heat-transfer equation 中文意思是什麼

heat-transfer equation 解釋
熱傳遞方程
  • heat : n 1 熱;熱力;熱度;熱量。2 體溫;發燒。3 (氣候的)高溫,暑氣。4 【冶金】熔煉的爐次;裝爐量;一...
  • transfer : n 1 移轉,轉送;調職;調任[轉學]證書;變換。2 (財產;權利等的)轉讓,讓與(證書),移轉,授受;...
  • equation : n. 1. 平衡,均衡;平均,相等。2. 【數學】方程式,等式。3. 【天文學】(時)差;均分,等分。4. 【化學】反應式。
  1. The calculation method using in factory has larger error and is n ' t used in high ignition point oil transformer. in this paper a calculation method, which has been verified by experiment results, is presented based on the fundamental theories and rule equation of heat transfer to calculate the temperature rise of average oil, top oil, coil, core and hot - point. a program has been compiled

    本課題立足於工程實際應用,根據傳熱學基本原理和經典試驗換熱準則式,通過對變壓器發熱冷卻原理進行分析和研究,提出了一套計算變壓器平均油溫升、頂油溫升、繞組溫升、鐵芯溫升和最熱點溫升的計算方法並編制了計算軟體,對影響變壓器溫升的因素進行了分析。
  2. Regressed the experimental date with linear use minimal dual multiply method. got the empirical equation of heat transfer and flow resistance in laminar, transitive and turbulent zone

    Reb隨肋高h 、肋軸向間距pt的增大而減小,隨肋寬的增大而增大。
  3. Coal - water slurry is a new type of clean fuel as a replacement for oil. this paper introduces the tests of maoming no. 2 oil - fired 220 t / h utility boiler being retrofitted to fire coal - water slurry, including slagging tendency, heat transfer performances and pollutant emissions. firstly the k - ? two - equation turbulence model is used in numerical simulation for the side - air burner, compared with the practical measures and tests, good accordance achives

    水煤漿是一種低污染、高效率、流動性強的代油新型清潔燃料,本文針對廣東省茂名熱電廠2 #油爐改燒水煤漿示範工程,對鍋爐改造后的結渣特性、爐內傳熱特性和污染物的排放特性進行了試驗研究。
  4. In order to overcome the difficulty mentioned above, this paper provides an improved heat transfer equation and a mended bem for the problems. first of all, the enthalpy and the " virtual temperature " are introduced into the paper to eliminate several mutative thermophysical properties in the heat transfer equation. secondly, the movement of the boundary between the solid and liquid phases in the billet is educed by virtue of the laplace transform

    這些改進包括:引入熱焓和「虛擬溫度」的概念,對非常數的熱物性參數進行整合:充分考慮鑄坯凝固潛熱釋放帶來的影響,利用「溫度回升法」來加以處理;利用拉氏變換和反拉氏變換的原理來對凝固過程中鑄坯內部固液相界面的移動方程進行了推導和求解,在凝固過程中充分考慮鑄坯內部的固液兩相的影響等等。
  5. In this paper, temperature distributions of buried cable were analyzed according to the knowledge of heat transfer, after constructing heat conduction equation and boundary condition, temperature distributions were calculated with the finite element method in which the grids divided into a triangle format

    摘要結合傳熱學知識對地下直埋電纜溫度場進行分析,構造出熱傳導方程和邊界條件后利用有限元法計算了地下電纜的溫度場分佈,計算區域採用三角形單元剖分法。
  6. 3 - d ift have three fin arrangements : staggered arrangement fins, in - line arrangement fins and spiral arrangement fins. the former experimental study regressed the experimental data of all three fin arrangements and obtained the heat transfer criterion equation of 3 - d ift, while the paper sets apart the three mixed fin arrangements and applies othorgonal testing method to the 3 - d ift with staggered arrangement fins which is wide used in the engineering

