generation rate method 中文意思是什麼

generation rate method 解釋
發生率法
  • generation : n. 1. 代〈約30年〉，世代，時代；同時代的人。2. 一代[一世]。3. 生殖，生育；發生，產生。4. 【數學】（面、體、線的）形成。5. 完善化階段，完善化方案，完善化的模型；發展階段。
  • rate : n 1 比率，率；速度，進度；程度；（鐘的快慢）差率。2 價格；行市，行情；估價，評價；費，費用，運費...
  • method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  1. According to the project of adaptive multi - rate speech coding ( amr ) being put forward by the third generation group of the mobile communication, this paper takes the principle of the speech arithmetic as the base, studies the technologies including the source controlled rate, voice activity detector, comfort noise and the error concealment unit in amr, discusses its the characteristic of adaptation and analyses its performances particularly. amr c codes are researched carefully through the modules being divided into and debugged under the tms320c54x provided by the ti corporation, and optimized in selecting the method of c code embedded assembler codes and simplified in the search codebook combining with the theory of speech coding, which are based on the realization about theory and practice of the optimization of amr speech coding

    從自適應多碼率語音編碼演算法的c代碼出發，對它進行模塊劃分後作了系統分析，將其在vc下調試通過，進一步在ti公司提供的tms320c54x環境中進行調試，結合語音編碼理論，對演算法進行優化，採用了在c代碼中嵌入匯編和簡化自適應碼本和固定碼本搜索的方法，部分地提高了c代碼效率，為實現自適應多碼率語音編碼的優化奠定了理論和實踐基礎。
  2. Numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation. it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source. the flame area which has developed from the fire source is an area of chemical reaction caused by combustion. even if grids in the vicinity of the fire source are made fine, it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface. therefore, we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results. it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall. the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume

    運用cfd進行數字模擬，以了解縱向通風隧道內熱煙氣流的特性.通過模擬發現對火源進行模擬非常重要，熱煙氣流特性受火源位置的影響很大，並且對火源模擬方法很敏感.火源生成的火焰區是燃燒引起的化學反應區域.即使火源附近的木垛排列完好，也很難在考慮這些化學反應條件下模擬熱生成區域.建議考慮縱向通風隧道內火焰形狀並對它進行數字模擬.模擬結果與試驗結果非常吻合.試驗證明，在縱向通風隧道內，熱煙氣流從靠近墻體火源處順風向隧道中心蔓延.數字模擬結果發現，火災羽流造成的螺旋上升空氣會在墻體和羽流之間形成一個渦流區
  3. Abstract : numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation. it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source. the flame area which has developed from the fire source is an area of chemical reaction caused by combustion. even if grids in the vicinity of the fire source are made fine, it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface. therefore, we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results. it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall. the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume

    文摘:運用cfd進行數字模擬，以了解縱向通風隧道內熱煙氣流的特性.通過模擬發現對火源進行模擬非常重要，熱煙氣流特性受火源位置的影響很大，並且對火源模擬方法很敏感.火源生成的火焰區是燃燒引起的化學反應區域.即使火源附近的木垛排列完好，也很難在考慮這些化學反應條件下模擬熱生成區域.建議考慮縱向通風隧道內火焰形狀並對它進行數字模擬.模擬結果與試驗結果非常吻合.試驗證明，在縱向通風隧道內，熱煙氣流從靠近墻體火源處順風向隧道中心蔓延.數字模擬結果發現，火災羽流造成的螺旋上升空氣會在墻體和羽流之間形成一個渦流區
  4. Distribute the pertinent information of cloth according to authoritative ministry, enterprise bond interest already was made clear should impose income tax, in order to show the distinction that with national debt breed invests, and in principle is told, the method of levy taxes of dividend distribution income that its impose method to should get with investor is same, collect by the tax rate of 20 % namely, do not set case piece dot, when carrying out, by the clique interest firm generation is buckled, but according to handing in place management greatly to appear on the market the concerned department of enterprise bond says, appear on the market at present breed is very few, trade not active also, to its the executive job of accrual levy has not begun, the difference that goes up in yield level about enterprise bond and national debt so, answer to do not have immediate impact with pay taxes

    根據權威部分發布的相關信息，企業債券利息已明確是要徵收所得稅的，以示與國債品種投資的區別，且原則上講，其徵收辦法應同投資者得到的分紅派息所得征稅方法一樣，即按20 %的稅率徵收，不設起片點，執行時由派息公司代扣，但據深交所治理上市企業債券的有關部門稱，目前的上市品種很少，交易也不活躍，對其利息征稅的執行工作還未開始，所以有關企業債券與國債在收益率水平上的差別，應與納稅不納稅沒有直接關系
  5. The finite element method ( fe '. i ) is adopted to analyze the effects of the numbers of coil turns, current intensity and current frequency upon the rate of joule heat generation in details. the thermo - radiation analytical countermeasures of various types are adopted to carry out the numerical analysis of the effects of the crucible with different shapes and sizes and the blind holes with different depths opened in the tops of crucibles as well as coil positions upon the thermal field distribution whereby solving the main problem of field the thermo - field design of the induction - heating sic crystal growth system. a new combination idea of the thermo - field design obtained by means of the united design of the thermo - insulator and blind holes has been presented

    採用有限元分析方法對線圈匝數、電流強度、電流頻率等對焦耳熱產生速率的影響進行了詳細的分析討論；採用不同的熱輻射分析策略，對不同坩堝形狀、坩堝頂部開設不同深度的盲孔以及線圈的位置等對熱場分佈的影響進行了數值分析，解決了感應加熱碳化硅晶體生長系統熱場設計的主要問題，提出了通過絕熱層與盲孔的聯合設計獲得所需熱場設計的思路，給出了根據軸向溫度梯度的波動對線圈位置實行動態調節以控制熱場的理論依據。
  6. A method of propellant charge techniqueto control the gas generation rate

    控制發射裝藥燃氣生成規律的一種方法
  7. This method need less unknowns, less computer memory requirement and better error convergence rate compared with low - order mom, and maintain the virtue of high accuracy. a method for efficient generation of mom matrices based on equivalent dipole is also discussed. we combine these two methods

    並在構造特徵基函數的過程中，將快速形成阻抗矩陣的等效偶極矩法運用於其中，使得兩種方法第一次有效的結合，這樣，我們在用矩量法計算散射問題時，可以節省時間，提高效率。
  8. Abstract : the saturation behavior of stress current is studied. the three types of precursor sites for trap generation are also introduced by fitting method based on first order rate equation. a further investigation by statistics experiments shows that there are definite relationships among time constant of trap generation, the time - to - breakdown, and stress voltage. it also means that the time constant of trap generation can be used to predict oxide lifetime. this method is faster for tddb study compared with usual breakdown experiments

    文摘:基於一階速率方程，討論了恆定電壓應力下應力電流的飽和行為.通過對應力電流的擬合，發現存在三類缺陷產生的前身.更進一步的統計實驗顯示，在缺陷產生時間常數、擊穿時間以及應力電壓之間存在著明確的關系.這意味著缺陷產生時間常數能夠被用於有效預測氧化層的壽命.與常規的氧化層擊穿實驗相比，基於缺陷產生時間常數的預測更快、更有效
分享友人
分享到 Line

分享到臉書