heat current 中文意思是什麼

heat current 解釋
熱電流
  • heat : n 1 熱；熱力；熱度；熱量。2 體溫；發燒。3 （氣候的）高溫，暑氣。4 【冶金】熔煉的爐次；裝爐量；一...
  • current : adj. 1. 通用的，流行的。2. 現在的，現時的，當時的。3. 流暢的；草寫的。n. 1. 水流；氣流；電流。2. 思潮，潮流；趨勢，傾向。3. 進行，過程。
  1. The ground always releases heat, making turbulent air current

    地面經常釋放熱量，造成有湍流的空氣流動。
  2. The silicon plates are formed reverse four wimble array in koh solution by wet - etching technology. then the electrochemical etching experiments are done in three poles electrobath. and some technology questions such as heat oxygenation, light etching, wet etching and electrochemical etching have been analyzed. at the same time sample appearances are analyzed by scanning electron microscope. according to current burst model theory, the electrochemical deep holes etching mechanism are analyzed

    在三極電解槽中，進行了電化學深刻蝕的探索性實驗。對氧化、光刻、濕法刻蝕和電化學刻蝕中的工藝問題進行了初步的理論和實驗研究，同時，採用sem對實驗樣品進行了形貌分析，並採用電流突破模型對電化學深孔刻蝕機理進行了理論分析。
  3. Induction heated oil tempered spring wire is a kind of new technical material which has been developed since 1980s. it can be heated by means of eddy induced into itself through electromagnetic coil and this method is mainly used in surface quenching. with correct designing and reasonable current frequency, induction coil and heat treatment process selected, as well as plc controlling applied, the wire can be uniform heated along cross - sectional and longitudinal direction and can be quenched and tempered continuously

    應加熱油淬火-回火彈簧鋼絲，是二十世紀八十年代發展起來的新技術材料，在國外稱為itw induction heat oil tempered spring wire 。是通過線圈電磁感應鋼絲本身產生的渦流進行加熱，通常主要用於表面淬火。經正確設計，選擇電流頻率，合理的感應線圈及熱處理工藝，並實施plc控制，可使鋼絲整個截面及長度上得到均勻加熱，進行連續整體淬火和回火。
  4. To calculate this boundary parameter, mohorovicic discontinuity palaeo - heat flow value during basin evolution process is identified through geotectonic background analogy method based on " peeling " method model, and the basin basement palaeo - heat flow is calculated through inversion from today to antiquity with current tectonic structure as constraint condition for palaeo - crustal architecture analogy

    為了求取這個邊界參數，以「剝層」法模型為基礎，通過大地構造背景類比法確定盆地演化過程中莫霍面古熱流值，以現今地殼結構為約束條件類比古地殼結構，從今至古反演求取了盆地基底的古熱流。
  5. Another maximum of heat loss existing in japan sea is tsushima current area with - 270wm - 2 in december. the seasonal variations of heat flux are similar in japan and east china sea

    在日本海區，對馬暖流沿日本群島西海岸在冬季12月也有最大損失值- 270wm ~ （ - 2 ） 。
  6. Pulse electric current heat treatment ( pecht ) developed by sodick, ltd., of japan, is a recently developed material processing method which consists of spark plasma sintering and welding, plasma activated sintering and welding, big pulse electric current ( bpec ) diffusion welding etc. the following are basic merits of pecht : rapid heating and cooling ; short sintering or welding time ; lowering sintering or welding temperature

    脈沖電流熱加工（ pulseelectriccurrentheattreatment ，比如燒結，焊接等）是九十年代發展起來的一種材料快速制備新技術，它包括放電等離子燒結與焊接、等離子活化燒結與焊接、脈沖大電流擴散焊接等。它具有升溫、降溫速度快、能在較低的溫度下燒結或焊接以及時間短的特點。
  7. The technical measures for deep reducing coal moisture were urgent needed due to china devoting major effort to implement the new and high technologies used for coal liquefaction and preparation high purity coal. through the analyses of current situation of technical level for coal drying and dewatering, the paper suggests to take overheat steam produced from power plant as a heat source, use the disk dryer to deeply reduce coal moisture with simple working process and low production cost

    本文針對我國人力實施煤炭液化和超純煤制備等高新技術，迫切需要將煤中水分深度脫除的技術手段，通過對我國煤炭乾燥脫水技術現狀與水平的分析，提出以電廠過熱蒸汽為熱源，利用盤式乾燥機，以簡捷的乾燥工藝、低的乾燥成本，深度脫除煤中所含水分的技術方案。
  8. Expection of the current heat - electricity cogeneration in heilongjiang

    黑龍江省近期熱電聯產展望
  9. Furthermore, both current in - situ conductivity test data interpretation methods and gshp design methods are based on models that only consider heat conduction. therefore, the groundwater flow may impact the results of in - situ thermal property of soil, and then the ghe size, and make the short - time economics of gshp comparatively unattractive consequently

    此外，由於現場對巖土熱物參數的測試及分析也都僅考慮了熱傳導的影響，這勢必影響現場測試結果的精度，最終又會引起換熱器大小的變化，使土壤源熱泵的經濟性受到挑戰。
  10. However, both of them have disadvantages. mo tip feas is fabricated by evaporating tip cathodes on base, so it has bad coherence with the base. on the other hand, the characteristics of silicon result in the bad heat stability, bad emission reliability, and low current density

    然而，這兩種陰極存在各自的缺點，如鉬尖錐是蒸鍍在基底上的，所以與基底的附著力不強;而硅的特性又決定了其熱穩定性差，發射的可靠性低，發射電流有限。
  11. Tests the operation status of an air - cooled heat pump air conditioner under defrosting conditions, and records the evaporation temperature and exhaust fan current at different voltages

