inverter circuit 中文意思是什麼

inverter circuit 解釋
反相電路
  • inverter : n. 【電學】1. 換流器；倒相器，倒換器。2. 變換電路。3. 反相旋轉換流器。
  • circuit : n 1 （某一范圍的）周邊一圈；巡迴，周遊；巡迴路線[區域]；迂路。2 巡迴審判（區）；巡迴律師會。3 【...
  1. The load character and control object for a parallel inverter is analyzed, the conclusion that series and parallel resonant circuit are two antithetic circuits is pointed out, this provides a theoretical guide to the control circuit design for these two inverters

    分析了並聯諧振逆變器的負載特性及控制目標，指出串並聯諧振逆變電路是兩種對偶電路，為這兩種逆變器控制電路的設計提供了理論指導。
  2. This paper proposes a soft - swiching inverter based on mrac and analyzes the design of main circuit drive circuit and control circuit in details

    提出了一種基於模型參考自適應控制的軟開關逆變器，詳細分析了主電路、驅動電路和控制電路的設計。
  3. In this paper, a kind of output current feed - forward circuit is added into the input of the current loop. by adding this compensatory circuit, the output character of the inverter is improved greatly

    本文還研究了一種提高逆變器輸出電壓外特性的思路，通過將負載電流正反饋給逆變器的電流環輸入端，從而達到提高輸出電壓的外特性的目的。
  4. In the realization of the inverter control circuit, the frequency self - following system with optimal dead time based on dsp is researched

    在逆變控制電路的實現中，研究了基於dsp的具有最佳死區的頻率跟隨控制系統。
  5. A circuit topology of the inverter with duty cycle extended active clamp forward style high frequency pulse dc link is adopted by each independent inverter. each inverter is cascaded by a circuit with duty cycle extended active clamp forward style high frequency pulse dc link and a dc / ac inverting bridge. the control strategy of voltage mode pwm forwardback is adopted by the former, and the control strategy of three - state discrete pulse modulation ( dpm ) hystersis current is adopted by the later

    每個獨立的航空靜止變流器採用占空比擴展有源箝位正激式高頻脈沖直流環節電路拓撲，由占空比擴展有源箝位正激式高頻脈沖直流環節電路與dc ac逆變橋級聯而成，前級採用電壓型pwm前饋控制技術，后級採用三態dpm電流滯環控制技術。
  6. Apply computer chip to control the circuit ; omron opto - elecrtonic control - ler and panasonic and mitsubishi inverter have stable performance, high precision, rapid reaction and long life - span ; the controlling plate applies tactile operation board which is handled easily ; vertical structural screen is easy to adjust the vertical printing pressure so as to ensure the quality of printing ; the frame lift is driven by electrical motor and installed with imported linear guide rails, of which the speed - adjust device, scraper and scraping blade can be adjusted within15 to 45 and can be set for many times so as to repeatedly printing with good precision and output, the flat bed is made of 2mm stain - less steel plates which are flat, smooth and indeformable ; it is also equiped with micromatic setting device in order to ensure the precision of multi - color overprint and auto air - intake device to ensure strong adsorption

    採用電腦板控制電路，歐姆龍光電控制器，松下，三菱變頻器，行直穩定.精度高，反應快，壽命長，控制面板採用觸摸式操作面板，操作方便，六式結構型網版垂直升降印刷壓力可調保證印刷質量，機架升降採用電機驅動安裝進口直線導軌，刮刀、回墨刀可在15一45角調整，可設置多次，重復印刷保證產品精度.平臺板採用2毫米不銹鋼板製作，平整光滑不變形配有微調裝置，確保多色套印精度，配自動吸氣裝置，確保強有力的吸附。
  7. The design of active power filter inverter circuit

    有源濾波裝置中逆變電路的設計
  8. Firstly. operation principle of induction heating is introduced and the actuality of the power supply for induction heating is summarized. then, the scheme of structure of the power supply is established : uncontrolled rectifier and buck chopper constitute dc circuit. in this part, operation principle of a kind of soft switching buck chopper is presented mainly and the conclusion that the power semiconductor devices operate in soft switching is also illustrated by analysing the operation principle of all stages ; series resonant inverter is selected as inverter circuit via comparing the advantage and shortcoming of parallel resonant and series resonant. moreover. the work principle of series resonant inverter is analysed and the calculating method of the best dead time is put forward as well

    文中首先介紹了感應加熱電源的工作原理並綜述了國內外的研究現狀。接下來分析並制定了電源主電路的構成方案：在對比幾種功率調節方式的基礎上選擇了不控整流加斬波調壓作為直流部分。在這部分里，重點研究了一種軟開關buck變換器，通過分析各階段的工作原理說明了開關器件如何工作在軟開關狀態；對于逆變器部分，在比較了串、並聯逆變器優缺點的基礎上選擇了串聯諧振逆變器，並詳細分析了串聯逆變器的工作原理，提出了最佳死區的計算方法。
  9. In this thesis, a clamp passive loseless snubber is put forward for igbt inverters after analysing the dissipation of hard switching and soft switching with snubber. then theoretical analysis and simulation are been take to prove the work of the snubber. and a real inverter circuit and its auxiliary circuits are built

    本文在對igbt在硬開關和有緩沖電路的軟開關情況下的開關損耗進行分析之後，提出一種適用於igbt逆變橋的鉗位式無源無損緩沖電路，然後進行了理論分析和模擬分析，並製作了實驗電路和相關輔助電路。
  10. At the same time, the control circuit must realize power regulating of the rectifying circuit and the inverter circuit and keep some parameters impervious to the interferer. this paper has researched high frequency solid induction heating power supply

