heat-transfer by convection 中文意思是什麼

heat-transfer by convection 解釋
對流傳熱
  • heat : n 1 熱；熱力；熱度；熱量。2 體溫；發燒。3 （氣候的）高溫，暑氣。4 【冶金】熔煉的爐次；裝爐量；一...
  • transfer : n 1 移轉，轉送；調職；調任[轉學]證書；變換。2 （財產；權利等的）轉讓，讓與（證書），移轉，授受；...
  • by : adv 1 在側，在旁，在附近。2 （擱）在一邊，（放）到旁邊，（存）在一旁；收著。3 （由旁邊）經過，過...
  • convection : n. 1. 傳送。2. 【物理學】運流，環流；【氣象學】對流，上升氣流。
  1. Combined heat and mass transfer by natural convection which is caused by heat and mass diffusion can be seen in nature and some processes of industry, such as evaporation and desiccation. these processes relate to aeronautics, hydraulics, mechanics, chemical engineering, oceanography and aerography

    熱及物質擴散引起的傳熱傳質復合自然對流常見于自然界和蒸發、乾燥等工業過程，涉及到航空、水利、機械、化工、海洋、氣象等諸多領域，其流體力學和傳質傳熱特性一直是人們研究的重點。
  2. The atmospheric phenomena suggested by jovian cloud tops are caused by convection, the transfer of heat from the interior of the planet to its surface and beyond

    木星雲頂景觀顯示了由熱對流造成的大氣現象：對流將熱量從行星內部轉移至表面或更遠的地方。
  3. Convection is heat transfer by mass motion of a fluid such as air or water when the heated fluid is caused to move away from the source of heat, carrying energy with it

    對流是傳熱集體議案的流體，如空氣或水，當加熱流體是造成搬離努力從源頭上的熱量，進行能量與它。
  4. Heat transfer by forced convection

    強制對蓮熱
  5. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定，確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒，增設煙氣含氧量分析，可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下，極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果，從而降低排煙溫度45 ，減少加熱爐排煙損失，節約了煤氣量6 %以上。
  6. Based on the review, the fluid flow and heat transfer in the curved circular and rectangular pipes have been researched by employing perturbation method and numerical simulation with a physical model under the rotational orthogonal curvilinear coordinate in a rotating curvilinear pipe with multi - parameters. we firstly analyzed the fully developed fluid flow and heat transfer, mixed convection heat transfer, the development of flow and heat transfer in the inlet in different cross section ( circular, elliptical, annular and rectangular crossection ). the variations of the secondary flow, axial velocity, distribution of temperature, the friction force on the wall, the ratio of friction factor as well as the nusselt number with different dimensionless parameters had been examined in detailed

    本文在總結和分析了一個世紀以來有關曲線管道流動和換熱特性的研究成果的基礎上，以旋轉正交曲線坐標系統下的多參數旋轉螺旋管道中的對流傳熱為物理模型，通過攝動方法和有限體積法，首次對各種截面（圓截面、橢圓截面、環形截面、矩形截面）旋轉曲線管道內充分發展流動的流動結構和傳熱特性（包括耦合對流傳熱特性）以及旋轉曲線管道開口段發展流動的流動結構和換熱特性進行了系統的數值模擬和理論分析，詳細討論了各種無量綱參數對管道內軸向速度分佈、二次流結構、溫度分佈、壁面摩擦力、摩擦系數比以及管道nusselt數的影響，獲得了若干創新性成果。
  7. Between glass - cover board and endothermic board, honeycomb is placed, which can eliminate heat loss caused by air natural convection and greatly reduce heat loss caused by radiation, and hence a better transfer heat efficiency

    而在透明玻璃蓋板和吸熱板之間放置蜂窩結構，基本上能消除吸收表面和蓋板之間的空氣自然對流熱損失，並可大大降低輻射損失，顯著提高集熱器的熱轉換效率。
  8. The modified model took into account not only the coupled heat transfer of conduction, convection and radiation, but also the heat convection between each zone caused by temperature difference and airflow

    該模型綜合了墻體熱傳導、壁面對流熱交換以及內部控制體之間的對流熱交換過程。
  9. Primary heat transfer shall be accomplished by convection through the reservoir wall to the pumped fluid

    最初的熱交換應該通過貯存器殼與泵抽液體的對流來完成。
  10. Abstract : in the internal circulating fluidized bed, there exist the moving zone, fluidizing zone and heat transferring zone with different fluidized air velocities. the convection heat transfer coefficient of immersed tube in the heat transferring zone is impacted by the velocity of the moving zone nearby and its data and change trend are obviously different with those of the common bubbling bed. the maximum heat transfer coefficient is evidently higher than that of the bubbling bed. as the bed materials have not been fluidized in the heat transfer zone, the coefficient has increased highly. the curve of that changes gently, feasilble to control the combustion intensity in the fluidizing zone

