heating insulation 中文意思是什麼

heating insulation 解釋
隔熱；熱絕緣
  • heating : adj. 1. 加熱的；供熱的。2. 刺激的。n. 1. 加熱；供暖；（建築物的）暖氣裝置。2. 白熾，灼熱。
  • insulation : n. 1. 隔離，孤立。2. 【物理學】絕緣，絕熱。
  1. Huida products are recommended as thermal insulation in stove, cave dwelling of steel mill, petrochemical, ceramics, glass, cement industries and power industries as well as other various ancillary heating equipment

    該材料由於使用溫度高，適用於鋼鐵、石化、陶瓷、玻璃、水泥等各種爐窯的保溫，及電力、機械、電子、造船等行業的保溫隔熱。
  2. In some 4, 000 houses and buildings in germany, switzerland, austria and scandinavia, extensive insulation, highly efficient windows and energy - conscious design have led to enormous efficiency increases, enabling energy budgets for heating that are a sixth of the requirement for typical buildings in these countries

    在德國、瑞士、奧地利和北歐，有4000棟的房屋和建築物具備大片的隔熱設備、高效能窗戶以及節能設計，使得能源使用效率大大提升，而暖氣的能源預算也只有這些國家中一般建築物的1 / 6 。
  3. For example, the temperature standards, the project adopted a geothermal heating to link with municipal heating networks. the designs of energy - saving insulation wall : extruded ceramic plastic plate, three - window design aluminum - plastics which meet energy requirements, and also to improve the insulation quotiety i

    如溫度標準，小區採取了地熱供暖方式，與市政供熱管網連接，採取節能保溫墻面體設計：陶粒加擠塑板，窗戶採用三玻鋁塑窗設計，即達到節能要求，又提高了保溫系數。
  4. It is designed according to electrical stove or microwave oven request. heating pipe adopts high temperature resistance mgo powder as the insulation medium and the stainless steel case is passed oxidation deal through the advanced web band protection oven 1050c in order to become the a special oxidation layer and improve the high temperature oxidation and bittern corrosive performance of the heating pipe. the heating tube has high power density and strong heat radion. this product with good safe performance can work normally after 3000hrs life test

    加熱管選用耐高溫氧化鎂作絕緣介質，不銹鋼外殼經過先進的網帶氣體保護爐1050的氧化處理，形成一種特殊的氧化層，提高電熱管的抗高溫氧化及鹽鹵的腐蝕性能。電熱管的功率密度較高，熱輻射能力強。產品經長達3000h的壽命試驗后，仍能正常工作，安全性能好。
  5. The core adopts cr20ni80 which is covered by silicon rubber insulation material. there also is heat conducting media outside of heating line with life time of over 1200h according to qb t1296 - 91electric heater for fridge 5. 12. 3, heating cable should bear 1. 15 times of the input voltage and 50 day continue life test

    使用壽命可連續達到1 200小時以上根據qbt 1 29691家用電冰箱用電熱線5 ， 123 ，電熱線應能承受額定輸入電壓的115倍，連續通電50天的壽命試驗。
  6. In order to enhance the precision, this design proposes that temperature - measuring circuit of platinum resistors and software should be employed to carry on adjustment of measured precision ; it also proposes that the interference of the grid can be reduced by the voltage front feed ; and meanwhile it calls for the application of the photoelectric insulation, the over heating protection and alarm so as to enhance the security performance of the system

    為了提高精度，本設計還採用了鉑電阻溫度測量電路，並利用軟體對測量精度進行自校準；通過電壓前饋控制減少電網干擾。此外，設計中還加入了光電隔離措施及過熱自動保護和報警功能，以增強系統的安全性能。
  7. The realization thought of the infrared nondestructive evaluation system software is : it can read and analyze the output image of the infrared scanner to get the information of the heating furnace, and then realize the function of image displaying, temperature analyzing, thermal insulation performance evaluation and damage detection

