indoor temperature 中文意思是什麼

indoor temperature 解釋
室內溫度
  • indoor : adj. （opp. outdoor）1. 屋內的，室內的。2. 待在家裡的。3. 〈英國〉救濟院內的。
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. Based on developed experimental testing facility, the shading performances of southing horizontal shading devices, vertical shading devices and integrative shading devices of external windows are measured, the performance parameters including indoor temperature, air - conditioned cooling load and shading coefficient as so on. and the shading coefficient of experimental test results and calculation results based on design standard for building energy efficiency are compared, and the windows5. 2 simulation results are compared also. the measured results are consistent with the calculation results of horizontal shading devices and vertical shading devices

    本文利用研製的建築遮陽性能檢測裝置，對南向水平遮陽板、垂直遮陽板和綜合遮陽板外窗的遮陽性能（包括室內溫度、空調耗冷量和遮陽系數等）進行了實驗測試，並對遮陽系數的實驗測試結果與節能設計標準的計算值以及windows5 . 2軟體的模擬結果進行了比較分析，測試結果表明水平遮陽板和垂直遮陽板外窗的遮陽系數與計算結果比較一致，相對誤差分別為2 . 5 %和4 % ，而綜合遮陽板外窗的遮陽系數與計算結果的差值比較大，相對誤差達到10 %以上。
  2. Test and analysis on the indoor temperature gradient of low - temperature hot water floor radiant heating

    低溫熱水地板輻射供暖的室內溫度豎向分佈的測試與分析
  3. The average pmv value indoor by ceiling heating is higher than the other two be used for room heating under same energy consumption, and the vertical distribution of indoor temperature results by either of the method in a heating room is different from that in a closed room

    頂棚輻射供暖墻體具有一定蓄熱能力，使其節能性優于散熱器供暖和熱風供暖。在相同的能耗條件下，輻射供暖比散熱器供暖和熱風供暖的pmv值要高。
  4. Through the research work of this article, it is shown that cfd technology can efficeintly instruct the design of indoor air distribution and evaluate indoor air quality and ventilating effect ; the distribution of heat sources have great impact on indoor air distribution ; under variable air volume condition, the indoor temperature and velocity fields are quite even and the thermo - environment is relatively good when using diffusers with coanda effect such as square diffuser and slot diffuser to supply air

    經過本文研究發現，利用cfd技術可以有效地對空調室內氣流組織設計進行指導，全面對室內空氣品質和通風效果進行評價。熱源分佈對于空調室內的氣流組織具有極其重大的影響。在變風量條件下，利用具有良好貼附效應的送風口如方型散流器和條縫風口送風，空調室內的溫度場和速度場較均勻，室內的熱環境良好。
  5. Then the air distribution system of the above - mentioned hotel ' s multi - function - hall was simulated with fidap, and the indoor temperature and velocity under the preliminary option was calculated. under the half - load condition of small air - supply quantity and slow velocity, finds that the problem has arisen, which the cold jets fall too fast in summer and the air distributes layer upon layer in winter

    然後應用fidap對上述旅館的多功能廳空調氣流組織初步方案進行了數值模擬計算，預測了該初步方案的室內溫度、速度分佈，發現在送風量和送風速度小的半負荷工況下，會出現夏季送風時冷射流過早下降，冬季送風時氣流分層分佈的現象。
  6. Pmv and the indoor temperature field can be used to evaluate the effect of heating in a large amount air current condition. the result of analysis indicate that the radiation heating and radiator heating have some advantages in such rooms, and hot - air heating is an unsuitable way for room heating

    分析結果后認為， pmv和室內溫度分佈是評價大換氣量房間不同供暖方式室內熱環境的重要參數，在這類房間中，輻射供暖和散熱器供暖將各有優點，而熱風供暖則是一種不宜採用的供暖方式。
  7. Ensuring that the indoor temperature of air conditioned offices and public waiting areas is not lower than 23j in the summer months

    確保有空調的辦公室及公眾輪候地方在夏季的室溫不低於攝氏
  8. Lewis relationship has been suggested to evaluate the surface mass transfer coefficient using the average surface convective transfer coefficient. in addition, a practical analytic technique for testing the surface mass transfer coefficient is proposed and the values of he surface mass transfer coefficient have been given for the particular desorption and absorption test and validated against lewis relationship results. indoor temperature and humidity evaluation equations of adobe buildings considering the moisture absorption and desorption by interior materials have been proposed based on the analysis of the indoor dynamic thermal and moisture process

    通過理論解析和實驗測試定量地研究了生土建築圍護結構表面吸放濕效應，首次提出了以空氣濕度（ kg / kg ）為驅動勢差的圍護結構表面吸放濕量計算公式，該公式較適用於工程計算，從而為使建築濕環境研究成果逐步應用到建築工程實踐中奠定了理論基礎和提供了簡便演算法；通過對國內外關于表面質交換系數確定方法的研究成果的分析，提出用lewis關系計算生土建築圍護結構表面質交換系數；在實驗室環境下，對生土建築圍護結構表面質交換系數進行了測試方法研究，測試結果和利用lewis關系得到的數值較接近。
  9. Two typical examples analyses are conducted for the average conditions both of winter and summer climates under vapor diffusion and air leakage. a further discussion is set forth to determine the main factors that the moisture accumulation in wall is affected. it is found that the factors are the relative humidity at the wall surface, indoor temperature, permeability, air pressure difference and rate of the infiltrative or exfiltrative airflow

