isothermal growth 中文意思是什麼

isothermal growth 解釋
等溫生長
  • isothermal : adj. 等溫的，等溫線的。 isothermal atmosphere 等溫大氣。n. 等溫線，恆溫線。 a reduced isothermal 對比等溫線。
  • growth : n. 1. 生長，成長，發育，發展。2. 栽培，培養。3. 生長物，產物；【醫學】瘤，贅生物。4. 【經濟學】（資本價值與收益的）預期增長。
  1. Numerical simulation of dendrite growth for binary alloy during non - isothermal solidification

    二元合金非等溫凝固枝晶生長的數值模擬
  2. Numerical simulation of non - isothermal dendritic growth of binary alloy using phase - field method

    二元合金非等溫凝固枝晶生長的相場法模擬
  3. In this paper, the course of isothermal crystallization kinetics of polymer in limited volume unit is simulated by use of the method of monte carlo. four factors influenting on the course of polymer in the limited volume unite isothermal crystallization are analyzed under the given conditions. the four factors are sample volume shrinkage, the change of the linear growth rate of entities g, the change of sample thickness and the change of the number of nuclei

    本文採用montecarlo方法研究了高聚物在有限體積元中的等溫結晶動力學過程，分析了在一定條件下，樣品體積收縮、晶體線生長速率變化、樣品厚度變化和晶核數目變化這四種因素對高聚物在有限體積元中的等溫結晶過程的影響。
  4. It was found that in the case of non - isothermal crystallization, the onset and maximum crystallization temperatures of the nylon 6 of the nanocomposites are increased, while the crystallinity and crystallization growth rate is reduced

    在非等溫條件下，尼龍6石墨納米薄片復合體系的結晶起始溫度以及最大結晶速率時的溫度均比純尼龍6有明顯的提高，但結晶度以及結晶速率卻出現下降。
  5. The first one was called one step process or isothermal deposition and annealing process. in this process, the ceo _ 2 layers were formed at high temperature and oxidative atmosphere and then annealed at the same temperature. the relationship between the growth parameters and the textured degree of ceo _ 2 thin film was systematically studied, and the optimal growth parameters were summaried

    採用等溫退火法（或稱「一步法」 ）沉積ceo _ 2 ，即:先在氧化性氣氛下直接反應生長ceo _ 2薄膜，再在與沉積溫度相同的溫度下對薄膜進行退火處理，系統研究了沉積溫度、退火時間、水蒸汽分壓對薄膜c軸織構程度的影響。
  6. The studies of crystallization kinetics of the composites indicated that isothermal and non - isothermal crystallization behaviors could be described by avrami equation, and the avrami exponents were between 2 and 3. so it could be concluded that the mode of crystallization growth was mainly three dimensions spherulity and two dimensions dish

    通過對復合材料結晶動力學研究表明：復合材料等溫及非等溫結晶行為均可用avrami方程來描述， avrami指數n約在2 3之間，從而推測體系中晶體生長方式以球晶三維和盤狀二維生長為主。
分享友人
分享到 Line

分享到臉書