    原有的研究是將三種肋排列形式三維內肋管的實驗數據混雜在一起進行回歸得到三維內肋管的換熱準則式,而本文則將原有研究中混雜不清的肋排列的三種形式區分開來,並對其中在工程中應用最廣泛的肋叉排三維內肋管進行了詳細的正交試驗研究。
  7. The formulation for the flow model is given using the finite element / control volume ( fe / cv ) technique based on darcy ' s law of creeping flow through a porous media. the heat transfer model is based on the two - dimensional, transient heat conduction equation, including heat generation. the cure kinetics model is based on kamal ' s model, and the degree of the resin cure as a function of temperature and time

    樹脂流動階段的模擬是根據牛頓流體在多孔介質中的滲流理論,應用darcy定律並使用有限元/控制體技術建立起來的;熱傳遞模型是一個二維瞬態熱傳導方程,考慮樹脂反應放熱;樹脂的固化模型利用了kamal提出的固化動力學方程,將固化度取為時間和溫度的函數。
  8. It presents a mathematical heat transfer model of air and soil temperature in greenhouse basing on the theory of transmission of heat. the model calculates the heat diffuse coefficient of soil by difference method and establishes regression equation on experimental data by sas

    基於傳熱學的熱傳導方程,利用測試的地溫數據,選用差分法計算了土壤熱擴散率,應用sas軟體擬合了非線性方程,建立了日光溫室土壤溫度場的數學模型。
  9. Firstly, under the condition of constant viscous dissipation, the field coordination equation was induced for steady laminar convective heat transfer by the conditional variational principle based on the extremum principle of heat transport potential capacity dissipation

    首先在粘性耗散一定的條件下以熱量傳遞勢容耗散取得極值為優化目標,運用變分方法導出了層流對流換熱場協同方程。
  10. Abstract : by using the 3 - d unsteady state heat transfer equation, the heat convection and radiation between the checker and the gas which flows through the checker holes, and the heat conduction among the checker in the chamber of the hot blast stove were studied. the time dependable gas temperature and the temperature distributions within the checker were obtained

    文摘:應用三維非穩態熱量傳輸方程,對高爐熱風爐在燃燒過程中蓄熱室內格子磚與氣體之間的對流和輻射傳熱,以及格子磚內部的導熱過程進行了耦合求解.得到了在燃燒期內格子磚及燃燒過程中燃燒廢氣的溫度分佈情況及其隨時間的變化規律
  11. Research work of hyperbolic equation of heat conduction not only posses theoretical meaning, but can be used to engineering practices for solving the complex heat transfer at extreme condition

    研究雙曲型熱傳導方程對于求解極端條件下的復雜傳熱問題不僅具有理論意義而且具有工程實際背景。
  12. The model can be made into difference equation of the temperature field that can be used to simulate calculation ; then we can get the set of edge point, and we can have the function of the fire line, and we can also have the burned area, the length of fire line and the space of fire area ; it also come to the conclusion that the main factor of forest fire is convection heat transfer

    經差分處理,得到進行模擬計算的一組溫度場計算方程;由邊界點條件,求出邊界點的集合后,擬合得出火線函數,積分后可得到時刻火場的過火總面積、火線長度和火場形狀,同時進一步證實了對流傳熱方式是影響林火蔓延的主要因素。
  13. Identification of nonlinear source term of a heat transfer equation

    一類熱傳導方程非線性源項識別問題
  14. The result shows that the heat transfer coefficient within the hollow fiber module with laminar flow can be calculated based on the correlation. by analyzing the equation, it was founded that the heat transfer coefficient under laminar flow is almost independent of the feed flow rate. numerical simulation of temperature distribution in hollow fiber membrane module with laminar flow was carried out

    首先採用純水為研究體系,研究分析了中空纖維管內的傳熱系數,研究表明,纖維管內的流動屬于層流狀態,其邊界層傳熱系數可用關聯式來計算,由此式看出,層流狀態下,流速對傳熱系數的影響很小。
  15. The characteristic of flow and heat transfer in the annular curved eccentric pipes were studied. the convective heat transfer equation and numerical simulation were based on it

