jet injector 中文意思是什麼
jet injector
解釋
噴射注水器-
Combustion lights and gas lights ; injector jet pipes and air control screws
燃氣燈和煤氣燈.噴射器的噴射管和空氣調節螺釘 -
A reasonable position of driving nozzle helps to achieve the maximum material flow that also depends on other parameters such as backpressure, properties of conveyed material and driving gas. it is observed that, an increase of convergent section angle is harmful to the pneumatic conveying system, and also influences on the mass flow rate of conveyed material, the distribution of static pressures in injector and the pressure drops of conveying pipe. in addition, within a reasonable scope of air mass rate, increasing the driving jet velocity is more advantageous than enlarging the dimension of driving nozzle
試驗研究發現，氣體噴嘴位置對氣固噴射器的輸送能力影響最大，氣體噴嘴存在某一最佳位置，而這一最佳位置與背壓、輸送物料特性和輸送風特性相關聯；氣固噴射器的收縮角對其輸送能力、內部靜壓分佈和輸送管阻力特性均有適量影響，收縮角增大對整個輸送系統均不利；在適當的輸送風范圍內，提高氣體噴嘴出口速度比擴大氣體噴嘴尺寸更為有利，但氣體噴嘴出口速度過高會增加氣固噴射器和輸送管內的能量損耗，給輸送帶來不利的影響；系統背壓與氣固噴射器的氣體噴嘴出口速度的選取有關。 -
The influences of the inlet tube angle, backpressure and driving jet velocity on static pressure distribution in the gas - solid injector are calculated, and the effects of the inlet tube angle on particle bulk phase concentration and axial mean speed of particles in the gas - solid injector are analyzed firstly. the predicament caused by lack of measuring means on the particle velocity in experiments is solved
分析了收縮角、背壓和氣體噴嘴出口速度對氣固噴射器內靜壓分佈的影響，以及收縮角對氣固噴射器內固體顆粒體積濃度場和顆粒平均速度的影響，解決了噴射器內固體顆粒速度試驗測試手段缺乏的困境。 -
Planar laser induced fluorescence ( plif ) was used to study the spray / wall impinging in constant volume vessel. the experimental result show that when fuel spray impinging on the plane wall, wall jet was formed while fuel impinging on a plane wall with a bump, when the wall jet meet the bump, a secondary jet can be formed. some parameters affecting the secondary spray were studied, including bump height, the secondary impinging distance, impinging distance and injector parameters
對傳統燃燒室和bump燃燒室內燃油空氣混合過程進行了對比研究，發現燃油撞壁以後在傳統燃燒室壁面形成壁面射流，這一層燃油濃度很高，很難與空氣混合，而在bump燃燒室內，壁面射流遇到bump后，會在空間形成二次射流，二次射流進一步能快速與空氣充分混合。
分享友人