injection mass 中文意思是什麼

injection mass 解釋
貫入體
  • injection : n. 1. 注射。2. 注射劑，注射液，針藥，灌腸（藥）。3. 充滿，注滿。4. 【醫學】充血。5. 【機械工程】噴射。6. 【宇宙空間技術】（衛星等的）入軌，射入軌道，射入軌道的時間[地點]。
  • mass : n 彌撒；彌撒的儀式[禱告、音樂]；彌撒曲。 a high [solemn] Mass （有燒香、奏樂等的）大彌撒。 a low ...
  1. It shows that the injection quantity and the difference of temperature distribute as a parabola which is at the same load, and the minimum of the parabola corresponds to the optimum quantity of injection ( g ). under the condition that the quantity of injected mass, the air speed and the heat quantity is respectively g, v and q, the research demonstrates that the pentium iv chip ' s temperature variation can be controlled under 40c and work normally when the wind speed overpass 1. 5m / s and the power dissipation of the chip is 60w. otherwise this paper calculates the flooding limit of thermosiphon with several different methods

    對其充灌量、散熱量、電子元件（ cpu模擬晶元）表面與環境溫度之差及通風、流速的影響進行了系統的測試，發現充液量與溫差的關系在負荷不變時呈拋物線分佈，其極小值點對應的充液量是最佳充液量g 。在充液量為g時，對風速v 、散熱量q進行的研究表明，當風速超過1 . 5m / s后，奔騰晶元在60w發熱條件下晶元溫度小於40 ，能滿足長期正常工作。
  2. And the consumption which are caused by the deformation of the rock mass and the consumption which fill all the void space of the joint can be got. then the block coefficient k of the this geologic condition can be got by the actual consumption of the injection grout in the practical grouting

    本論文中主要通過有限元法來計算巖體的變形，並進而求得由巖體變形引起的那部分注漿量和完全充填節理裂隙的注漿量，再根據實際工程的實際注漿量來計算試驗所代表的地層的充填系數k 。
  3. This demand can only be supported by mass production processes that require specific material properties : technyl nylons allow fixation part manufacturers to downsize their production costs by lowering cycle time. technyl high crystallisation speed facilitates fast cycled injection moulding processes

    這種要求只有在對材料性能有特殊要求的成批生產過程中才能得以體現：泰克尼尼讓緊固件生產廠商得以通過縮短成型周期來降低生產成本。
  4. A vacuum interface used for atmospheric pressure ionization ion source was designed to couple with an orthogonal - injection electrospray ionization time - of - flight mass spectrometer ( tofms )

    摘要研製了一種大氣壓離子源真空介面，並已將其用於自製高解析度垂直引入式電噴霧電離飛行時間質譜儀。
  5. Wt has been applied to denoising, data compression, and resolution of overlapping signals in analytical chemistry that includes flow injection analysis ( fia ), voltammetric analysis, high performance liquid chromatography ( hplc ), infrared ( ir ) spectroscopy, mass spectroscopy ( ms ), nuclear magnetic resonance ( nmr ) spectroscopy, ultraviolet - visible ( uv - vis ) spectroscopy, photoacoustic spectroscopy ( pas ), extended x - ray absorption fine structure ( exafs ) spectrum, etc

    在分析化學領域中，小波變換在流動注射分析、伏安分析、高效液相色譜、紅外光譜、質譜、核磁共振譜、可見紫外光譜、光聲光譜、擴展x -射線吸收精細結構（ exafs ）譜等分析化學信號的平滑濾噪、數據壓縮、重疊信號解析等方面都有成功的應用。
  6. Zhongshan gu zhen town dafa plastic factory is a professional manufacturer of novel meter type energy save lamp case series, decoration type plastic accessories and plastic injection processing. we possess ten years production experience, high level technicians, many advanced injection machines, perfect management system. we are winning more and more favour and support from mass customers all over the country for our steady product quality, prompt delivery and considerate after - sales services

    中山市古鎮達發塑料廠是一間專業生產新款電度型節能燈殼系列產品，燈飾型塑料配件和注塑加工，憑借十多年來的生產經驗，高素質的技術人員，以及多臺高級注塑機設備，同時本廠擁有完善的管理體制，豐富的實踐經驗，產品質量穩定，起貨快，周全的售後服務因而贏得全國各地客戶的支持和信賴。
  7. Abstract : on the basis of the general chromatography rate model, the effects of bi number, number, mass transfer pel number, particle diameter, injection and ratio of solute diameter and pore diameter on the chromatographic peak of taxol and the separation of taxol and cephalmonnine were simulated with computer. the essential factors affect on the chromatographic process of taxol and cephalmonnine were obtained and a more useful theory was provided to direct the chromatography separation of taxol and cephalmonnine

