heat removal 中文意思是什麼

heat removal 解釋
排除熱量
  • heat : n 1 熱；熱力；熱度；熱量。2 體溫；發燒。3 （氣候的）高溫，暑氣。4 【冶金】熔煉的爐次；裝爐量；一...
  • removal : n. 1. 移動，遷移；撤退；折卸。2. 排除；除去；切除；殺害；【林業】皆伐，終伐。3. 撤職；調職。
  1. Ventilation is concerned with the supply of fresh air, the removal of contaminants and heat.

    通風涉及的是新鮮空氣的供應，污染物和熱量的排除。
  2. Abstract : through analysis on the character and use of geothermal water, expatiate the mechanism of iron removal from geothermal water, adopt the iron removal and manganese removal technology of aeration full oxygen and savageness manganese grit osculate oxidation, and control the intention and time of inverse flush, these make the treated geothermal water reach the standard of iron and manganese chroma, moreover, it won ' t increase bad component or decrease good component it is a perfect iron removal and manganese removal technology that can save installation investment, need low operating cost and reduce the heat losing

    文摘:通過對地熱水的特點及其用途的分析，闡述了地熱水除鐵除錳機理，採用曝氣充氧、天然錳砂接觸氧化的除鐵除錳工藝，並適當控制反沖洗強度和時間，使處理后地熱水含鐵、錳濃度達到標準，且不增加有害成分或減少有益成分.設備投資省、運行成本低，熱損失小，是一種理想的地熱水除鐵工藝
  3. Finally, by studying the heat transfer coefficient and the mechanism of mass transfer through the membrane pores, a complete mathematical model was proposed for the removal of voc from dilute aqueous solutions by vmd

    根據對傳熱系數和膜孔內傳質機理的研究，最後得到了真空膜蒸餾脫除水溶液中voc全過程的數學模型。
  4. Abstract : there are offered many ways how to improve work of a spark plug. but one of the m ost important problems has not been solved yet. this is a thermal mode operation of a spark plug. the ideal spark plug should be instantly heated at the moment of occurrence of a spark and instantly cooled down in expectation of the foll owing electrical pulse. thus it balances between preservation of heat for self ? c leaning from scale and its removal in avoidance self ? ignition. in this article a uthor managed for this time to offer a spark plug with capability “ self ? regula tion ” of heat flux removed from a zone of ignition. essence of the offer is a t ip ， which is transparent for heat flux. it is produced from single crystal of sap phire

    文摘:在如何提高火花塞的工作質量方面有多種方法，但是其中最重要的一個問題還沒有得到解決，那就是火花塞工作的熱學模型問題.理想的火花塞應該能在點火的瞬間被立刻加熱，並且在接下來的電脈沖過程中迅速冷卻，由此在熱量的存儲與散發之間取得平衡，以避免自點火.本文力圖展示一種具有自動調節源於點火區域熱流能力的火花塞，其技術的關鍵是頂部絕緣體材料，它是由藍寶石單晶製作，而非傳統的氧化鋁陶瓷
  5. Traditional hydronic sizing methods can be used for selecting pumps, expansion tanks, heat exchangers, and air removal devices, as long as the heat transfer liquid ' s thermal properties are considered

    傳統的液體循環加熱體量法在泵、蒸發器、熱交換器和空氣移動裝置的選擇中可以應用，在考慮載熱流體的熱血特性的情況下。
  6. Standard test method for measuring the heat removal rate of personal cooling systems using a sweating heated manikin

    用發汗熱人體模特測量人體冷卻系統散熱率的標準試驗方法
  7. Emcut 103 compounded well - balanced extreme pressure additives system to achieve rapid heat dissipation and chip removal performance, but not cause any staining problem

    Emcut 103所含平衡良好的極壓添加劑系統，能達到快速散熱與磨屑清除的性能，但卻不會造成任何油斑的問題。
  8. - acetolactate decarboxylase are widely found among bacterial strains but not in other groups of organisms. the enzyme has been demonstrated to be effective for removal of acetolactate and widely used in beer product. in this paper, - acetolactate decarboxylase from bacillus subtilis was purifed to homogeneity from cell extract by ammonium sulfate - fractionation, heat treatment, deae - sepharose fast flow column chromatography

    本文對來源於枯草芽孢桿菌（ bacillussubtilis ） 3226 - 5的-乙酰乳酸脫羧酶經硫酸銨分級沉澱、熱處理、 deae - sepharosefastflow離子交換柱層析等分離純化步驟，得到sds - paeg電泳純，通過n末端氨基酸序列分析驗證酶蛋白的純度。
  9. An experimental setting of thermoelectric module which can simulate alterable work conditions in the cold and hot sides at the same time was designed. and the experiment research on the effect of the heat removal in the cold and hot sides was done

