laminate film 中文意思是什麼

laminate film 解釋
層合薄膜
  • laminate : vt 1 把(金屬等)輾壓成薄板。2 把…切[分]成薄片。 3 用薄片疊成。4 用薄板覆蓋。5 黏合(薄片)。vi ...
  • film : n 1 薄層,薄膜;薄霧,輕煙;細絲狀的東西。2 【攝影】感光乳劑,照相軟片,電影膠片;影片。3 〈 pl ...
  1. It can measure shell speed and crusting of film laminating by adopting fks - 1 tester of film laminating capacity ; the principle of this instrument is that it makes film laminate on heating plate and turns 90or 180 of heating plate for moving un - shell sand. and then it measures shell thickness and observes cocking condition of surface sand

    採用fks - 1型覆膜砂結殼性能測試儀可以觀測覆膜砂的結殼速度和起皮狀況,其原理是將覆膜砂撒在加熱板上,經過某一時間之後,將加熱板旋轉90或180移去未結殼的鬆散砂,然後測量結殼厚度,並觀察表層砂的翹起情況。
  2. The nonsepa series is a printing sheet - use over - laminate film that does not employ a release paper, thereby yielding a host of benefits including substantial saving in forestry resources, less work for the user, and a significant saving in storage space

    非?染,高度遮蔽形膠帶無離型紙系列產品,不使用離型紙的印刷用膠帶。具有大幅度節約森林資源和減少工業廢物,空間優化等多種優點。
  3. After mechanical and process properties testing, the results indicated that : ( 1 ) the film resin can make the properties good in climbing drum peer strength of sandwich constructions composite, the little effects of the film resin on other mechanical properties have been given ; ( 2 ) the sandwich composite has the better mechanical properties at central symmetry layer than asymmetric layer ; ( 3 ) through the study of the different pressure of the sandwich composite, the result is obtained that the edgewise properties increases, the flexural properties decreases with the pressure increase from 0. 2mpa to 0. 5mpa ; ( 4 ) at the sameness extend layer, the mechanical properties of the laminate is bigger than that of the honeycomb sandwich panel ; ( 5 ) through the studies on honeycomb sandwich plate delamination under three - point bending tests. it is found that the flexural strength decreases with the area of delamination increases

    研究表明: ( 1 )膠膜能明顯的提高蜂窩夾層結構的剝離性能,對其它性能的影響不大; ( 2 )對稱鋪層較非對稱鋪層的力學性能高; ( 3 )固化壓力由0 . 3mpa提高至0 . 5mpa時,蜂窩夾層結構的側壓強度提高,而彎曲強度和剪切剛度分別降低; ( 4 )蜂窩夾層結構中的面板較同樣材料鋪層的復合材料疊層板的力學性能低; ( 5 )蜂窩夾層結構的界面上有缺陷時,彎曲強度下降,且隨著缺陷面積增大,彎曲強度下降幅度增大。
分享友人