input-power 中文意思是什麼

input-power 解釋
輸入電力
  • input : n. 1. 【電學】【自動化】輸入；輸入端。2. 輸入電路，輸入信號，輸入功率[電壓]。3. 放入物，投入的資金。vt. ,vi. 把（數據等）輸入計算機。
  • power : n 1 力，力量；能力；體力，精力；（生理）機能；〈常 pl 〉才能。2 勢力，權力，權限；威力；政權；權...
  1. In chapter we give out an explicit expression of classical capacity of general fermi quantum channel for single mode fermion system under the restriction of input average occupation numbers of fermions ( that is the input power restriction )

    第二章給出了輸入費米子平均占據數限定（平均輸入功率限定）的條件下的單模費米系統量子通道的經典容量。
  2. The amazing character of the quantum capacity of gaussian channel is that planck constant h takes over the place of input power restriction of classical capacity

    高斯通道量子容量的迷人特徵是普朗克常數h取代了經典容量中輸入信號功率限制條件的位置。
  3. A dead - line operation option permits using the batteries located in the control for operation of the recloser if ac input power is lost

    失壓線路方案在不能提供操作電源的情況下，控制器的內置的電池進行操作。
  4. Do not drive the speaker system with a continuous wattage exceeding the maximum input power of the system

    不要連續使用超過系統的最大輸入功率驅動揚聲器系統。
  5. Test results show that under 2 - tone test in 5mhz tone spacing, the power amplifier system achieves - 50dbc imd3 with 20w output power, improved 20db in imd3 compared with the one without linearity. estimated value of aclr comes to 53db, which satisfies the 3gpp requirement for wcdma base - station transistor. further tests with alterative input power indicate a steady suppression to the imd3 controlled by the adaptive system

    測試結果表明，自適應前饋功放系統在雙音輸出功率20w時三階交調系數小於- 50dbc ，鄰通道泄漏抑制比（ aclr ）的估算結果大於53db ，在理論上滿足3gpp對wcdma基站發射機的指標要求。
  6. Based on the six - port relative power theory that for a given load the relative power ratios of different ports are left unchanged with the input power to the six - port varied, characteristic parameters of detectors can be obtained through the least - square method

    根據六埠相對功率理論即對某一負載各埠相對功率比值不隨輸入功率變化，由最小二乘法得到檢波器的特徵參數，結合四標準法，確定六埠網路的系統常數。
  7. Aimed at design index of input power 1. 5kw, most output rotate velocity 300rpm, and rating output rotate velocity 150rpm, considering factors of angle and ratio of transmission, on the basis of kinematics simulation, author optimized the kinematics parameters. in this paper, author has made some analysis and study to the primal assembly condition of transformer ' s sequential action in theory, designed structure dimension of the input and output transformer, and verified the corresponding strengthen. further, the structure, which is to key transmission components of velocity control system of the speed regulator, has been designed based on meeting operational sensitivity, precision and self - locking

    本文針對輸入功率為1 . 5kw ，最大輸出轉速，額定輸出轉速的無級變速器的設計要求，並考慮到傳動角及變速比等因素，在運動學模擬的基礎上，對運動學參數進行了優化；本文對變換器連續作用的初始裝配條件進行了理論分析與研究，對輸入、輸出變換器作了結構尺寸的設計，並進行了強度校核計算；本文還對變速器調速系統中主要傳動構件在滿足操作的靈敏度、精度、自鎖性的基礎上進行了結構設計；最後採用workingmodel3d軟體，進行虛擬樣機的計算機輔助模擬設計及運動學和動力學計算。
  8. Measurement method of total input power of ballast - lamp circuits

    鎮流管電路的全部輸入功率的測量方法
  9. The stability of electric power system has been being focused for a long time toprevent a power system from losing synchronism after sudden fault ， researchers have done much work and got many accomplishments this paper applied the direct feedback linearization ( dfl ) technique on the power system ， a strong nonlinear system simulation results by matlab proved this method efficiency main works and results are as follows ： this paper compared some existing methods in excitation control ， fast valve control and coordinated control respectively, analyzed the developments and actuality of nonlinear control research in brief, illustrated why ransient stability could be greatly improved by using the fast valve control in chapter 3 ， indicated the importance of coordinated control farther this paper introduced the inverse system theory, based on which ， discussed the dfl theory, pointed out which had consistency with the inverse theory, expanded the dfl theory combined the idiographic model equations ， made which adapt to the model of a single machine - infinite bus power system this paper referenced abundance articles and educed a set of equations ， which could describe the dynamical process of excitation and fast valve control for synchronous generators in the equations ， there were several very important parameters of power system - - rotor angle ( ) ， rotor speed ( ) ， generator q axis voltage ( eq ) ， transient voltage ( e ' q ) ， active power ( pe ) ， mechanical input power ( pm ) ， valve opening ( ) ， generator terminal voltage ( vt ) ， based on the model ， nonlinear coordinated controller and terminal voltage optimal controller have been designed by using the expanded dfl theory and lq optimal control theory the simulation results showed that the controller could keep power system transiently stable under the effects of a symmetrical 3 - phase short circuit fault ， which achieved better postfault regulation compared with another two routine methods ， one is the proportion excitation controller and proportion fast valve controller, the other is the proportion excitation controller and the optimal fast valve controller, which could exert good performance when met 1ittle disturbance either

