light annealing 中文意思是什麼
light annealing
解釋
光亮退火-
Standard guide for in - service annealing of light - water cooled nuclear reactor vessels
輕水冷卻核反應堆容器在運轉中逐漸冷卻的標準指南 -
Xps showed that there were much chemical absorbing water on the ti _ ( 2 ) film surface which mainly existed in form of - oh, and the contents of - oh was increasing with the annealing temperature. hydrophilic property became better with the annealing temperature ; the essential relation between the changing of contact angle and light - induced - electrons and light - induced - cavities was studied in details. the photocatalysis of samples without heat treatment was very bad, but that of samples after heat treatment was much better
Xps的分析表明：試樣的表面含有大量的化學吸附水，主要以羥基的形式存在，隨著熱處理溫度的升高，吸附羥基的含量在增加；親水性能測試表明：隨著氧氣分壓的變化，其親水性能變化不大，隨著熱處理溫度的增加，試樣的親水性能在變好，並從理論上解釋了親水性能光照前後變化和光生電子?空穴對之間的本質關系。 -
To find the parameters of preparation and annealing process associated with the best electrochromic properties of these films, following researches and experiments were carried out : to compare the visible light transmittance of the colored state with bleaching state of the electrochromic films which were annealed at different temperatures and for different duration, to count the dynamic optical density change, and to test the i - v relations of these films " electrochromic cycles and their colored / bleaching response time
對經過不同熱處理溫度和不同熱處理持續時間得到的薄膜樣品的著色褪色可見光范圍內透射光譜的比較，計算薄膜動態光密度變化量的大小，測試薄膜著色褪色循環伏-安關系以及薄膜著色褪色響應時間的快慢，尋求到薄膜呈現最佳電致變色性能時所對應的制備參數與熱處理參數。 -
One is about of temperature - dependence of luminescence of eu3 + and tb3 + doped in oxide glass and nanocrystalline y2o3 ; the other is about of light - induced luminescent and structural change in nanocrystalline y2o3 : tb. the creative works are as follows : ( 1 ) euand tb doped nanocrystalline y2o3 with different sizes were prepared by combustion synthesis. dependences of particle size, crystallinity and fluorescence characteristic on ratio of gly / y ( no3 ) 3 and annealing temperature were studied
本文以變溫與光輻照為實驗方法研究了eu與tb摻雜y _ 2o _ 3納米晶及氧化物玻璃中發光性質隨溫度的變化關系和光誘導y _ 2o _ 3 ： tb納米晶發光性質及結構的改變過程，得到如下創新性研究成果： （ 1 ）用燃燒法制備了稀土摻雜y _ 2o _ 3納米晶，研究了甘氨酸與硝酸釔的反應比例（ g n ） 、退火條件對稀土摻雜y _ 2o _ 3納米晶顆粒尺寸、結晶狀況及發光特性的影響。 -
Carbon plasma immersion ion implantation ( piii ) into the porous silicon has been studied for the first time, and obtained intense blue light. the effect of annealing temperature on the luminescence has been investigated and results show that the luminescence intensity of sample reaches maximum after annealed at 4000c
首次研究了碳等離子體注入對多孔硅的改性，得到了強藍光發射，詳細研究了退火溫度對發光強度的影響，發現在400時達到最大值，並探討了相關的機理。 -
Based on the heating treatment control system of a spring steel - wire production line in a factory, hubei province, the paper deals with the design of fully automatically monitoring system across its manufacturing process. through research of parameters of temperature control during the period of heating, annealing and tempering in steel wire manufacturing process, the corresponding composite intelligence fuzzy controller is designed. in light with the way of fast heating, a composite intelligent fuzzy controller combined with on - off control & pi control is set up
本文以湖北某鋼絲繩廠彈簧鋼絲熱處理生產線控制系統為依託，論述了整個生產過程的監控系統的設計，通過對該類鋼絲生產中的快速加熱過程、退火、回火等過程中的溫度控制參數的研究，設計了相應的智能型復合模糊控制器，根據快速加熱過程的實現方式，對于快速反應的被控對象，給出了以模糊控制為基礎的結合開關控制、 pi控制的快速升溫，且不超調的一種智能型復合模糊控制器，對于退火、回火等工藝過程，採用電加熱方式，該類工藝過程作為控制對象屬于具有純滯后的大慣性系統，作者設計出模型預測自適應模糊控制器，並對所設計的控制器進行計算機模擬實驗，取得了滿意的效果。
分享友人