    設計並建立了一臺可同時模擬冷、熱端變工況工作的熱電製冷實驗裝置，對冷、熱端傳熱狀況對製冷器性能的影響進行了實驗研究。
  10. Using lithium bromide aqueous solution as liquid desiccant, adopting the total heat transfer rate and enthalpy efficiency to describe the combined heat and mass transfer performance and the moisture removal rate and regenerative efficiency to describe the mass transfer performance of the regenerator, explores the effect of air and desiccant inlet parameters on the regenerator performance by experiment, and compares the result obtained with those of other counter - flow configurations previously published

    以溴化鋰溶液為除濕劑，採用總換熱量、全熱效率描述再生器的熱質交換總體效果，採用再生量、再生效率描述傳質效果，實驗測試了溶液和空氣的進口參數對再生器性能的影響，並與逆流再生器的實驗結果進行了比較。
  11. And the influence of the heat removal in the cold and hot sides and electric current and some other factors which affect the cooling performance of thermoelectric refrigerator was also discussed by numerical calculation. furthermore, the influence of thomson effect on the performance of thermoelectric refrigerator in different refrigerating capacity and electric current was analyzed. and the work parameter of thermoelectric refrigerator was pointed out under the conditions that whether or not considering the influence of thomson effect

    通過數值計算詳細討論了穩態條件下冷、熱端傳熱系數及電流等因素對熱電製冷器製冷性能的影響，分析了在不同製冷量和不同工作電流下湯姆遜效應對溫度場的影響，指出了設計中是否要考慮湯姆遜效應的工況條件。
  12. By utilizing mechanical vibration, the problem of protecting heat - pipe exchanger against smoke dust adhesion is solved. an inertia vibration is successfully used as an exciting source in dust removal process

    摘要本文應用振動的方法，解決了長期來防礙熱管換熱器的含塵煙氣餘熱中應用的難題。
  13. Roadbed construction on permafrost will give substantial disturb for the heat and mass transfer balance between the ground surface and atmosphere, usually, roadbed construction increases the amount of absorbed heat via vegetation removal, solar radiation and increased role of water activities in the adjoining area, then cause the local degradation of the permafrost underneath, as a result may lead to damage of the roadbed

    多年凍土區道路的修築，改變了原來天然地表與外界的熱交換關系，通常由於地面植被的破壞、太陽輻射和水的影響，導致進入地層中的熱量增加，引起多年凍土區凍土的融化，從而導致路基面破壞。
  14. Nuclear design should make boiling water reactor power plant meet the safety criteria such as criteria for safety shutdown, after - heat removal and radioactive inclusive

    核設計應使沸水堆核電站滿足安全停堆準則、余熱導出準則、放射性包容準則等安全準則。
  15. Content of the project : set up a new heat & ache removal raw material medicine production line. sales revenue is estimated to increase by rmb200 million yuan, tax turnover, 35 rmbmillion yuan

    項目內容：新建年產2500噸解熱鎮痛原料藥生產線，預計新增銷售收入2億元，利稅3500萬元。
  16. Marketing analysis : heat & ache removal raw material medicine has large market volume, and the technology is high - tech and application technology ; therefore, it can develop domestic and international market on the one hand, and on the other hand, alleviate the contradiction between supply and demand of its own raw material medicine

    市場分析：採用先進適用技術，開發生產技術含量高、市場容量大的解熱鎮痛原料藥，一方面開拓國內外市場，一方面緩解本公司原料藥的供需矛盾。
  17. The spent fuels would be stored and cooled in the " spent fuel pool " inside the fuel building for about 10 years to allow for the radioactive decay of its nuclides and removal of the residual heat

    「乏燃料」會放在燃料廠房內水池中貯存約十年，進行冷卻排除餘熱，以及待其放射性因衰變而隨時間減退後，再運往西北偏遠地區進行
  18. The spent fuels would be stored and cooled in the " spent fuel pool " inside the fuel building for about 10 years to allow for the radioactive decay of its nuclides and removal of the residual heat. the spent fuels would then be transported to remote site in the northwest region for either

    「乏燃料」會放在燃料廠房內水池中貯存約十年，進行冷卻排除餘熱，以及待其放射性因衰變而隨時間減退後，再運往西北偏遠地區進行
分享友人
分享到 Line

分享到臉書