impact displacement 中文意思是什麼

impact displacement 解釋
壓縮位移
  • impact : n 碰撞；沖擊（力）；（火箭的）降落[著陸]；【軍事】彈著；影響，效力。 The point of impact彈著點。 ...
  • displacement : n 1 轉位，移動；取代，置換；（人的）流離失所。2 撤換，免職。3 【機械工程】（活塞）排氣量；【航海...
  1. The equations of motion governing the axisymmetric elastic deformation of finite orthotropic cylindrical shells, involving the effect of transverse shear and rotational inertia, are derived. by applying the reverberation method, the displacement and the resultant forces of the shell in the phase space are expressed. then the transient waves in the finite orthotropic cylindrical shell subjected to the axisymmetric impact are obtained by using inverse laplace transforms. furthermore, the transient solutions are decomposed to the generalized ray integrals and computed numerically

    分析了計及剪切變形和轉動慣性的有限長正交異性圓柱殼中彈性瞬態波的傳播問題，採用回傳矩陣法，在相空間中給出了位移和內力的表達式。再利用laplace逆變換，得到正交異性圓柱殼受軸對稱沖擊作用時彈性瞬態波解，然後將其分解為若干廣義射線積分之和，並用數值方法求解之。
  2. The dynamic force - displacement relation curve is of crucial important to the design and operation of mechanical impact devices. using one - dimensional wave mechanics and characteristic line theory, this paper presents a testing method for determination of dynamic force - displacement relation curve from one - point strain measurement on an elastic rod endface. the principle of measurement, data processing method and experimental results for penetration into granite are discussed. 4figs., 5refs

    沖擊載荷下彈性桿端的作用力-位移關系曲線是沖擊機械繫統研究的重要內容.基於一維波動力學方程，應用特徵線方法，探討了已知一點應變求取彈性桿端的作用力-位移曲線的測試原理與數據處理方法，以及在花崗巖上沖擊鑿巖機具的測試結果，對一點應變測試法的可行性進行了論證.圖4 ，參5
  3. The dynamic data of displacement, strain and impetus force acquired from the experimental collection system are also well analyzed for measuring precision and errors. based on the underlying work and experimental features, the thesis proposes a simple, practical and well accurate impetus resultant force fitting method, weighted factor fitting method. a line - off data processing software system for bird - impact experiment, named as cadabie, is well designed under the principle of software engineering, and has been applied, with high praise, in bird - impact laboratory in the factory numbered 320 and esfahan bird - impact laboratory of iran

    本文系統總結了鳥撞實驗的全部過程、主要儀器設備的工作原理與性能參數，分析了鳥撞實驗動態數據採集系統中位移、應變與撞擊壓力傳感器測量系統的測量范圍、測量精度及其工作特點，提出了一種更適合鳥撞實驗的撞擊合力計算擬合方法：加權因子法，同時應用軟體工程原理編制了「鳥撞實驗計算西北工業大學博士論文機數據分析系統」 （ caoabie ） ，目前該軟體己經在320廠鳥撞實驗室以及
  4. Thirdly, it simulated the pumping circuit & dividing circuit with the widely used software matlab / simulink. the displacement of the rod piston and the impact of hydraulic are analyzed in the different input flow ( frequency of pump ) and different reversing time. it found out the cause of hydraulic impact ( one - to - one incorrespondence between the response time of dividing circuit and the operation time of rod piston ), and gave some methods to weaken hydraulic impact. in the final part of the paper, the reliability of the theory analysis is further verified by the experiment of hydraulic system

    首先在流變學原理的基礎上，深入分析混凝土在輸送管道內的流動狀態，得出混凝土泵的負載特性方程；然後根據功率鍵合圖的建模方法，建立泵送迴路和分配迴路的數學模型，並運用模擬軟體matlab simulink對泵送和分配迴路模型進行了模擬，分析了在不同的輸入流量（泵送頻率）和換向時間下，活塞桿的位移和系統的液壓沖擊情況，找到了引起液壓沖擊的根本原因（即分配迴路的響應時間（固定值）與活塞桿的運動時間（變化值）不相匹配） ，並提出了相應的改進方法。
  5. The effect of car body elastic vibration on the ride comfort is analyzed. the ride comfort and acceleration responses of the car system with rigid car body model or elastic car body model are studied and compared. finally by using ansys / ls - dyna software, the finite element impact models of car body with a rigid wall have been set up, then the displacement, velocity, acceleration and energy variation of the car body are analyzed and compared for before and after lightening cases under the condition of impact speed 5. 8m / s and 11. 8m / s

    本文利用ansys軟體建立了25k硬臥客車車體輕量化前後的有限元模型，計算了車體的強度、剛度和模態，並對輕量化前後的車體作了對比分析；然後，用nucars動力學分析軟體建立了25k硬臥客車系統的數學模型，分析了彈性振動對平穩性的影響，並對剛性車體和輕量化前後的彈性車體對平穩性和加速度響應的影響作了對比分析；最後用ansys / ls - dyna軟體建立了25k硬臥客車車體輕量化前後的動態顯式有限元模型，分別在5 . 8m / s和11 . 8m / s的速度下碰撞剛性墻，得到了車體的相對位移、速度、加速度和能量的變化過程，並作了對比分析。
  6. But it will affect the airflow organization with the cooled airflow drops. also, it studies the impact of solar radiation on displacement ventilation and cooled ceiling system. horizontal warm areas lowers the height of thermocline and is unfavorable to displacement ventilation system ; vertical hot surfaces will destroy the thermal stratification

