generated phase control 中文意思是什麼
generated phase control
解釋
綜合相位控制-
The dissertation is organized as follow : first, the characteristics of srm and its control system ' s development are introduced. previously major methods used to implement non - position sensor detection and the significance of making search for this direction is generated. and the configuration and fundamental operating principle of srm are analyzed ; some study of linear model and nonlinear model with phase coil as fundamental parameter are presented and sr ' s linear model and nonlinear model are set up
本文就以上兩個問題進行了深入研究，首先介紹了sr電機及其控制系統的發展歷程，研究無位置傳感器srd的意義和總結已有的無位置傳感器檢測方法，並且通過分析sr電機的結構和運行原理，研究sr電機繞組的線性電感模型和非線性電感模型，建立了電機的線性和非線性數學模型，重點研究sr電機的非線性模型，為sr電機運行與控制特性的研究和模擬研究奠定了理論基礎。 -
Due to the complexity of the structure and control of cycloconverter - type three - phase hf link inverter for soft - switching based on phase - shift - controlled full - bridge mode, a simple and optimized vvvf control strategy is proposed. this control strategy includes : produced pwm by space voltage vector ( svm ) and equivalent carrier frequency fe = 1 / te are introduced into the pdm control of the cycloconverter ; softened equivalent pwm wave is generated at the notches of hf voltage pulses ; the harmonious control between regulating pulse width by phase - shifted angle and regulating voltage of equivalent pwm is to minimize the harmonics content of output voltage of the inverter
西安理工大學博士學位論文針對這種前級移相全橋軟開關周波變流型三相高頻鏈逆變器結構和控制的復雜性，提出了一種實現簡單而整體優化的vvvf控制策略:將空間電壓矢量產生p姍的方法svm和等效載波頻率fe = 1 / te引入到周波變流器的pdm控制;按高頻電壓脈沖前後沿軟化等效p翎波;用移相調節高頻脈沖寬度和等效p姍調壓協調控制逆變器輸出電壓，在滿足輸出電壓條件下使諧波最小。 -
The proposed driving circuit includes a low - pass filter circuit 、 feedback circuit 、 signal generated circuit 、 phase shifted circuit and power inverter circuit. a ti cooperation ' s dsp ( tms320lf2407a ) is chosen for the drive and control system based on the characteristics of usm, the interface circuit 、 each function ’ s flow chart and algorithm program are designed
根據usm的特點，選取一款專用於電機控制的dsp晶元tms320lf2407a ，設計了硬體介面電路、各功能部分的流程圖及控制演算法程序，以ccs為編譯環境，進行電機整個控制系統的軟體編寫與調試。 -
In the design of real - time control system, the paper takes three - phase full - bridge mosfet inverter as the real - time control main circuit, and adopts a control scheme with 120 ? switching mode combined with half - bridge pulse width modulation ( pwm ), which would avoid straightthrough short of a certain bridge. phase current is detected by single current sensor ; three - phase position signals generated by position sensors could not only supply commutation information for inverter, but also be used for speed detecting based on signals " period measurement, which makes the speed sensor unnecessary. the whole control system adopts speed and current dual closed - loop control strategy in order to construct a high performance rare - earth permanent magnetic brushless dc motor ( repm bldcm ) full - digital real - time control system
在實時控制系統的設計中，本文以三相全橋mosfet逆變電路作為實時控制主電路，採用120導通方式結合半橋pwm調制的控制方案，從而有效地避免了橋臂的直通短路；本文用單電流傳感器實現對相電流的檢測，來自位置傳感器的三相位置信號不僅為逆變電路提供換相信息，而且也用於基於信號周期測量的轉速檢測，這樣就省去了速度傳感器；系統採用的是速度、電流雙閉環控制策略，力求構建高性能的稀土永磁無刷直流電動機全數字實時控制系統。 -
Generated phase control
綜合相位控制
分享友人