    摘要實驗測定了一臺空氣源熱泵空調機組除霜工況下的運行狀況，記錄了蒸發溫度和不同電壓下的排風機電流。
  12. And the results of calculation and numerical simulation indicate, without increasing the intrinsic collector - junction area of power devices, collector - combed structure helps to raise the intrinsic heat - dissipating area and base ' s perimeter, improve heat - dissipating method of each cell of the chip, enhance the distribution uniformity of junction temperature and current of each cell of the chip, reduce the thermal resistance and raise the dissipation power pd and output power p0, fairly well relax the contradiction among frequency, out - put power and dissipation power of the devices, and further improve the devices " property against second breakdown

    而計算分析和二維數值模擬分析結果表明：梳狀集電結（基區）結構在不增加器件本徵集電結面積的條件下，增大了器件的本徵散熱面積和基區周長，改進了每個子器件單元內的散熱方式，提高了單元內結溫和電流分佈的均勻性，降低了器件的熱阻，增大了器件的耗散功率和輸出功率，較好地緩解了目前傳統結構中頻率與功率、功耗的矛盾，並有利於改善器件抗二次擊穿的性能。
  13. Multiple protections : delayed start - up for avoiding current shock, phase / over - current / over - heat / water protections

    具備完善的保護特性：防電流沖擊緩起動、缺相保護過流過熱保護、缺水保護。
  14. This is considerably better than the current statutory requirement of 30 watts per square metre introduced to limit the building solar and temperature heat gain

    訂立這個法定標準，是要限制建築物的日照加熱效應。
  15. Theoretical analysis indicates, the two technology helps reduce the concentration of current, lower the peak junction - temperature, and effectively avoid the appearance of devices " breakdown caused by heat and current

    理論分析表明：上述兩種技術，有利於減小電流集中現象，降低器件峰值結溫，避免熱擊穿和二次擊穿的發生。
  16. The calculations axe based on the equation of current motion with temperature and field - dependent critical current density, and the heat dissipation produced by flux motion in the normal state region and the superconducting state region

    此計算基於電流運動方程，考慮到電流密度是溫度和磁場的函數，考慮到在正常區和超導區由磁通運動產生的熱耗散。
  17. This paper analyses current situation of chp and situation of development, use evaluating energy utilization - - based on electricity comparing with state calculated method - - based on heat, calculates the operating data of baotou second thermal power plant heat supply system ， extends the study of heat supply performance to heat net and heat consumer, synthetically analyses heat load characteristic 、 pipe net property and heat supply distance witch effect heat supply cost. the paper studies the thermal power performance of thermal power plant total energy system, discuss heat supply cost which effect the development of chp

    本文對熱電聯產的現狀及發展情況進行分析，採用能源利用系統性能評價指標體系及其評價指標? ?電量法與國家目前採用的法定計量方法? ?熱量法進行比較，通過對內蒙古包頭第二熱電廠供熱熱源系統及供熱熱網系統的熱電聯產運行數據進行分析計算，將供熱過程的熱力性能研究延伸至熱網和熱用戶，分析用戶終端的能源利用情況，針對內蒙古地區主力機組和地區條件，綜合分析了熱負荷特性、管網性能及供熱距離對供熱成本的影響，研究了熱電廠總能系統的熱力性能，對困擾熱電聯產的供熱成本進行了探討。
  18. Genetic analysis shows that it may be caused by the difference of the response of each area to winter monsoon ' s abnormal, the kuroshio and our offshore is influenced mostly by heat flux between the sea and atmosphere, but in the other areas, the abnormal current incited by abnormal wind has decisive effect on the change of the sea temperature, at the same time, air pressure also has some impact on the sea temperature

    其區域性形成的原因主要可能是因為各海區對冬季風異常的響應方式不同，強冬季風使得黑潮與我國近海海洋過多散熱，海溫降低；在西北太平洋暖池北部，強冬季風引起西風異常，從而引發異常氣旋性環流，海水輻合下沉加熱其表層以下海水，同時異常環流使得更多東側異常暖水向西加熱其表層水；在黑潮與親潮交匯處的升溫也主要是由於強冬季風導致的流場異常，海水輻合下沉升溫。
  19. The product facilitates extensive safety functions including : self diagnostic circuit ( temperature sensor malfunction, heater disconnection, automatic overheat preventive device, ssr short circuit ), over heat preventive device, over current electric leakage breaker, and key lock function

    故障自我診斷（溫度傳感器異常、加熱器斷線、自動溫度過升防止功能、 ssr短路） ，過升防止器、過電流漏電保安開關、鍵盤鎖定等安全功能充實。
  20. Since the company began to resrerch and make radiators in 80 ' s last century, domestically advanced production lines have been adopted in the production. we sim at 100 % conformity of heat impedance performance curve with the testing standards stipulated in st2564 - 85 standard book of " profiled material raditors " which is promulgated by ministry of electronic industry of people republec of china. the radiators are matching heat - radiating components for power semiconductors, generally can be applied to fields of large and small power appliances, hi heat current density utensils, whole - set apparatus, electuonics and electrical devices, etc

    本公司自八十年代初研製生產散熱器系列產品以來，採用國內最先進的生產流水線，工藝精湛，其熱阻特性曲線均按中華人民共和國電子工業部標準st2564 - 85 《型材散熱器》規定的檢測方法，百分之百達到設計要求，是功率半導體器件的配套散熱元件，運用於多種大、小功率電器熱流高密度、整機設備、電子，電器等領域。
分享友人
分享到 Line

分享到臉書