inlet water 中文意思是什麼

inlet water 解釋
進入水
  • inlet : n. 1. 進口,入口。2. 【電學】引入,輸入,輸入線。3. 水灣,小港。4. 插入物,鑲嵌物。vt. (inlet, inletting)1. 引進。2. 嵌入,插入。
  • water : n 1 水;雨水;露;〈常作 pl 〉 礦泉,溫泉;藥水。2 〈常 pl 〉水體;水域;水道;海;湖;河;海域;...
  1. As for the dehumidifying conditions, the condensing rate for the humid air increases with reynolds number but decreases as the inlet temperature of cold water increases

    同時濕盤管的熱傳量及除濕率亦也隨著冰水入口溫度的降低而增加,顯熱比隨著冰水溫度的降低而減小。
  2. For a soil or rock of water - lacked, a heat transfer theoretical model is developed, which is a steady or unsteady, the results show that reservoir temperature, thermal diffusion coefficient, inlet temperature, flow rate of and run time of ground source heat pumps have an effect directly on heat transfer process of dhe. it can deduce that intermit running is favorable for this type of soils and rocks

    對于貧含水地下巖土層建立了穩態與非穩態傳熱的理論模型,分析結果表明,巖土層的熱儲溫度、導溫系數、埋地換熱器進水溫度、流量以及地源熱泵系統的運行時間或開停機比,都對埋地換熱器的傳熱過程產生直接影響,可以推斷,對于該類型巖土層的地源熱泵系統,採用間歇運行將是有利的。
  3. Experimental studies on s1a - 02 gas turbine with water injection into compressor interstage / inlet as well as that on turbocharger self - loop test rig with inlet water injection are introduced. test results are in good accordance with simulation results, wet compression can lower compression work and increase engine power output so engine performance is enhanced, if engine power output is not changed, efficiencies of compressor and this engine become higher and turbine inlet temperature and fuel consumption become lower and if keeping t4 the same as that before wet compression is used, efficiencies become furthermore higher and engine power output increases greatly

    實驗結果和計算結果同樣表明:濕壓縮減少了壓氣機所消耗的壓縮功,增加了燃氣輪機的輸出功率,提高了燃氣輪機性能,如果保持發動機輸出功率恆定,濕壓縮可以提高壓氣機和整個燃氣輪機機組的效率,與此同時,渦輪進口溫度t _ 3 ~ *和燃油消耗率下降;如果保持渦輪排氣溫度t _ 4 ~ *恆定,壓氣機和燃氣輪機機組效率進一步提高,燃氣輪機輸出功率增加。
  4. Rotation grid series : they are mainly used at water inlet, sewage and rainwater lifting pump stations, water inlet of sewage treatment plants, to prevent grass, wood, garbage and fibrous matters from entering water pumps and other devices behind so as to ensure the normal running of water pump and other equipments

    旋轉式系列格柵主要用於取水口、污水及雨水的提升泵站、污水處理廠進水口等處,用於阻擋草木、垃圾、纖維狀物質等雜物進入水泵和后續設備,以確保水泵及其它設備的正常運行。
  5. The sensible heat factors are found to increase with both reynolds number and inlet temperature of cold water

    濕盤管的熱傳量隨著入口風速與鰭片數目的增加而增加,顯熱比及除濕率亦隨著風速增加而增大。
  6. Close the cold water inlet valve and open a nearby hot water faucet

    關閉冷水進水閥,打開附近的熱水水龍頭。
  7. Install a shutoff valve in the cold water inlet line

    在冷水進水管處安裝一個關閉閥。
  8. Install a shut - off valve in the cold water inlet line

    在冷水進水管處安裝一個關閉閥。
  9. Tide control testing of water inlet model in power plant

    電廠取水口潮流控制的模型試驗
  10. Design of water inlet structure in mianhuatan hydropower station

    棉花灘水電站尾水岔管設計
  11. Design of water inlet stucture in mianhuatan hydropower station

    棉花灘水電站進水口結構設計
  12. Practice during the period of four years shows : ( 1 ) settled water pond and three - stage filtration system with mechanical agitation can meet the requitments of reverse - osmosis components to the inlet water quality ; ( 2 ) it must be considered in the design that the demineralization efficiency of reverse - osmosis components will be decreased about 1 % 2 % in every year ; ( 3 ) in normal case, the outlet water from reverse - osmosis equipment shall enter into mixed bed via a decarbonator ; ( 4 ) the output capacity of the mixed bed must have a sufficient surplus, to avoid its influence on the water supply

