出了基於fpga嵌入式系統的相位式激光測距機的整體設計,並就各部分進行了詳細的分析與設計;接著介紹了激光測距系統的外圍電路和基於quartusii集成軟體平臺的部分硬體電路的設計,並對其中的設計進行了模擬和驗證;最後總結提出了對系統今後的進一步改進和完善的思路。
  19. The system eliminates the conventional rotating driving components, the absence of mechanical propeller system will lead to a reduction in the mechanical noise generated and make the arrangement of ship more expedient

    由於磁流體推進取消了傳統的螺旋槳推進系統中的螺旋槳、傳動軸、減速齒輪等轉動裝置,因此,它具有噪音小、布局靈活等優點。
  20. 3. we put forward a combine algorithm for predicting the aerodynamically generated noise using different methods mentioned above, and developed a computer code named " nospre " to predict acoustic noise generated by rotors 4

    Nospre集成了三種噪聲預測方法,可採用固定或旋轉的聲源面來預測跨音速旋翼懸停和前飛時的氣動噪聲。
分享友人