    水平熱表面的存在，會使系統的溫躍層高度降低，對置換通風系統會有負面影響，為了減小水平熱表面的影響，對于地板材料應該選擇對長波輻射吸收較低的物質;垂直局部熱表面的存在會破壞置換通風系統溫度分層的特性，使垂直方向溫度變化減小。
  7. The energy due to the beam ' s falling is overwhelming. this impact will do great harm to the sub structure. the beam ' s falling, mainly because the displacement of the pier ' s top supporting the beam makes the span become greater, or the pier ' s displacement brings the beam change its position, which makes it come away from the pier ' s top

    對于簡支梁橋，當地震作用發生時，落梁是一種主要的破壞形式，落梁的能量具有壓倒性優勢，沖擊會給下部結構帶來極大的影響，而墜落的原因，多數由於支承梁的兩橋墩的墩頂位移而使跨度變大，或是因為橋臺位移帶動梁使梁錯位，造成梁在墩頂處脫開。
  8. The displacement quantity can be transform into corresponding standard industrial measuring signal, when in a certain overpressure, the membrane could be direct stuck on the solid matrix. if overload pressure is increased the membrane also cannot be made the greater distortion, then be sure that the membrane cannot be damaged because of overpressure, so that the sensor has the very strong anti - impact and anti - overload ability

    把位移量換成相對應的標準工業測量信號，在一定過壓時，膜片會直接貼到堅固的基體上，過載壓力加大，也不會使膜片產生更大的變形，從而保證膜片不會因為過壓而損壞，所以傳感器有很強的抗沖擊及抗過載能力。
  9. Another factor that may have an impact on job creation is the possibility of displacement

    另一個會影響創造職位的因素，是部分回收商可能遭受淘汰。
  10. Abstract : a previously proposed approximate quasi - static theoretical method is employed herein to examine the deformation and perforation of a simply - supported circular plate struck by a flat - faced projectile at normal incidence. based on the principle of virtual work, static load - displacement relationships are first obtained and then used to predict the energy - absorbing capacity of the plate subjected to relatively low speed impact. it is shown that good agreement is obtained between the theoretical predictions and the available experimental data, provided that adiabatic shear plugging failure does not occur, but the influence of strain rate sensitivity is taken into account

    文摘:採用準靜態近似理論方法分析簡支圓板在平頭彈丸正撞下的變形和穿透.首先基於虛功原理得到了靜態荷載位移關系，並將其用於預測低速沖擊下圓板的能量吸收能力.當考慮了材料的應變率敏感性，並且不發生絕熱剪切沖塞破壞的前提下，理論預測和實驗結果吻合良好
  11. It will have a direct impact on the displacement compressors, power consumption and reliability of operation, the current compressor is fast direction, and rotational speed limit is one of the key issues in improving air valve

    它的好壞直接影響壓縮機的排氣量、功率消耗及運轉的可靠性，目前壓縮機正向高速方向發展，而限制轉速提高的關鍵問題之一就是氣閥。
  12. Abstract : based on spline function method, the spline finite element formulation for the contact - impact problems is proposed. in order to get the formulation, the b3 spline function is used to distribute the contact problem, and numerical examples are analyzed to show the effectiveness of the method. because the spline function has double characteristics including analytical and numerical, and good continuity and high correctness, a little unknown number and high efficiency, the spline functions are used to set the displacement of the bar, and the whole structure equations are constructed directly. it is convenient to analyze dynamic response of the structure by using the method

    文摘:用樣條有限元法分析了桿的接觸沖擊動力響應問題，建立了計算格式，並用算例說明該方法的有效性.該方法充分利用了樣條函數的解析和數值雙重性及連續性強的優點來構造桿的位移函數，因此可推廣應用於分析結構在沖擊荷載下的動力響應問題
  13. In this paper, the effect of velocity pulse in near field ground motions is emphasized and the influence of velocity pulse to acceleration velocity and displacement in earthquake ground motions is analyzed by using simple impact modal

    摘要著重介紹了幾次地震中出現的近場地震動的速度脈沖特性，並利用簡化沖擊模型來分析速度脈沖效應對地震動加速度、速度、位移的影響。
  14. The force - time curves are then converted to force - displacement curves to calculate the energy associated with different impact phase. the results show that the maximum load of the composites with non plasma treatment filament is low and the absorption is also low in the initial crack phase

    通過對載荷?位移曲線進行積分，可得到不同試樣在沖擊過程中吸收的總能量、裂紋起始區吸收的引發能以及裂紋擴展區吸收的擴展能，從而分析界面粘結強度對材料能量吸收能力的影響。
  15. The formation and formation reason of inertial force during the impact tests were studied by the force - displacement curve to determine the inertial force

    摘要利用儀器化動態沖擊機測試力位移曲線，研究了沖擊過程中慣性力的產生，並分析了其產生原因，以確定慣性力。
分享友人
分享到 Line

分享到臉書