    紅外無損評估系統軟體的實現思想是：讀取紅外熱像儀拍攝得到的設備圖像，從圖像中獲得加熱爐的信息，然後進行圖像再現、溫度分析、保溫性能評估和損傷探測等。
  8. District heating pipes - preinsulated bonded pipe systems for directly buried hot water networks - pipe assembly of steel service pipe, polyurethane thermal insulation and outer casing of polyethylene

    區域供暖管道.直埋式熱水供暖網的預絕熱連接的管道系統.聚氨酯絕熱層和聚乙烯外覆層的鋼管組件
  9. Aluminum pipe heater uses aluminum pipe as carrier, common aluminum heat tube for insulation with silicon rubber max temperature below 150c. put wire heating component in aluminum pipe to form different shape components with max temperature below 150c. it have two types 4. 5, 6. 35 by outer diameter. suggest to use the power below 35w m and we can design specially for the bigger power

    以鋁管做載體，將硅橡膠加熱線置於鋁管內而製成的各種形狀的電加熱組件，最高使用溫度在150以下。根據鋁管外徑可分為4 . 5 6 . 35兩種類型。建議設計功率小於35w m 。
  10. After electric heating system is installed, check electrical insulation of all circuits. the insulation resistance between generatrix and shielding layer, core wires of series cable before connection at end not be less than 20 m. and then check if dc resistance of circuit is normal and phase resistance is banlance

    電伴熱系統安裝完工後，應逐路檢查系統的絕緣電阻：各種電熱帶母線與屏蔽層之間、串聯帶芯線尾端末短接前的各芯線間絕緣電阻均應不小於20m ；然後再檢查電熱帶直流電阻是否正常，三相電阻是否平衡。
  11. District heating pipes - preinsulated bonded pipe systems for directly buried hot water networks - joint assembly for steel service pipes, polyurethane thermal insulation and outer casing of polyethylene

    區域供暖管道.直埋式熱水管網用預先絕熱有包覆管層的管道系統.聚氨基甲酸乙酯熱絕緣和聚乙烯外覆層的鋼管用接頭組件
  12. After that, begin to construct thermal insulation and protection layer. then repeat last step ( 4 ) to check electric heating system and switch on for 24hours

    試送電運行正常后，可進行保溫層和防護層的施工。施工完后，電伴熱系統重復本節第（ 4 ）條的檢查，並連續通電24小時。
  13. District heating pipes - preinsulated bonded pipe systems for directly buried hot water networks - pipe assembly of steel service pipe, polyurethane thermal insulation and outer casing of polyethylene ; german version en 253 : 2003 a1 : 2005

    區域供暖管道.直埋式供熱網路用預隔熱粘結管系統.鋼制
  14. Analysis of the selecting of the insulation around the heating pipes

    熱力管道保溫材料的選用分析
  15. Methods measuring and evaluating heat loss and thermal insulation efficiency for thermal insulation construction of heating pipeline

    供熱管道保溫結構散熱損失測試與保溫效果評定
  16. Methodds measuring and evaluating heat loss and thermal insulation efficiency for thermal insulation construction of heating pipeline

    供熱管道保溫結構散熱損失測試與保溫效果評定方法
  17. Selection and application of insulation systems for heating, ventilating and air conditioning duct work

    加熱通風和空氣調節管道用絕熱體系的選擇和應用
  18. The passage dimension of separation chamber, the heating temperature of intake pipe air and the relevant influence of the ceramic heat insulation coating of combustion chamber upon the compressive ignition process of natural gas were studied by experiment

    實驗研究了分隔室通道尺寸、進氣管空氣加熱溫度、燃燒室陶瓷隔熱塗層對天然氣壓燃著火過程的相關影響。
  19. To reduce heat loss, the insulation must be coated on the pipe and heating cable

    為減少熱損失，應在電熱帶外側加保溫層。
  20. Further the heating platens are surrounded on the sides by insulation sheets, which are covered by a stainless steel frame

    加熱平臺的周邊由熱絕緣片包圍，這些熱絕緣片由不銹鋼支架包覆。
分享友人
分享到 Line

分享到臉書