interfacial resistance 中文意思是什麼
interfacial resistance
解釋
界面間阻力- interfacial : adj. 1. 界面的，面際的。2. 界面角的。
- resistance : n. 1. 抵抗，反抗，抗拒，抵禦；敵對，抵抗力，反抗力，阻力，【生物學】抗病性。2. 【電學】電阻；阻抗；電阻器。
-
Itr ( interfacial thermal resistance ) has been one of the important problems to be resolved in many fields such as avigation, spaceflight, biomedicine, energy, mechanism and low tc superconductor
界面熱阻是航空、航天、生物醫學、能源、機械、低溫超導領域中關註解決的重要問題之一。 -
It set up the development of the world recognized high performance nanofiltration composite membrane of aromatic polyamide, on the basis of reviewing the development, the importance in the membrane separation technology, the classification, the fabrication technique and the current development of the research and the application of the nanofiltration membrane. polysulfone was chosen as the material for making the porous substrate because of its excellent compress - to - denseness resistance, its cheap price and its great availability. by fabricating an ultra thin polyamide functional layer on the polysulfone substrate through interfacial polymerization taking piperazine as the monomer in aqueous phase and trimesoyl chloride as the monomer in organic phase, high performance nanofiltration composite membranes of ultra low pressure and ultra high permeating flux were prepared
選擇耐壓密性能優良，價廉易得的聚碸材料為制備復合膜基膜材料，哌嗪為水相單體，均苯三甲酰氯為有機相單體，通過界面聚合反應在基膜表面形成超薄功能層，制備了超低壓高通量聚哌嗪均苯三甲酰胺聚碸納濾復合膜，以0 . 1 mgso _ 4溶液為測試液，所得高脫鹽平板復合膜（ ）在0 . 4mpa下，脫鹽率為96 . 1 ，通量達85 . 2l -
Generally, the membrane thickness is much larger than the pore dimension. therefore, the resistance of the pore channel was the control resistance of the membrane diffusion process. while the existences of the stephen diffusion and pore interaction well explained the reason why the total membrane surface would be used as the interfacial area through where the mass transport took place
盡管由於膜的厚度比孔的尺寸要大很多， stephen擴散以及孔之間的相互作用對通過膜的總擴散阻力影響很小，但它們存在的結果是使整個膜表面的氣體濃度趨於一致。 -
Bending strength, compressive strength, interfacial bond strength and frost - resistance are also studied and analyzed. based on indoor research, on - site experiments are conducted on damaged pavement to inspect the performance of repairing concrete
在室內試驗研究的基礎上，進行了破損路面的工程修補試驗，對修補混凝土的修補效果進行了觀測。 -
The theory of interface of two - phase fluid id used to analyze the role of the interfacial heat transfer resistance in cond ensation process, it shows that the interfacial heat transfer resistance can not be ignored under such a vacuum condition, and the effect on heat transfer process becomes declined with the increasing of vapor pressure
應用兩相界面理論分析了汽液界面熱阻在水平管內低壓蒸汽冷凝過程中所起的作用，發現實驗范圍內汽液界面熱阻不可忽略，且其對冷凝傳熱過程的影響隨蒸汽壓力的增大而減弱。 -
The effects of interfacial resistance, superheating, free convection due to both temperature and concentration gradients, mass diffusion and thermal diffusion, and variable properties in both the liquid and gas - vapor regions were considered
分析中，考慮了相間阻力、液膜波動、蒸汽過熱度、因溫度和濃度梯度引起的自然對流、質擴散和熱擴散以及物性的變化。 -
When sintered at 1050c, the wear resistance of the composites were better than that of the ferroalloy under both low and heavy load without oil lubrication. the wear resistance, hardness, and other mechanical properties of the composites with nickel coated sic were better than those of the composites with bare sic particles. however, when sintered at 1100c, interfacial reaction became so acute that the properties of the composites with nickel coated sic particles was worse than those of the composites with bare sic particles
試驗結果表明：與鐵合金相比，在1050時燒結時，加入適量的sic后，耐磨性有較大的提高；而且加入鍍鎳sic的復合材料的耐磨性、硬度和拉伸強度等力學性能比加入相同含量的未鍍sic的材料的性能要好；在1100燒結時，由於界面反應的加劇，含有鍍鎳sic材料的性能反而比含有未鍍sic材料的性能差。
分享友人