    摘要討論了環形偏心圓截面彎管內的對流換熱特性,並在此基礎上建立了對流換熱方程。同時採用數值模擬的方法分析了環形偏心圓截面彎管內的流場分佈。
  16. This article analyzes the characteristics of permafrost earth, establishes mathematical model of earth thermal transfer, which consists of thermal transfer equation in thaw zone, the conservation relationship of heat quantity transferring from pipeline to earth and from earth surface to atmosphere, earth temperatures at thaw zone interface, heat transfer condition of solid phase changing into liquid phase at phase interface

    文章分析了永凍土的特點,建立了永凍土地帶土壤傳熱數學模型:融化圈內外傳熱方程、管道向土壤和土壤表面向大氣所放熱量的守恆關系、融化圈界面處土壤溫度、相變界面處固相變為液相的傳熱條件。
  17. Compared with traditional air - conditioning, its advantages lie in thermal comfort energy efficiency free use of spacing and etc. this paper introduces the procedure and the result of the experiment of gas - heater radiant floor system and gshp radiant floor system and compares them with traditional air - conditioner. based on the analysis of the heat transfer of radiant floor, this paper uses the theory of heat transfer to establish a mathematical model and computes it with difference equation. the important factors inferred from the model such as floor surface temperature heat intensity composite heat transfer coefficient deviate from the experiment result in a small range of 20 % and fit the need of the practical use

    在分析了輻射地板傳熱機理的基礎上,文中利用熱傳導、大空間的自然對流換熱等傳熱學理論建立了輻射地板的傳熱模型,再採用有限差分方法對模型求解,所得有關輻射地板供冷熱性能的重要參數如地板表面平均溫度、熱流密度、地板表面復合換熱系數等與實測值相差在20以內,滿足工程使用要求;同時得出輻射地板盤管供水溫度是影響地板供冷熱性能的重要因素的結論。
  18. According to the theory of engineering thermodynamics and phase change, heat - transfer process of the special working fluid heat - pipe stove is analyzed. some hypotheses are postulated and with the help of equation of mass - conservation, energy - conservation, the dynamic concentrative parameter model is built, the change of each parameter is prescribed at any stage from starting to stopping. with the thermodynamic calculation of burnable process, the parameter of device, such as heat - transfer coefficient / thermal efficiency etc, are achieved under steady state ; based on theoretic calculation, observing the actual running circumstance of the heating stove in person, with some performance comparison between the new and the old, the high efficiency and reliability of heat - pipe stove is proved, the project which expend it in the oil - filed is feasible

    對充入該工質的熱管加熱爐,本文根據工程熱力學和相變傳熱學及相關知識,對其進行了傳熱分析,經過適當假設,運用質量守恆和能量守恆定律,建立了裝置動態集中參數模型,描述了加熱爐從開機到穩定運行這一動態過程各參數的變化情況,同時對燃燒過程也進行了熱力計算,最終得到了穩態工況下裝置的換熱系數、熱效率等熱力參數;在理論計算的基礎上,親赴現場觀察該爐的實際運行情況,通過與原有的加熱爐的各項性能進行對比,最終證明新爐的高效性和可靠性,為其在油田中推廣的可行性提供了依據。
  19. In this paper, the continuity equation, the momentum equation, the k equation and the e equation are used to set up the theoretic model. the flow in the intake port is looked upon as the three - coordinate steady flow, but the heat transfer between the all and the flow in the intake port is n ' t considered

    本論文利用連續性方程、動量方程、 k方程、方程建立氣道流動理論模型,將氣道內流體看作三維定常流動,不考慮氣道壁面與流體之間的熱傳遞。
  20. Discrete ordinate solutions of radiative transfer equation and its practical utilization in the heat furnace

    離散坐標法及其在加熱爐中的應用
分享友人