    文摘:垃圾焚燒系統中，內旋流流化床存在不同布風速度的移動區、流動區和換熱區，處于換熱區的埋管的對流換熱系數受附近流動區氣流參數的影響，其變化趨勢及數值大小與普通鼓泡型流化床之間有明顯不同：最大的對流換熱系數明顯高於鼓泡床；換熱區尚未流化時，對流換熱系數已經大幅提高；整條換熱曲線的變化比較平緩，易於流化床濃相床內換熱。
  11. Abstract : by using the 3 - d unsteady state heat transfer equation, the heat convection and radiation between the checker and the gas which flows through the checker holes, and the heat conduction among the checker in the chamber of the hot blast stove were studied. the time dependable gas temperature and the temperature distributions within the checker were obtained

    文摘:應用三維非穩態熱量傳輸方程，對高爐熱風爐在燃燒過程中蓄熱室內格子磚與氣體之間的對流和輻射傳熱，以及格子磚內部的導熱過程進行了耦合求解.得到了在燃燒期內格子磚及燃燒過程中燃燒廢氣的溫度分佈情況及其隨時間的變化規律
  12. In this condition heat convection inside and outside of tube are coupled. coefficient of convective heat transfer inside and outside of tube gotten through such way compare with coefficient of convective heat transfer inside and outside of tube gotten through by electricity. for comparability between this two condition, the average heat flux on the tube must be equal for this two condition

    這種情況下管內外對流換熱是藕合的，得到的管內外對流換熱系數分別與電加熱管道壁面的邊界條件下管內和管外流動的對流換熱系數相對比，為了使他們具有可比性，我們規定在這兩種邊界條件下通過管子的平均熱流密度相等。
  13. The ash fouling online monitoring models are built for furnace, convection heating surface and tri - sectional regenerative air preheater based on the analysis and summarization the researches on the ash fouling monitoring technic and models of boiler. clean factor ( cf ) is chosen to express the effect on heat transfer of ash fouling and is calculated by heat transfer steady - state model

    在分析研究總結現有的鍋爐各類受熱面的各種灰污監測技術和模型的基礎上，建立了鍋爐爐膛、對流受熱面和三分倉空預器的灰污在線監測模型，以清潔因子表徵受熱麵灰污對鍋爐受熱面傳熱的影響。
  14. The experimental correlations for the forced convection - condensation heat transfer of flue gas in the heat exchanger are obtained by the experimental study result

    根據實驗研究結果擬合出了肋片管式冷凝換熱器煙氣強迫對流凝結換熱的實驗關聯式。
  15. Conventional submersible non - clog pump motors are air - filled non - jacketed type designed to be cooled by convection heat transfer to the surrounding media

    一般的潛水無堵塞泵電機是風冷、無加套結構設計，由周圍介質的對流傳熱進行冷卻。
  16. The characteristic of combined heat and mass transfer by natural convection has been the focus of researches for a long time. numerical analysis is conducted for combined heat transfer and mass transfer by natural convection on inclined surface. effects of the inclination angle and the ratio of buoyancies due to heat diffusion and mass diffusion on fluid flow and heat and mass transfer characteristics have been investigated for pr = 0. 7 and sc = 0. 05 - 5. 0

    本文採用數值計算方法研究了傾斜平面上的傳熱傳質復合自然對流，求解了動量、能量及質量的完整方程，考察了熱質擴散共存時傾斜平面上的流動和傳熱特性，著重分析了熱浮力及物質擴散浮力之比b和傾斜角度對流體流動和傳熱傳質特性的影響。
  17. And also meet experiment result well. the heat release from floor thought radiation is validated about 70 % by analyzing the surface coefficient of heat transfer with convection and radiation

    隨后，對低溫輻射地板上表面的對流換熱系數和輻射換熱系數分析結果表明地板表面輻射散熱量約佔地板表面總散熱量的70 。
  18. The approximate analytical solution of melting process within a spherical enclosure is to presented by contacting heat transfer. a numerical model describing the melting process is presented by considering the difference of the solid - liquid density and natural convection

    在所建立的模型中考慮了固相與液相的密度差和自然對流的影響，得出了各個時刻液膜厚度的分佈、融化速率和傳熟量等計算結果。
  19. In addition, the inner surface temperature with the effect of air convection in the detect is different from the one in terms of considering air heat transfer in the defect as conduction and the effect caused by radiation can be neglected

    考慮缺陷內空氣對流換熱的影響下得出的溫度與純導熱條件下得出的溫度存在較大誤差，輻射的影響可以忽略不計。
  20. Supported by the national natural science foundation of china ( study on heat transfer characteristics of downhole coaxial heat exchanger in convection geothermal reservoir ) and tianjin development and plan program of science and technology ( study of ecologic architectural energy system ), the thermal performance exploiting earth energy for heating and cooling is studied in this paper ， and its main purpose is to offer reference for increasing the percent of renewable energy in ecologic architectural energy

    本文在國家自然科學基金（井下換熱器周圍對流型地溫地層內的傳熱特徵研究）和天津市科技發展計劃項目（生態能源建築體系研究）的資助下，重點研究了地表熱能（或稱地溫能）高效利用中的傳熱與熱力性能問題，為可再生能源在生態能源建築中發揮更大的作用提供依據。
分享友人
分享到 Line

分享到臉書