heat test 中文意思是什麼

heat test 解釋
加熱試驗
  • heat : n 1 熱;熱力;熱度;熱量。2 體溫;發燒。3 (氣候的)高溫,暑氣。4 【冶金】熔煉的爐次;裝爐量;一...
  • test : n 1 檢驗,檢查;考查;測驗;考試;考驗。2 檢驗用品;試金石;【化學】試藥;(判斷的)標準。3 【化...
  1. In trpsin tolerance assay. this virus could resist to 1 % trpsis at 37 in an hour. in acid tolerance assay, this virus was resistant to ph3. 0 and ph5. 0 at 37 in 2 hours, and the average infection litre of the virus decreased little. in heat assay, at 50, the virus was processed from 5 minutes to 150 minutes and at each condition the viral virulence reduced to some certain degree. among these conditions, when at 50 in 30 minutes. the average infection litre of this virus decreased over 2 tilre. and when al 50 in an hour, cpe of ihis virus disappeared. when time was set for an hour. but with processed in different temperature as 50 60 70, 80, the virus losl the multiplication capacity complelely. in biological assay, we selected different cell lines to cultivate this virus by laking advantage of possesional cells at that time in our laboratory. then we found that fcwf cell line was the most sensitive to dxmv and mdck was the second. with f81 cell line, after passaged for 12 times continuously with low concentration of fcs. the virus could produce cpe. however, with vero cell line. the virus could not procuce any cpe after many passages. the hemagglutination and lumadsorption reaction test proved that this virus had no any reaction to erythrocyte of pig, fowl and cavy. by neutrolizaion assay, dxmv could be identified as a kind of ccv

    理化學研究表明,該病毒為rna病毒,對氯仿、乙醚敏感;胰酶試驗中,經37 、 1小時處理的病毒,仍然能夠在貓源細胞fcwf細胞上生長,並且毒力基本保持不變;耐酸性試驗中,病毒分別在ph5 . 0和ph3 . 0經37作用2小時,毒力僅下降一個滴度;耐熱性試驗中,該病毒在恆定溫度50 ,設定不同時間,從5分鐘到150分鐘,毒力均有不同程度下降,其中, 50作用30分鐘,病毒平均滴度下降2個單位; 50 , 60分鐘, cpe消失;恆定時間1小時,設定不同溫度( 50 - 60 - 70 - 80 ) ,病毒在細胞上完全喪失增殖能力, cpe消失。生物學試驗,利用實驗室現有條件,選擇不同的細胞系對該病毒進行培養,發現該病毒對貓源細胞fcwf最敏感; mdck細胞次之; f81細胞經多次傳代,亦可出現cpe ;而vero細胞則不敏感。血凝試驗表明,該病毒對豬、雞、人及豚鼠的紅細胞均無血凝性。
  2. Standard test method for measuring heat flux using a copper - constantan circular foil, heat - flux gage

    用康銅環形箔熱流計測定熱流的標準試驗方法
  3. Standard test method for heat resistance of hot - applied sealants under dead load shear

    最大承載剪切下熱應用密封劑耐熱性的標準試驗方法
  4. Clothing and equipment for protection against heat - test method for convective heat resistance using a hot air circulating oven

    防熱服及設備.用熱空氣循環爐測試耐對流熱的試驗方法
  5. Resistance to soldering heat - test procedure for electrical connectors

    耐焊接熱.電連接器的測試程序
  6. Resistance to soldering heat test procedure for wire and electrical components

    電線和電器元件耐焊接熱試驗程序
  7. By using the academic calculating formulas of each factors, we can analyze and calculate the no. 23 # residence building of abstracted coefficient that is measured by ledge in baihua small region. finding the abrration between practicable heat test and theory calculation, sequentially the communal heating load calculation is abstracted from the total heating load calculation of the building

    應用各個系數的理論計算公式,對百花小區23 #住宅樓公共耗熱量的各個提取系數進行分析計算。找出實際測試與理論計算兩者之間的誤差,提取出公共耗熱量。
  8. Heat test source lamps for carrying out heating tests on luminaires

    燈具加熱試驗用熱試驗源燈
  9. H. t. s heat test source h. t. s. lamps for carrying out heating tests on luminaires

    照明設備進行熱試驗用熱試驗源
  10. Heat test source h. t. s. lamps for carrying out heating tests on luminaires

    光源耐熱試驗用熱源試驗燈
  11. Tp - 56b, resistance to soldering heat test procedure for electrical connectors and sockets

    電氣連接器和插座的tp - 56b耐焊接性加熱試驗過程
  12. Environmental testing - part 2 : tests. test z amd : combined sequential cold, low air pressure, and damp heat test

    環境試驗.第2部分:試驗.試驗z amd :低溫低氣壓和濕熱組合順序試驗
  13. Acid heat test

    酸熱試驗
  14. Dry heat test

    乾熱試驗
  15. Standard practice for evaluation of aging resistance of prestressed prepainted metal in a dry heat test

    乾熱試驗中預應力預塗金屬抗老化性評定的標準實施規程
  16. Specification for damp heat test chambers

    濕熱試驗箱技術條件
  17. Cyclic damp heat test

    循環濕熱試驗
  18. Steady damp heat test

    固定濕熱試驗
  19. Alternate humid heat test

    交變溫熱試驗
  20. Abstract : the effect of the humid and hot environment on the quality life time of electronic product is discussed with emphases on the hot topic about humid heat test ? ? ? the failure mechanism of ion migration and the test method

    摘要:闡述了濕熱環境對電子產品質量壽命的影響,並重點介紹了目前濕熱試驗的熱門話題:離子遷移失效的機理和試驗方法。
分享友人