light transmittance 中文意思是什麼

light transmittance 解釋
光透射比
  • light : n 1 光，光線；光明，亮光 （opp darkness） Hang the picture in a good light 把那幅畫掛在能看清楚的...
  • transmittance : n. 1. 透射作用，透射過程。2. 【物理學】透射比〈率〉。
  1. Under the applied voltage of 2v, the duration of colored process and bleaching process of the semisolid - state smart window was 2s and 1. 5s respectively, which denoted rapid response velocities. researches on the glass / ito / wo3 / linbo3 / niox / au all solid - state smart window were referred to the effect of each film ' s thickness on the device ' s electrochromic properties. through the test of the visible light transmittance of the colored state and bleaching state of the device, it proved good electrochromic capabilities with the dynamic optical density changed between 0. 2 - 0. 5

    並在此基礎上繼續研究了glass ito wo _ 3 linbo _ 3 nio _ x au結構的全固態智能窗器件模型，對于各薄膜層厚度對于器件電致變色性能的影響做了初步的研究，測試了器件可見光范圍內的著色褪色透射光譜，光密度變化量在0 . 2 0 . 5范圍內，表明器件具有良好的電致變色性能。
  2. By the use of gelation - flow - casting method, the troubles caused by the structural characteristics of pvf resins were resolved, and the produced films met a bright foreground of application with super properties such as uv resistance, mechanical strength and light transmittance

    該工藝克服了聚氟乙烯自身結構特性給成型帶來的困難，得到的薄膜產品具有耐候性強、強度高、透光率大等優點，並有很好的應用前景。
  3. Determination of light transmittance, solar direct transmittance, total solar energy transmittance and ultraviolet transmittance for glass in building and related glazing factors

    可見光透射比太陽光直接透射比太陽能總透射比紫外線透射比及有關窗玻璃參數的測定
  4. Test method for visible light transmittance of fine ceramic thin films

    精細陶瓷薄膜的可視光透射率的試驗方法
  5. Compared with pure pmma, the thermal and mechanical properties of the nanocomposites are obviously improved at a very small amount of mmt ( ommt ) loading. the tgs of the composites via different methods are improved by 10 ~ 26 ?, the decomposition temperatures at weight loss of 5wt % are increased by 42 ~ 99 ?. in the bulk system, tensile strength, tensile modulus and impact strength are improved by 32. 2 %, 60. 3 % and 68. 6 %, respectively, without the loss of light transmittance

    相對于純pmma體系，懸浮法、乳液法及本體法復合材料的t _ g值提高了10 26 ；后兩種復合材料熱失重5wt的溫度提高了42 99 ；而本體法復合材料的拉伸強度、拉伸模量及沖擊強度值最大分別提高了32 . 2 、 60 . 3和68 . 6 ，而透光性能基本未受影響。
  6. To find the parameters of preparation and annealing process associated with the best electrochromic properties of these films, following researches and experiments were carried out : to compare the visible light transmittance of the colored state with bleaching state of the electrochromic films which were annealed at different temperatures and for different duration, to count the dynamic optical density change, and to test the i - v relations of these films " electrochromic cycles and their colored / bleaching response time

    對經過不同熱處理溫度和不同熱處理持續時間得到的薄膜樣品的著色褪色可見光范圍內透射光譜的比較，計算薄膜動態光密度變化量的大小，測試薄膜著色褪色循環伏-安關系以及薄膜著色褪色響應時間的快慢，尋求到薄膜呈現最佳電致變色性能時所對應的制備參數與熱處理參數。
  7. The mechanical property, light transmittance of ion exchange strengthened solar cell cover glass and the effect of ion beam bombardment on its properties are investigated by dynamic mechanical analyser ( dma ), microscope, sem, uv / visible spectrophotometer and micro hardness instrument respectively

    摘要系統研究了太陽能電池蓋片玻璃經離于交換增強（化學鋼化）后的機械性能、透光率以及離子束轟擊對蓋片性能的影響。
  8. The damage and the decrement of light transmittance of ion exchange strengthened cover glass arc much lower than that of as - received one after ion beam bombardment, which demonstrates that ion exchanged solar cell cover glass has better resistance to ion beam bombardment