    經4年的實踐表明: ( 1 )採用機械攪拌澄清池和三級過濾的系統,可以達到反滲透組件對進水水質的要求; ( 2 )反滲透組件的脫鹽率每年約降低1 % 2 % ,在設計中必須考慮; ( 3 )一般情況下,反滲透裝置的出水應經過除碳器再送入混床; ( 4 )混床的出力必須有足夠的余量,以免影響供水。
  13. Through developing a 2 - dimensions heat transfer model of buried pipe - in - pipe heat exchanger and simulating the process by computer, the author figures out inter - relations of factors which influence characteristics of buried pipe - in - pipe heat exchanger, such as pipe diameter, pipe length, ratio of pipe diameters, flow rate, inlet water temperature, patterns of water inlet and outlet, and material features made of pipe, and proposes some optimizing indexes of buried pipe - in - pipe heat exchanger. the author studies the " heat - - short circuit " phenomenon as well and gives < wp = 5 > some important results

    本文通過建立地下套管式埋管換熱器傳熱過程的二維傳熱模型,並藉助計算機對分析結果進行解析,弄清了影響埋管換熱器性能的管徑、管長、管徑比、通過流量、進水溫度、進出水方式以及管材等參數的作用,並提出了相應的優化指標,對研究界懸而未決的「熱短路」問題也進行了細致分析,得出了有關結論。
  14. Reservoirs, dams, water inlet, water diversion tunnels ( including branch tunnels, water diversion canals, voltage adjustment wells ( towers ), open - air high - voltage conduits, premises, water discharge canals, communications facilities between premises and dams and other related ancillary equipment used by hydropower stations

    (三) 、水力發電廠使用的水庫、大壩、取水口、引水隧洞(含支洞口) 、引水渠道、調壓井(塔) 、露天高壓管道、廠房、尾水渠、廠房與大壩間的通訊設施及附屬設施。
  15. This experiment include many contents, in a word, that is summer condition experiment, winter condition experiment > summer - winter transition condition experiment and winter - summer transition condition experiment, furthermore summer condition experiment still include flux changing experiment and winter condition experiment still include thermal balance experiment this article dealt with the data of the test, calculating out energy absorbing ( energy discharging ) of buried pipe in winter condition ( summer condition ), input power of heat pump x heat exchanging of piece buried pipe length x co - efficiency performance ? op ( energy efficiency rate ? er ) and average heat exchanging coefficient ; in additiont this article compares the inlet water temperature and outlet water temperature of underground the first layer and the second layer buried pipe when heat pump was running, the results are that the heat exchanging ability of the second layer buried pipe outgos the first layer buried pipe, and heat exchanging is more stable ; and still analyse earth temperature resuming in the transition season. the results are earth temperature resume fast in the first week when the heat pump runs off

    本文測試內容相當多,概括地說就是四個工況的測試,即夏季製冷工況的測試、冬季供熱工況的測試、夏?冬過渡季測試和冬?夏過渡季測試;另外在夏季工況的測試中還進行了變流量測試,在冬季工況的測試中還進行了熱平衡測試。本文對測試數據進行了處理,計算出了冬(夏)季工況埋管吸(放)熱量、熱泵空調器供熱量(製冷量) 、熱泵空調器輸入功率、埋管單位管長換熱量、供熱性能系數(製冷能效比)和平均傳熱系數等;另外,還比較了熱泵運行時地下一二層埋管進出水溫度變化情形,得出地下二層埋管換熱能力優于地下一層埋管,且換熱很穩定;並分析了過渡季地下一二層埋管溫度恢復情形,得出熱泵系統停機一周內地溫恢復特別快。
  16. Influence of inlet water injeetion on performance of compressor

    增壓柴油機進口加濕壓氣機性能研究
  17. It was showed that temperature and quality of inlet water would affect the activity of denitrification

    受進水水質和低溫天氣的影響,反硝化細菌制劑的凈化作用及反硝化作用不能充分發揮。
  18. Open the inlet water valve and press the top discharge valve to discharge the air in the filter at the same time

    打開進水閥門,同時按下頂上排氣閥,使濾器內空氣排出即可。
  19. This article makes a model test research to filter function of porcelain sand filter according to the new material - porcelain sand filter - that baogang uses in the new water processing technology of sheet semifinished turbidity of the inlet water, different medicine and variation of outlet water quality in different filter velocity

    本文針對包鋼薄板坯連鑄連軋新水處理工藝中所採用的新型濾料? ?瓷砂均質濾料的過濾特性進行了研究。在不同的進水濁度、不同的加藥量、不同的濾速下出水水質的變化,對瓷砂濾料過濾性能進行了模型試驗研究。
  20. The relief valve shall have an internal sensing line to sense the inlet water supply

    安全閥應該配置內置感應管,用於感應水供應的進入。
分享友人