intake chamber 中文意思是什麼

intake chamber 解釋
電纜管道的引入人孔
  • intake : n 1 吸入，納入，收納。2 進水口 （opp outlet）; 輸入端，（礦井的）進風巷道，通風孔。3 吸氣，進氣。...
  • chamber : n 1 〈古、詩〉室，房間；寢室，臥室；〈pl 〉套房；〈pl 〉律師[法官]辦公室。2 會議室，會場；議會，...
  1. M111 test method for evaluating gasoline detergent in use part 6 : engine dynamometer test method for influence of intake valve and combustion chamber deposit tendencies of gasoline detergent m111 method

    評價汽油清凈劑使用效果的試驗方法第6部分:汽油清凈劑對汽油機進氣閥和燃燒室沉積物生成傾向影響的發動機臺架試驗方法
  2. Ford 2. 3l test method for evaluating gasoline detergent in use part 5 : engine dynamometer test method for influence of intake valve and combustion chamber deposit tendencies of gasoline detergent ford 2. 3l method

    評價汽油清凈劑使用效果的試驗方法第5部分:汽油清凈劑對汽油機進氣閥和燃燒室沉積物生成傾向影響的發動機臺架試驗方法
  3. Results show that all the geometric parameters have remarkable effects on combustion performance ; the swirl of intake air generated by skew intake holes enhances fuel - air mixing, minimizes dead zone and stabilizes the flame with reverse flow, but the excessive reverse flow can cause overheat in combustion chamber and exhaust ; the consistency of flow resistance in intake and exhaust system is conducive to the stability of heater performance

    研究表明，燃燒室進氣孔的孔徑、孔數、孔的分佈及方向等均對燃燒性能影響很大；斜孔所產生的旋轉進氣，雖具有強化燃氣混合、消除死區和迴流穩焰的作用，但迴流過度會使燃燒室及排溫過高；保證進排氣系統流動阻力（壓力）的一致性，有助於保證加熱器性能穩定。
  4. The piston moves up and down in the piston chamber primarily in response to changes in intake manifold vacuum.

    活塞主要因進氣歧管真空度的變化而在活塞腔內上下移動。
  5. Finally, the inlet port and combustion chamber designed and machined is tested on 4100qb. the paper mostly investigates the change of performance targets of the engine that three different grooved chambers including two different re - entrant model and one w model match with various intake port and nozzles, in order to realize the influence of chamber geometry on combustion process. the results analyzed have indicated that re - entrant grooved chambers can enhance the turbulent intension in the chamber, improve the combustion proces of diesel engine on the altiplano, being groove, re - entrant and convex, and have the farther developing potential

    著重研究兩種縮口、一種直口矩形環槽燃燒室與不同進氣道、噴油嘴的組合方案發動機的動力性、經濟性及排放指標的變化，確定燃燒室的幾何形狀對燃燒過程的影響。分析結果表明，由於有矩形環槽、燃燒室縮口以及燃燒室底部凸臺，縮口矩形環槽燃燒室中的紊流得以加強，改善了高原柴油機的燃燒過程，這種燃燒室有進一步發展的潛力。
  6. For the sake of realizing compressive ignition of single fueled natural gas and aiming at the characteristics of high spontaneous combustion temperature of natural gas, the separated combustion chamber provided with low heat radiation structure was designed, meanwhile the heating device for the intake pipe air and the ceramic electro - thermal plug heating device inside the separation chamber were set up

    摘要為實現單一燃料天然氣的壓燃著火，針對天然氣自燃溫度高的特點，設計了具有低散熱結構的分隔式燃燒室，同時設置了進氣管空氣加熱裝置和分隔室內陶瓷電熱塞加熱裝置。
  7. An experimental study is carried out on the effect of following factors on the combustion performance of a vehicle fuel heater : geometric parameters ( the number, diameter, distribution and direction of combustion chamber intake holes ) and intake and exhaust pressures

    摘要對車用燃油加熱器燃燒室進氣孔徑（流通面積） 、孔的分佈、孔的方向等幾何參數和進排氣壓力對加熱器燃燒性能的影響進行了試驗研究。
  8. The passage dimension of separation chamber, the heating temperature of intake pipe air and the relevant influence of the ceramic heat insulation coating of combustion chamber upon the compressive ignition process of natural gas were studied by experiment

    實驗研究了分隔室通道尺寸、進氣管空氣加熱溫度、燃燒室陶瓷隔熱塗層對天然氣壓燃著火過程的相關影響。
  9. The disposal of the valves and intake manifold structure not only affect fresh air charge but airflow in the cylinder, which immediately affect combustion efficiency and the performance of dynamic, economic and emission. the structure of the air distributing institution has influence on charging efficiency and the noise of engine. the combustion chamber affects compression scale which has great influence on dynamical performance ; f / v which affects the exhaust of hc ; squash area and clearance which have great influence on the intensity of squash

    氣缸蓋的氣門排列方式與氣道結構形式影響進氣充量和氣流在氣缸內的運動，從而影響了燃燒效率，對整機的動力性、經濟性以及排放都有直接的影響；配氣機構的形式影響充氣系數和整機噪聲等；缸蓋燃燒室決定了影響整機動力性能的壓縮比，影響hc排放的f / v和對擠流起決定性作用的擠氣面積以及擠氣間隙，所以燃燒室對整機動力性、經濟性、排放等都有重要的影響；氣缸蓋是整機熱負荷與熱應力最大的部件之一，熱負荷過高將不利於發動機壽命以及可靠性的提高。
  10. In order to improve performance of truck diesel engine, we can from intake system, fuel injection system and combustion chamber geometry three aspects to commence

    提高車用自然吸氣直噴式柴油機的性能，可以從進氣系統，噴油系統以及燃燒室形狀等三個方面入手。
  11. The engine emissions are decreased effectively and can meet the euro i emission standard by making intake vortex ratio and combustible chamber shape better, delaying injection timing, speeding fuel injection spray in combination with other optimization

    通過改善進氣渦流比、改進燃燒室形狀、延遲供油定時、提高供油速率等改進措施，並進行優化匹配，降低了各項柴油機的排放，使該機型達到歐i排放標準。
分享友人
分享到 Line

分享到臉書