influence of magnetic field 中文意思是什麼

influence of magnetic field 解釋
磁場影響
  • influence : n 1 影響，感化 （on; upon）。2 勢力，權勢。3 有影響的人物[事物]，有權勢的人。4 感應。vt 1 影響。2...
  • of : OF ＝Old French 古法語。
  • magnetic : adj. 1. 磁（性）的；（可）磁化的。2. 吸引人心的；有魅力的。3. 催眠術的。
  • field : n 菲爾德〈姓氏〉。n 1 原野，曠野；（海、空、冰雪等的）茫茫一片。2 田地，牧場；割草場；〈pl 〉〈集...
  1. The way beehives are built is further evidence of the influence of the magnetic field.

    建築蜂房的方法更進一步證明了磁場的影響。
  2. Using the particle - in - cell ( pic ) model, a 8 millimeter relativistic backward wave oscillator underlying superradiance mechanism was gotten, the influence on both operation frequency and radiation efficiency of the guiding magnetic field, the diode voltage, the beam current and the beam radius as well as the corrugation structure were also presented

    採用pic方法，通過數值模擬優化設計了超輻射狀態下的8毫米相對論返波振蕩器，分析了引導磁場、二極體電壓、電子束流、電子束半徑、周期慢波結構等對器件的輻射功率及輻射效率的影響。
  3. The scaling relations of conduction time and opening time with the plasma density, which are computed by a series of simulation results, show that, influence of plasma density on conduction time is greater than opening time. influence of cathode em itted electrons on conduction process, which is found to be more important when initial plasma density is low, is dependent of the initial plasma density. the penetration of a magnetic field into cylindrical middle - density ( 1013 / cm3 ) c + + and h + plasma with uniform and parabolic density profile, are examined with aid of pic simulation

    模擬得到的低密度（ 10 ~ （ 11 ） cm ~ 3 10 ~ （ 13 ） cm ~ 3 ）條件下導通和斷路時間與等離子體密度的定標關系曲線顯示：密度對于導通時間的影響遠大於對于斷路時間的影響；陰極電子對于peos導通過程的影響程度與初始等離子體密度有關，初始密度越大，陰極電子的影響就越小。
  4. The results of simulations are : i ) energies of the incident ions to the target are determined mainly by the voltage across the cathode sheath, with a majority of ions " energy vary around the sheath voltage ; ions nearly normally bombard the target ; ions mainly locate above the sputtering holes because of the influence of the magnetic field, and the incident ions mainly come from the region ; the ions undergo several collisions during transportation, but that do n ' t matter much

    主要模擬結果有： ? ）入射離子到達靶面時的能量主要受到了射頻輝光放電中陰極殼層西北工業大學碩士學位論文李陽平電壓的影響，大部分離子的入射能量在陰極殼層電壓值附近，離子濺射時接近於垂直入射;射頻輝光放電受到陰極磁場的影響，等離子體中的離子主要集中在靶面濺射坑的上方，且入射離子主要來自這個區域;入射離子在輸運過程中和背景氣體分子有少量的碰撞，但影響不太大。
  5. The influence of msfvw bandwidth on the diffraction efficiency is also considered. for the nonuniform bias magnetic field of u - type parabola profile, when the msw frequency is less than the cut - off frequency at the edge of mo film, the effective mo interaction length reduces. the edge cut - off frequency is determined by the maximum of the nonuniform field

    對于拋物型分佈（開口向上）的偏置磁場，當激發靜磁波的rf頻率小於邊緣截止頻率時，磁光作用的有效長度減小（與靜磁波頻率有關） ;邊緣截止頻率由不均勻磁場的最大值決定，靜磁波的下限截止頻率由不均勻場的最小值確定。
  6. The shape and the structure of the internal thermal shield are complicated. in this paper, a method which can be used to calculate the parameters which can influence the penetration of magnetic field is provided

    針對內冷屏幾何形狀和結構形式的復雜性，提出了一種求解反應其對磁場滲透影響的參數求解方法，這種方法也可用於任意形狀的復雜金屬殼體。
  7. Against a prototype which is being produced ， its three dimension end region entity model of stator is established ， and with the aim of simplifying calculation ， the theory of how to simplify entity model is studied ， then the theory is made use of ， and the end region entity model of stator is simplifi - ed ； meshing characteristics of three dimension entity model and shortcomin - gs of end region entity model of stator are studied ， then meshing method of three dimension end region entity model of powerformer stator is studied as well ， and the simplified entity model is meshed with this meshed model ， the distribution of end region magnetic field of stator is analyzed ， and the magnetic field energy and reactance of powerformer end region are calculated and compared with design value because the prototype is being produced ， in this paper ， stator core ， gap and eddy equipment are not taken into consideration ， and this has a little influence on the result ， but through analysis ， the result is proved to be good through the example calculation ， it is known that the method of this paper is useful and through theoretic analysis ， it is proved that end region

    針對一臺生產中的樣機，對其建立了定子端部三維實體模型，而且為了達到簡化計算的目的，研究了如何將其簡化的理論，並應用這些理論對樣機定子端部實體模型進行了簡化；研究了三維實體模型的剖分特點和定子端部實體模型存在的缺點，在此基礎之上，研究了對簡化的powerformer定子端部三維實體模型的剖分方法，並且對簡化的實體模型進行了剖分。應用剖分的三維實體模型，用有限元法分析了powerformer定子端部的磁場分佈，計算了端部區域的磁場儲能，並利用磁場儲能計算了powerformer定子端部漏抗，將計算值與設計值進行了比較、分析。由於樣機處在設計生產階段，本文暫時沒有考慮定子鐵心、氣隙和渦流器件對端部磁場的影響，這對分析結果有一定的影響，但是仍然得到較好結果。
  8. Abstract : this article analyzes the reason and influence of magnetic blow on welding arc during the welding process. through the adjusting and improving of the magnetic field distribution, adopting the anti - magnetic erasing method to eliminate the influence of magnetic blow for welding arc