    文摘:根據建立的液相色譜普遍化速率模型，模擬了比渥數、數、傳質彼克列數、粒徑、進樣量和溶質分子直徑同多孔粒子孔徑比對紫杉醇色譜峰峰形和紫杉醇和三尖杉磷堿色譜分離度的影響，獲得了控制紫杉醇和三尖杉磷堿色譜過程的主要影響因素，從而為紫杉醇和三尖杉磷堿的色譜分離提供了更好的理論指導。
  8. Standard test method for determining radionuclides in soils by inductively coupled plasma - mass spectrometry using flow injection preconcentration

    使用流體噴射預集中的感應耦合等離子體質譜測量法測定土壤中放射性核素的標準試驗方法
  9. Determination of pesticide residues in concentrated fruit and vegetable juices by gas chromatography - mass spectrometry with large - volume, temperature - programmed injection

    大體積進樣氣質聯用法測定濃縮果蔬汁中農藥的殘留量
  10. Based on a thorough investigation of the engineering geological condition for the reservoir region of the huizhou pumped storage power station, the in - situ trial pit water injection test, boring water injection test, and water pressure test were performed to study the permeability of rock and soil mass

    摘要在對惠州抽水蓄能電站庫區工程地質條件進行詳細調查的基礎上，採用現場試坑注水和鉆孔注水、壓水試驗等方法了解巖土體的透水性。
  11. As the key of the sample injection, a digital control instrument of mass flow controller ( mfc ), which can work in online and offline mode, was designed. it can give 4 flow signals accurately at the same time. the concentration and flux of the sample gas can be set by the instrument software

    進樣裝置的核心是自行設計開發的新型流量控制儀，該儀器採用數字介面，可以以聯機和脫機方式工作，能夠同時快速準確地輸出4路流量控制信號，對測試氣體的流量和濃度進行設定。
  12. Quantity of injection ? unless otherwise specified, 190 ml of the sample per kg of body mass of the animals is used

    注射劑量- -除另有規定外，每隻兔子每千克注射190毫升的樣品。
  13. At the conditions with the same fuel injection quantity per cycle and the same engine speed, with the increase of the additive mass fraction in the fuel, the ignition and heat release timings brought forward, the peak of heat release rate increased and the operating range at low engine load was enlarged obviously. however, excessive additives will make the engine be prone to knock, run rudely and shorten the operating range at high engine load

    在相同循環噴油量和相同轉速的條件下，隨著添加劑質量分數的增加， hcci著火和燃燒放熱提前，燃燒放熱峰值提高，低負荷工況范圍明顯拓寬，但過高的添加劑質量分數會使得發動機爆震，工作粗暴，導致高負荷工況變窄。
  14. 3, carry out detailed numerical simulation and analysis for heat extraction of deep - seated hdr based on the tengcong prefecture, reach the major variety rule of rock mass stress, temperature, fracture width depending on the heat extraction. ( 1 ) in the hot dry rock geotherraal energy extraction system, transportation of energy and flow of water arise mainly through the fracture, the lower temperature water attain the high temperature from the injection well to production well through conduction convection and take away the thermal from wall rock

    3 、認真地對騰沖高溫巖體地熱開發進行了數值模擬計算和分析，得出了地熱開發過程中巖體應力、溫度以及裂縫寬度隨地熱提取的變化規律等重要結論： （ 1 ）在高溫巖體地熱開發系統中，能量的運移、輸送與水的流動主要通過裂縫面發生，注入的低溫水在流到生產井的過程中，發生傳導、對流、吸收圍巖熱量，達到升溫的目的。
  15. The consumption of the injection grout include two parts : the consumption which are caused by the deformation of the rock mass and the slurry which fill the void space of the joint in the rock mass, this is q = q1 + k ? qq2. in this paper, fem is used to compute the deformation of the rock mass

    灌漿的注入量主要來源於兩部分：由巖體變形引起的注漿量和由漿液充填節理裂隙的空隙的注漿量，即： q = q _ 1 + k ? q _ 2 。
  16. Determination of organochlorine pesticides in river water by gas chromatography - negativeion chemical - ionization mass spectrometry using large volume injection

    質譜大體積進樣負化學電離法測定河水中的有機氯農藥
  17. The company collects product research, the design, the production and the sale in a body, the equipment have blow bottle injection molding printing and so on the necessary production line, may receive the mass the domestic and foreign customer oem order form

    公司集產品研究、設計、生產與銷售於一體，配備有吹瓶注塑印刷等配套生產線，可接收大批量的國內外客戶oem訂單。
  18. These laboratories use a number of advanced analytical technologies, including flow injection analysis for nutrients, inductively coupled plasma - atomic emission spectroscopy and inductively coupled plasma - mass spectrometry for metals, and gas chromatography - mass spectrometry and a uv detector coupled with a fluorescence detector for trace organics

    兩間化驗所應用先進分析技術分析樣本中各類參數，分析方法包括流動注射分析法分析養分電感耦合等離子-原子發射光譜法電感耦合等離子-質譜法分析金屬，以及氣相色譜-質譜法和紫外光螢光檢測法分析痕量有機物。
分享友人
分享到 Line

分享到臉書