input chamber 中文意思是什麼
input chamber
解釋
泵的吸入腔-
The thoron chamber with the size of 350mm x 250mm x 180mm was made of the perspex. five holes were drilled on the two side with the size of 2 50mm xi 80mm for thoron source input or sampling
用有機玻璃製成（氣土）積累箱，尺寸為350mm 250mm 180mm ，在250mm 180mm的兩個側面上打了五個孔，用於充源或取樣。 -
The simple thoron chamber consists of three parts, they are the thoron accumulation box, the circuit of thoron source input and gas circulation, the circuit of thoron level measurement in the thoron accumulation box
簡易（氣土）室由（氣土）積累箱、充源循環迴路、積累箱中（氣土）水平標定迴路三部分組成。 -
Teacher worktable control system including main computer, instruct screen, scene watch screen, driver chamber monitor and relative input output equipment. main computer is the control center of the whole teacher worktable system
教員臺控制系統包括教員臺主機及顯示屏、場景監視屏、駕駛室操作監視器以及相關的輸入輸出設備，其中教員臺主機為整個系統的控制中心。 -
The research indicated that, if the secondary combustion chamber was looked on as a controlled object, with the adjusting valve as a input, the pressure and the temperature of a selected point on the inside wall of the combustion chamber as outputs, then such controlled system would be a strongly non - linear, time varying system with number of random disturbances, which resulted in huge difficulty to build an analyzed mathematics model for the spray burning of the liquid fuel, so that classic control methods were all invalid
研究表明，若將rbcc發動機的二次燃燒室視為一個控制對象，同時以燃燒室內壁面取定點處的壓強、溫度和調節閥的開度為輸入輸出變量，則該系統將是輸入?輸出特性非線性很強、隨機干擾嚴重的復雜時變系統。這導致建立燃油噴霧燃燒具體模型的很大困難，從而宣告了經典控制方案的失效。 -
A rectangular box simulating the axial box of the lathe tool is manufactured ; experimental measurements of the surface vibration on the rectangular box and the acoustic field around the rectangular box corresponding to firstly a series of a homogeneous excitation and secondly two iii independent white noise excitations are taken in a semi - anechoic chamber. taking the vibratory properties as input, the properties of the sound field are calculated by the evsbpm and the sdsbpm respectively. the effectiveness and reliability of the evsbpm and the sdsbpm for the calculation of acoustic radiation problem is further verified from the comparison of the calculated results and measured ones
第五章設計加工了一模擬機床主軸箱的長方箱體，在半消聲室環境下，分別對其在單點處一系列簡諧激勵作用下和兩點處的獨立白噪聲激勵作用下的振動及其輻射聲場進行了實驗研究和分析計算，通過計算結果和實測值之間的比較，進一步驗證了改進體積源邊界合肥工業大學搏士學位論文點方法和統計分佈源邊界點方法計算振動聲輻射問題的有效性和可靠性。
分享友人