    結果表明，經離子交換增強后的蓋片玻璃，彎曲強度最大可以提高約4倍；且在受到離子束轟擊時的損傷以及透光率下降的程度都小於原片玻璃，說明化學鋼化玻璃具有較好的耐離子束轟擊的能力。
  9. Heat mirror insulating glass may use spectral selective film at various visible light transmittance, to satisfy different design requirement of natural lighting and solar heat rejection

    熱鏡中空玻璃產品可以運用各種可見光透過率的光譜選擇性反射薄膜，以滿足不同的採光和陽光遮蔽設計要求。
  10. Heat mirror ? insulating glass may use spectral selective film at various visible light transmittance, to satisfy different design requirement of natural lighting and solar heat rejection

    熱鏡中空玻璃產品可以運用各種可見光透過率的光譜選擇性反射薄膜，以滿足不同的採光和陽光遮蔽設計要求。
  11. Solar protection devices combined with glazing - calculation of solar and light transmittance - simplified method

    與門窗玻璃組合在一起的日光防護裝置.太陽光傳輸率的計算.簡化法
  12. Solar protection devices combined with glazing - calculation of solar and light transmittance - part 1 : simplified method

    裝有玻璃窗的遮陽設備.日光和光的透射率計算.第1部分:簡化法
  13. Solar protection devices combined with glazing - calculation of solar and light transmittance - part 1 : simplified method ; german version en 13363 - 1 : 2003

    裝有玻璃窗的遮陽設備.日光和光的透射率的計算.第1部
  14. Solar protection devices combined with glazing - calculation of total solar energy transmittance and light transmittance - part 2 : detailed calculation method

    裝有玻璃窗的遮陽設備.太陽能和光的透射率總量計算.第2部分:詳細的計算方法
  15. Solar protection devices combined with glazing - calculation of total solar energy transmittance and light transmittance - part 2 : detailed calculation method ; german version en 13363 - 2 : 2005

    裝有玻璃窗的遮陽設備.太陽能和光的透射率總量計算
  16. Sio2 optical anti - reflective thin films with micropores were prepared with esam method. the optical properties of pdda / sio2 complex films against the changes in temperature in the processof heat treatment were studied. after heat treated at 520 c, the light transmittance at certain wavelengths of the thin improved greatly. the chemical bond structures of the optical thin films was studied with ft - ir, and surface analysis of the thin films was carried out using xps and their anti - scratching performances were studied

    用esam法制備了sio _ 2多孔光學增透薄膜，研究了pdda sio _ 2納米復合薄膜在熱處理過程中光學性能隨溫度的變化規律，發現520熱處理后一定波長下的光透過率大大增強；用ft - ir研究了熱處理后的薄膜的組成，用xps進行了表面分析，研究了薄膜的耐機械擦傷強度，發現1 ~ #薄膜的耐機械擦傷強度較小，甚至小於相應的pdda sio _ 2納米復合薄膜的耐機械擦傷強度，而2 ~ #薄膜的耐機械擦傷強度則大大增強，即使用刀片平刮也只略有損傷。
  17. Carbon black for rubber industry - secondary characteristics - part 4 : determination of light transmittance of toluene extract

    橡膠業用炭黑.二級特徵.第4部分:甲苯提取物的光傳遞率的測定
  18. At all level of visible light transmittance, the high performance ultraviolet absorbing substrate of heat mirror ? can shield over 99. 5 % harmful ultraviolet outside

    熱鏡中空玻璃產品可以選擇各種可見光透過率的光譜選擇性反射薄膜，薄膜中集成了高效紫外吸收劑，可以屏蔽99 . 5 %有害的紫外輻射入室。
  19. Excellent light transmittance

    導光率極佳
  20. When end product burning, the minimum light transmittance should not less than 30 %

    成品電纜燃燒時的最小率應不小於30 % 。
分享友人
分享到 Line

分享到臉書