length bias 中文意思是什麼
length bias
解釋
病程長短偏倚-
Author analyzed the relationship between the length and the impurity concentration of drift region and thickness of buried oxide layer and thickness of soi and the charges of oxide layer and bias voltage of bulk and breakdown voltage and on - resistance by numerical simulation
採用數值模擬分析方法，深入研究了漂移區長度、漂移區濃度、埋氧層厚度、頂層硅厚度、氧化層電荷以及襯底偏壓對resurf效應、擊穿電壓和導通電阻的影響。 -
The influence of msfvw bandwidth on the diffraction efficiency is also considered. for the nonuniform bias magnetic field of u - type parabola profile, when the msw frequency is less than the cut - off frequency at the edge of mo film, the effective mo interaction length reduces. the edge cut - off frequency is determined by the maximum of the nonuniform field
對于拋物型分佈（開口向上）的偏置磁場，當激發靜磁波的rf頻率小於邊緣截止頻率時，磁光作用的有效長度減小（與靜磁波頻率有關） ;邊緣截止頻率由不均勻磁場的最大值決定，靜磁波的下限截止頻率由不均勻場的最小值確定。 -
In the simulation work, one 1. 5kw and one 18kw induction motors ? control system were simulated and two simplified control scheme were proposed. when developing the program in tms320f240 dsp, this paper solved two practical problems : the finite - length effect and dc bias effect. finally, sensorless control system based on adaptive filter theory are tested on the platform of 1. 5kw induction motor, the results show that the scheme ? performance is good
在模擬過程中，針對1 . 5kw和18kw異步電機進行了模擬，並在此基礎上提出兩種簡化控制方式；在tms320f240的具體編程過程中，分別對自適應濾波器的有限字長效應、直流偏置效應等非理想因素進行了修正和補償；最後，在1 . 5kw微型異步電機上進行了轉矩閉環無速度傳感器實驗，實驗結果表明了演算法完全可以達到預期的目標。 -
The simulated results show that we can improve the sensitivity by setting the optical bias at / 2, reducing the gap of electrode, increasing the overlap integral factor, reducing the insert lose, adopting suitable segmentation number, increasing the electrode length, increasing the optical power, reducing the wavelength and the relative intensity noise and reducing the receive bandwidth ; obtain the wider bandwidth utilizing reducing the electrode length and the capacitance of modulator, segmentation the electrode ; increase the dynamic range using lowering noise, increasing the optical power at the detector and lower optical bias
通過計算得知，使傳感器相位偏置為/ 2 ，減小電極間距，提高電光重疊因子，減小器件插入損耗，採用合適的分段數，增加電極長度，增大光功率，降低激光的波長，減小相對強度噪聲，減小接收帶寬，對提高靈敏度的效果是非常明顯的。而減小天線長度，降低調制器電容，電極分段，都可以獲取較大的帶寬。降低系統噪聲;增加到達探測器的光功率，採用較低的光學偏置，都可以增大線性動態范圍。 -
When it comes to modeling, i have explained my bias at length in the previous two articles : briefly, i believe that the most reasonable strategy is to view modeling as a continuous activity that starts with an open discussion in front of a whiteboard or a piece of paper in smaller offices and ends with the production of a w3c xml schema or a wsdl file
談到建模，前兩篇文章中我已經用了很大的篇幅介紹了我的觀點：簡而言之，我相信最合理的策略是把建模看作是一種連續的活動，從白板前的公開討論（或者小型辦公室中的一沓紙）開始，直到生產出w3c xml schema或者wsdl文件結束。
分享友人