    在介紹逆系統理論的基礎上，詳細介紹了dfl理論，通過比較闡明了dfl理論其本質是逆系統方法的一類，並結合具體課題推導出的模型方程將dfl理論進行了擴展，使之適應于電力系統這個強非線性對象。通過參考大量的書籍文獻推導出一套實用的可將大型汽輪發電機勵磁與汽門綜合起來進行控制的模型方程，此模型方程涵蓋了電力系統中特別引人注目的幾個量- -轉子角、轉子轉速、發電機q軸電勢eq 、暫態電勢e ' q 、有功功率pe 、機械功率pm 、汽門開度、機端電壓vt ，在此基礎上建立了實用的電力系統簡化的數學模型，並將擴展的dfl理論應用於此模型系統，結合線性二次型最優控制理論設計出大型汽輪發電機的非線性綜合控制器及機端電壓最優控制器，通過模擬實驗與採用常規的按電壓偏差進行調節的比例式勵磁控制器+汽門比例控制及採用常規的按電壓偏差進行調節的比例式勵磁調節器和基於二次型性能指標設計的最優快控汽門（考慮發電機的飽和因素）進行了對比，證實了採用此種控制器可以有效地提高電力系統的暫態穩定性，並且在電力系統遭受小干擾時同樣具有良好的調節性能。
  10. The input power is also provided by a dc motor

    輸入動力也是由直流電機提供的。
  11. This method changes the input power of the motor

    此種方法改變電動機的輸入功率。
  12. Rated input power : 2400w

    額定輸入功率： 1300w
  13. Rated input power : 1300w

    額定輸入功率： 1300w
  14. Rated input power : 600w

    額定輸入功率： 600w
  15. Rated input power : 280w

    額定輸入功率： 280w
  16. Rated input power : 460w

    額定輸入功率： 460w
  17. Rated input power : 900w

    額定輸入功率： 900w
  18. According to the experimental parameters of mpt, the main performance parameters of different propellants have been given by engineering performance computation under designed and working states, which has great importance for the experimental research and the future work. 2. for helium and argon, the factors which influence on mpt ' s vacuum steady work have been discussed such as the material of microwave tie - in, the distance between the probe and inner - conductor, the position of the inner - conductor, the input power of microwave, the mass flowrate of propellant and the vacuum pressure of environment, and the influence has been discussed of the microwave power and the mass flowrate of propellant on the pressure of the resonance cavity, thrust, reflected power and the temperature of the resonance cavity

    論文的工作和新見解主要包括： 1在設計狀態和工作狀態下，根據mpt的實驗參數，對mpt使用不同工質時的性能進行了工程估算，這對mpt現階段的實驗研究和今後的研究有重要的指導意義； 2對于he 、 ar推進工質，討論微波的接頭材料、探針與內導體的間隙、內導體的位置、微波的輸入功率、工質的質量流量以及環境真空度對mpt真空啟動和穩定工作的影響，並探討微波的輸入功率、工質的質量流量對諧振腔壓強、推力、反射功率以及諧振腔溫度的影響； 3對于n _ 2 、 h _ 2 、 nh _ 3 、 h _ 2o推進工質，主要討論與he 、 ar工質不同的特性，並從長遠的眼光和工程應用的角度，認為其可行性不容置疑，潛在優勢不可忽略，是未來mpt應用的主流推進工質。
  19. Measuring the intracavity loss of laser. in the theory, we analyze the relation of output power and input power of the different transmission rate of output mirror. using the experiment validated the theory result

    實驗上測量了激光器的內腔損耗，並計算得到在泵浦功率等於2 . 2w時，最佳輸出耦合透射率t _ （ opt ） = 5 . 2 。
  20. The ratio of output power from an amplifier system, to the input power. gain is normally measured in decibels

    放大系統的輸出功率與輸入功率之比，增益通常用分貝表示。
分享友人
分享到 Line

分享到臉書