    本文首先研究了墻體內的濕氣遷移過程，詳細分析了濕積累現象形成的原因，通過對夏、冬兩季平均氣候下墻內溫度、水蒸氣壓力、相對濕度及濕積累在僅有擴散、擴散與空氣滲透同時存在等情況所作的具體計算，發現墻內、外表面的相對濕度、室內溫度、滲透率、空氣壓差以及空氣的滲流速度是影響墻內濕積累的主要因素。
  10. Storing ultra - dried ceratoides arbrescens seed ( mc 4. 2 % 4. 5 % ) in an outdoor temperature or in a low indoor temperature achieves basically the same result - life of the seed is prolonged

    摘要華北駝絨藜種子在超乾燥（含水量4 . 2 % 4 . 5 % ）室外溫度條件下貯藏，與低溫貯藏效果基本相同，能顯著延長種子壽命。
  11. Abstract : this article lists some notices of the measurement points and their importance in cleanrooms, content focus on ： indoor temperature measurement, humidity survey, exhaust air flow measurement, production line velocity measurement, inside and outside pure room differential pressure survey and the related test equipment for those measurement mentioned above

    本文主要介紹了潔凈室里需要注意的幾個測量點和它重要性，內容包括：室內的溫度測量、濕度測量、送風量和排風量的測量、成品生產線上的微風速測量、潔凈室內外壓差測量等，以及與之配套的測試儀器選擇方法。
  12. This kind of detector has many merits as follows : fast response time, large output current, fine linear response, high sensitivity to many particles including neutron, charged particle, x - ray, gamma - ray, visible light, and being able to work at indoor temperature

    這種探測器具有時間響應快，輸出電流大，對多種粒子如中子、帶電粒子、 x射線、射線、可見光都具有高靈敏度，而且響應的線性性好，可在室溫工作等特點。
  13. Based on thermal comfort formula and pmv / ppd evaluation indices, design indoor temperature of residential building with household heating and heat metering systems was studied in this dissertation. it was determined that the range of indoor temperature is 16c ~ 24c when design indoor temperature is 20c

    本文從熱舒適、工作效率以及健康標準等方面出發，以熱舒適方程及pmv ppd評價指標為依據，對採用分戶計量供熱系統的居住建築的室內設計計算溫度的確定進行了研究，確定其為20 ，室內溫度的變化范圍是16 24 。
  14. Installing an independent air conditioning control at the general post office, allowing individual officers to control the indoor temperature and air flow of the rooms

    在郵政總局裝設獨立空調控制器，讓各人員能自行調節室內溫度和空氣流量
  15. As far as energy efficiency buildings, design indoor temperature is increased, but its energy consumption is less than that in ordinary buildings at the temperature of 18c

    研究表明，對節能建築而言，雖然室內設計溫度提高了，但是採暖能耗比非節能建築在18時的能耗低。
  16. Of course, increase of design indoor temperature must lead to increase of energy consumption, so the feasibility of 20c is demonstrated from the aspect of building consumption

    當然，溫度的提高必然帶來能耗的增加，因此從建築能耗方面論證了室內設計溫度提高為20的可行性。
  17. Because indoor environment temperaturejs a large time - delay system of non - linearity and big inertia, it is a discontinuous process to adjust temperature by traditional air - conditioner inevitably. the compressor ca n ' t adjust its running situation at an appropriate speed according to indoor temperature changes, which will result in dweller ' s uncomfortableness and energy waste

    由於壓縮機的on off控制方式及空調器自身的非線性、大延遲時滯系統的結構特點，以及壓縮機室內的輸出與壓縮機室外的輸出相比有一定的滯后性，這樣就造成室內溫度波動性較大，勢必影響空調的溫度控制精度和人的舒適性。
  18. The results indicate that thermostatic radiator valves can regulate and control indoor temperature effectively and save heating energy consumption, and that using thermostatic radiator valves can produce good economic benefit because the initial investment is lower and the payout period is shorter

    分析結果表明散熱器恆溫控制閥可以有效調控室內溫度和節約供暖能耗；恆溫控制閥初投資低和投資回收期短，在實際應用中可以產生良好的經濟效益。
  19. The study results showed : ( 1 ) the bigger the temperature difference between indoor and outdoor air, the more obvious and more flux of the drop flow ; ( 2 ) the drop flow influenced the room temperature distribution and could even destroy the indoor temperature delamination ; ( 3 ) the prediction values agreed well with the test values, and the modified model could be utilized completely to predict the air - temperature distribution in a chilled wall room with underfloor system

    研究表明室內外溫差越大，壁面下降流越顯著且流量越大；下降流影響房間內溫度分佈且破壞了地板送風房間的溫度分層特性；預測值與實驗值有著良好的一致性，因此該模型可用來預測具有冷卻壁面的地板送風房間溫度分佈。
  20. An experiment was conducted to measure and analyze five important parameters of indoor air quality ( laq ) in public such as the surroundings of food and drink in hotels, including indoor temperature, indoor relative humidity, indoor concentrations of co2, hcho and total volatile organic compound ( tvoc )

    摘要主要針對公共場所（酒店餐飲空間）的室內溫度、相對濕度、 co2體積分數、甲醛（ hcho ）和總揮發性有機物（ tvoc ）質量濃度等5個室內空氣質量的重要參數進行了檢測和分析。
分享友人
分享到 Line

分享到臉書