    同時，控制電路必須對整流電路、逆變電路等系統主電路部分進行功率控制，使在各種擾動下維持系統各參量不偏離其設定值。
  11. The study has completed the design of two - phase inverter and made up of the two - phase inverter - motor system for experimental use it is a variable frequency adjustable speed system with a open - loop control of rotational speed, which consists of voltage - controlled oscillator circulating assign device inverter circuit and two - phase induction motor a accurate mathematical model is set based on the whole system, and simulator program of dynamic and steady condition is established, which is used to calculate the dynamic and steady performance by kron and symmetrical coordinate converter by simulator calculation and experimental research with specific parameter of the system, a comparison is made between predicted and experimental characteristics, experimental measurements are shown to compare closely with corresponding theoretical result it is compared with some variable frequency adjus table speed system comprising inverter and single - phase induction motor from the system efficiency torque pulsation and the effect of two - phase inverter capacitance based on the conclusion, harmonic cancellation pulse width modulation control of a two - phase inverter - fed induction - motor drive system is researched, which cancelled the low harmonic and improve the system performance

    通過對電機的kron變換和對稱分量變換，建立了系統較精確的數學模型，編制了系統動態及穩態運行的模擬計算程序分別計算系統的動態和穩態性能。通過對系統的具體參數進行了模擬運算和實驗研究，實驗和模擬結果進行比較，說明實驗和理論較為一致，並從系統效率、轉矩脈動及兩相逆變器電容的影響等方面與各種逆變器和單相異步電動機組成的變頻調速系統加以比較。在此基礎上，對兩相逆變器供電-異步電動機系統使用諧波抑制pwm控制進行了研究，由於減少了低次諧波，改善了系統性能。
  12. Finally it is explained how the inverter circuit and the digital control circuit are design

    最後給出了本文實驗所用的逆變器功率電路的設計和並聯控制數字電路的設計。
  13. There is a voltage inverter circuit provided by suzhou auo used to supplying working voltage for the ccfl ( cold cathode fluorescent lamp ) of lcd back light module

    同時，蘇州友達光電有限公司為液晶顯示模塊的ccfl （ coldcathodefluorescentlamp ）背光源提供一塊逆變器。
  14. A novel resonant pole zvt three - phase pwm inverter circuit for three - phase ac motor driving is presented. the proposed circuit has the feature of being more flexible with three inverter arms in zvt process. using only one resonant inductance, the inverter can not only reduce the power loss of inductance but also avoid possibility of unbalance in motor ' s three stator windings

    提出了一種針對三相交流電機驅動的新型諧振極零電壓過渡三相pwm逆變器電路，該電路中三個逆變橋臂的零電壓過渡更具有靈活性，僅使用一個諧振電感，既減少了電感損耗又防止了電機三相定子繞組可能存在的不平衡問題，並且諧振電感中殘余能量能夠回饋給電源；新型逆變器的輔助開關均工作在零電流開關條件下，並且控制邏輯簡單。
  15. On the basis of the characteristics of locomotive air - conditioner inverter, the inverter control system. including the inverter circuit configuration, working principle and control hardware & software, is designed to meet its application requirement

    摘要根據機車空調電源的特點，設計了滿足機車空調電源應用要求的逆變器控制系統。
  16. Through the combination of inverter circuit and pll circuit, the process of frequency - tracking is described, and the experimental waves can be reflected perfectly. this provides some experience for the designing and debugging of electrical source

    並將鎖相環路與主電路結合起來，觀察到頻率跟蹤的過程，很好的反映了實際波形，為今後該類電源裝置的設計調試提供了良好的前期準備。
  17. This dual - loop strategy is analysed completly and simulated. the implementation strategy is using digital and analogous hybrid control. the voltage loop is realized by dsp, and the inner - loop is realized by analogous circuit the design of cpld which simplified signal - phase cascade inverter circuit is also introduced in this paper

    根據控制方案設計了採用數模混合方案的控制電路，電壓外環採用dsp控制，實現輸出電壓有效值計算、 pi調解、輸出限幅等操作，電流內環採用模擬電路實現，並基於復雜可編程邏輯器件cpld設計了載波移相電路和死區產生電路，簡化控制電路。
  18. In order to supply adjustable voltage for the voltage inverter circuit, an output adjustable dc voltage stabilizer power supply circuit is designed

    該電源電路能將輸出的電壓值的大小用數碼管實時的顯示出來。
  19. The proposed driving circuit includes a low - pass filter circuit 、 feedback circuit 、 signal generated circuit 、 phase shifted circuit and power inverter circuit. a ti cooperation ' s dsp ( tms320lf2407a ) is chosen for the drive and control system based on the characteristics of usm, the interface circuit 、 each function ’ s flow chart and algorithm program are designed

    根據usm的特點，選取一款專用於電機控制的dsp晶元tms320lf2407a ，設計了硬體介面電路、各功能部分的流程圖及控制演算法程序，以ccs為編譯環境，進行電機整個控制系統的軟體編寫與調試。
  20. In order to get the real - time motor controller with wide speed scope, high precision and large ability, this paper has used the special digital signal processor ( dsp ) made in texas instrument for motor control to design and finish the speed adjustable motor controller, analyzed the control methods and discussed the application in the fields of position testing, drive and power inverter circuit, completed related hardware testing and tested its functions

    為了獲得調速范圍寬、精度要求高、功能強大的實時電機控制器，本論文選用了德儀公司生產的電機專用數字信號處理dsp晶元，完成了調速電機控制器的設計與製造。並在此基礎上分析了控制策略以及在位置檢測、驅動、主功率電路應用等方面展開了討論。完成了相關的硬體調試並在實際中加以檢驗。
分享友人
分享到 Line

分享到臉書