    文摘:分析了磁偏吹在焊接過程中對焊接電弧的影響以及產生原因，通過調整和改善焊接電弧周圍磁場分佈，並採用反消磁法，克服和消除了磁偏吹對焊接電弧的影響。
  9. Magnetic head is designed by six magnetic poles in symmetrical distribution, the design of excitation loop and excitation angle makes magnetic field act on welding arc region which could control welding arc effectively. the insulation, cooling and hermetization of magnetic head avoid the influence on magnetic field of outside ; miniaturization design of magnetic head could achieve different welding process

    磁頭裝置採用六磁極對稱勵磁方式設計，勵磁線圈和勵磁角度的設計使產生的磁場恰好作用於焊接電弧區域以實現對電弧的有效控制;磁頭的絕緣，冷卻，密封設計避免了焊接過程中外界因素對磁場的干擾;磁頭整體的小型化使該裝置可以實現多種形式的焊接工藝。
  10. In simulations, all important phenomena, such as non - neutral sheath widening near cathode, cathode electron emitting, current channel migrating to the load side of the plasma, ion accelerating toward cathode and magnetic insulation of cathode emitting electrons etc, have been observed and depict the internal physics of this device. also presented is the influence of cathode emitted electrons on phenomena in the conduction processes of pegs. the simulation results show, without cathode emitted electrons, rapid magnetic field penetration takes place only in region near the cathode, with cathode emitted electrons, magnetic field penetration takes place in all plasma region

    診斷發現了陰極表面非中性鞘層的形成、陰極電子發射、電流通道的漂移、等離子體離子加速以及陰極電子磁隔離等物理現象，揭示了這一斷路器件的物理機制；分析了陰極電子對peos導通過程中的物理現象的影響，模擬結果顯示：忽略陰極電子作用，磁場滲透現象主要出現在陰極表面區域，考慮陰極電子作用，磁場滲透現象出現在整個等離子體區域。
  11. Influence of end effect on air gap magnetic field, thrust is dwelt on, and the relationship between end effect force and structure parameters of motor is stated

    首先，理論分析了直線感應電機邊端效應對氣隙磁場、推力的影響及電機結構參數與邊端效應力之間的關系。
  12. The analysis and study on the dynamic efficiency of pmsm performing under the various loads. the influence of machine ' s parameters on dynamic efficiency and dynamic power factor is studied ; this has significant meaning for design of pmsm applied in the various load fields. the theoretical analysis and fem calculation fo air - gap magnetic field of pmsm is done

    在建立永磁同步電動機dq軸數學模型時，考慮了電機的鐵耗和雜散損耗，提高了模擬計算的精度，根據實測的負載變化情況，對永磁同步電動機的動態性能進行模擬，並研究分析了電機各參量對其動態平均效率和動態平均功率因數的影響，總結出變化規律。
  13. Some formulas are deduced and used to calculate the wastage of eddy current, and analyse factors about magnetic field and wastage of eddy current, at last measures for minishing the wastage of eddy current and the influence of magnetic field are put forward

    本文推導了隔離套中渦流損耗公式，分析了對磁場和渦流損耗的影響因素，提出了減小隔離套渦流損耗及對磁場影響的措施。
  14. This thesis is devoted to studying those issues relevant to the interaction of ultra - short ultra - intense laser pulses with overdense plasmas, including the generation and transport of relativistic electron beams, the generation of quasistatic magnetic field, the energetic ions production, and the influence of preplasma on electrons acceleration

    本文的研究目的是：利用粒子模擬方法，對超短超強激光脈沖與高密度等離子體相互作用中高能強電流的產生和輸運、準靜態磁場產生、高能離子產生等物理過程進行研究。
  15. The influence on the electromagnetic parameters, by the change of air ply, permanment magnet length and the magnetic pole arc coefficient, are calculated by the ansys software. the optimum parameter of the magnetic pole is obtained by solving the magnetic field

    運用有限元分析軟體ansys分析了通過改變電機極弧系數、磁鋼厚度和氣隙厚度對電機磁場的影響，以電機性能和磁鋼利用率為目標對這些參數進行了優化。
  16. The shg was found in as - prepared films and the intensity of film with 20 % se was bigger then that of 10 % se films. this phenomenon indicated that the film had been poled during the fabrication, due to the influence of electric field and magnetic field

    結果表明薄膜的制備方法影響了薄膜的微觀結構，磁控濺射過程中，電場和磁場影響了靶材原子的沉積，使玻璃薄膜中的電偶極子在一定程度上得到了定向排布，使薄膜呈現出顯著的二階非線性效應。
  17. Influence of magnetic field on rheology of foam drilling fluid

    磁場對泡沫鉆井液流變性能的影響
  18. Further measurements for the deposited films indicate that the appearance and the deposition rate of the films also vary. after we simulate the magnetic field in such case with c program, these variations are owed to distributed change of magnetic field near the target surface and in the discharging space, which can influence the motion of charged particles in the plasma obviously

    進一步對沉積薄膜的測量表明，薄膜的沉積速率等發生了變化，通過對空間磁場進行模擬計算發現，由於空間外加的縱向磁場引起了放電空間中以及靶面附近磁場分佈的改變，影響了等離子體中帶電粒子的運動並最終導致了上述變化。
  19. Influence of geomagnetic field on the formation of stress induced magnetic abnormalities

    地磁場在應力致磁畸變產生過程中的影響
  20. Influence of magnetic field on i - v relations of spherical cathode diode

    磁場對球頭陰極二極體特性的影響
分享友人
分享到 Line

分享到臉書