junction signal 中文意思是什麼

junction signal 解釋
樞紐信號
  • junction : n. 1. 接合,連接,連絡。2. 接合點,交叉點,(河流的)匯合處,(鐵道的)聯軌點。3. 【電學】中繼線。4. 【物理學】接頭,結。
  • signal : n 1 信號,暗號;信號器。2 動機,導火線 (for)。3 預兆,徵象。adj 1 暗號的,作信號用的。2 顯著的...
  1. At - grade signal controlled junction

    交通燈控制地面路口
  2. Overtaking. besides, this thesis also presents fuzzy - based multi - phase intelligent signal control strategy according to the deficiencies of present traffic signal control system and the research of fuzzy traffic signal control, this signal control strategy focuses on the single junction signal control problem, though imitating the ways of traffic police managing the traffic, it has the ability of intelligent phase changing and controlling in the light of the real traffic flow, the simulation result shows : in two - and multi - phase conditions, the average vehicle delay is reduced by 15 % and by 27 % compared with the general fuzzy control method

    此外,本文還根據目前交通信號控制方法的不足以及現有的運用模糊控制技術進行交通信號控制研究上的欠缺,提出了基於模糊控制的多相位智能擬人信號控制策略,該控制策略以單交叉口的信號控制為研究對象,通過模擬交通指揮者實際進行交通控制的特點,使控制系統能實時根據各相位車輛的多少進行信號的智能控制,模擬結果表明:與普通模糊交通信號控制方法相比,在兩相位與多相位的模式中可分別減小平均停車延誤平均15和27 。
  3. On the 10th of last month, a serious traffic accident occurred at a signal - controlled junction at sau mau ping road in kwun tong

    上月十日,觀塘秀茂坪道一個由交通燈控制的路口發生一宗嚴重交通意外。
  4. The preamplifier will drive a low impedance load without alteration in the signal, in fact it can be used as a current source driving a 0 impedance mixer junction without any distortion

    這個前級放大器能夠驅動一個低阻抗的負載而不會引起信號的變化,實際上它可以用作一個驅動零阻抗混合節點,而又不產生任何失真的電流源。
  5. As to the video signal, alarm signal, control signal, are all weak electricity signal, exceedingly easily be subjected to the jam, in case the power supply system does not steady, wave propag ation is greatly, the harmonic content of power source overtops, the veins wave factors are great unduly, and even power source equipment breakdown, outputting abnormal, will be about to affect the video signal image effect, and dependability cuts downs to the security and alarming system. we adopt fast fu lye ' s mutation rule - fft alternatives, by the way of carrying fft alternatives to the local junction circuit, regulated power supply, ups ' s power source, and switch power source, thereby diagnose every degree harmonious wave content of power souse, and abnormal coefficient, compared to the normal working situation. thereby diagnose out the working condition of the regulated power supply, ups ' s power source, and switch power source

    如果有供電系統不穩定、波動大,電源的諧波含量過高,紋波系數過大,乃至電源設備損壞、輸出異常等情況出現,將會嚴重影響視頻信號的圖像效果,大大降低防盜系統的穩定性和可靠性,我們採用快速傅利葉變換原理,即fft變換,通過對市電、穩壓電源、 ups電源、開關電源等的電壓信號進行fft變換,從而得出信號中各次諧波的含量及信號畸變系數,並將其與正常工況下的參數進行對比,從而進一步診斷出穩壓電源、 ups電源、開關電源等設備的運行狀況;組成監控系統的設備長期處于工作狀態,往往由於設備散熱條件不好、設備老化故障等原因導致設備表面溫度過高,從而影響設備的正常運行,降低設備的使用壽命。
  6. Figure 2. 9 road traffic accidents by junction type by traffic signal junction control by severity 2005

    2 . 11二零零五年按嚴重程度劃分的快速公路交通意外數字
  7. Figure 2. 9 road traffic accidents by junction type by traffic signal junction control by severity 2002

    9二零零二按路口類別,交通燈控制及意外嚴重程度劃分的道路交通意外數字
  8. Figure 2. 9 road traffic accidents by junction type by traffic signal junction control by severity 2004

    9二零零四年按路口類別,交通燈控制及意外嚴重程度劃分的道路交通意外數字
  9. Figure 2. 9 road traffic accidents by junction type by traffic signal junction control by severity 2000

    9二零零零年按路口類別,交通燈控制及意外嚴重程度劃分的道路交通意外數字
  10. This paper realized frequency modulation using the video signal to directly control the resonance loop ' s diode of the vco at the early stages, and then through using radio frequency bipolar junction transistor, designed a lc voltage controlled oscillator which was emulated by advance design system. in addition, it also implemented the design and debugged the hardware circuit

    本文第一次實驗採用視頻信號直接控制vco諧振迴路變容二極體的方式實現頻率調制,並且利用射頻雙極性晶體管( bjt )設計了一種lc壓控振蕩器,通過ads軟體進行了參數模擬,最後進行了硬體電路的製作和調試。
分享友人