line of load 中文意思是什麼

line of load 解釋
荷載曲線
  • line : n 1 線；繩索；釣絲；測深度用繩，捲尺。 a fishing line 釣魚線。 be clever with rod and line 會釣魚...
  • of : OF ＝Old French 古法語。
  • load : n 1 裝載，擔子；負擔；工作（負荷）量。2 （車船等的）裝載量；一馱，一車，一飛機。3 【電、機】（機...
  1. On the basis of remote sensing technique ' s good characteristic with large - area, multi - time, multi - photograph variety, manifold abundant spectral information and high ground resolution, the fault tectonics frame, river geomorphy ( such as terrace, floodplain, shoal, etc ) and suspended load, etc. were explained after analyzed the fault tectonics, river geomorphy, characteristic in the tm image by gray bar statistics, primary component analyses, tm741 image integration, line convolve enhancement and model recognition etc. especially 9 piece of fault tectonics were explained in this thesis, in succession, the impacts of the factors severally were analyzed

    遙感技術具有大范圍、多時相、多片種、多層次、含有豐富的光譜信息及具有較高的地面解析度的特點。本文利用該技術，運用灰階統計特徵分析和主成分分析、 tm741多波段融合、線性卷積增強、模型提取等一系列遙感解譯分析方法，分析了斷裂構造、河流地貌（階地、漫灘、沙洲）及懸浮物等在tm遙感圖象上的影像特徵，解譯出了安徽南部斷裂構造格架、河流地貌和懸浮物的分佈，並新解譯出了9條近東西向的斷裂。
  2. In oilfield, feeder line of 6kv often has many branches. the pole high voltage automotive capacitor compensation system controlled by single chip computer is designed for this situation. in the system, we separate the measure position and compensation position and realize the supervision of reactive load in local area

    文章以油田6kv輸配電線路為例，針對多分支樹狀結構線路的特點，研製出由單片機系統控制的戶外術上型高壓電容器自動補償系統。
  3. Planning of assembly line production cycle time based on the balance of load

    基於負荷平衡的流水線生產節拍設計
  4. Maximum load factor of line

    線路最高滿載率
  5. The drawing of ac load line in amplificatory circuit

    放大電路交流負載線的作法
  6. Construct a static force analysis model by using ansys, so as to calculate the influence line of control internal force of all nodes, and draw a conclusion of the maximum value of control internal force of all nodes under the influence of live load and the bit shift value of internal force of other corresponding member bars, in order to offer correlative data for local node analysis

    利用ansys建立全橋靜力分析模型，計算各節點控制內力的影響線，得出活載作用下各節點控制內力最大值以及與其相對應其他各桿件的內力位移值，為局部節點分析提供相關數據。
  7. Tag line restrict swinging of load

    可限制負荷擺動弧度的牽線。
  8. The ability of power network maintaining its power supply reliability and quality is restricted by power network structure, line and load characteristics, generator drive device characteristics and relay protection mechanism

    電力網路維持其供電可靠性及電能質量的能力是受電網結構、線路和負荷特性、發電機動力設備特性以及繼電保護機制等因素影響的。
  9. Application of high - voltage explosion fuses is very abroad. in addition to protecting the electrical equipment by melting itself, disjunction or close of its tube can also be manipulated by a high - voltage insulative stick under some circumstance, for example, to switch on or off no - load overhead transmission line, no - load transformer and little burden current

    跌落式高壓熔斷器的應用極為廣泛，不僅能保護電氣裝置，在一定條件下還能直接用高壓絕緣鉤棒來操作熔管的分合，以斷開和接通空載的架空線路、小容量空載變壓器和小負荷電流。
  10. The theory and its calculated methods of tunnel section design is researched in this paper, including the foundation and methods of the choice of profile and line types, and value and distribution of load, and the common calculated methods of lining structure

    研究了水工隧洞斷面設計的理論及其計算方法，包括斷面選型和襯砌型式選擇的依據和方法，荷載的取值和分佈，襯砌結構常用計算方法的研究。
  11. The basic software consists of topology analysis, on - line load flow computation, state estimator, security analysis, dispatchers training simulator, short circuit current computation, and voltage / reactive power optimize, etc. the derived softwares consist of load control, capacitor optimizer configuration, transformer and feeder load distribution, impedance computation of generator, etc. network analysis software is powerful dispatch tool, though witch the current state of the power system can be realize, then improve the security and economic potential

    Dms網路分析的基本軟體有：網路結線分析、潮流計算、狀態估計、負荷預報、短路電流計算、電壓無功優化等。派生軟體有：負荷控制、電容器優化配置、變壓器與饋線負荷分配、電源阻抗計算等。網路分析軟體是有力的調度工具，通過它可以了解和掌握當前的運行狀態，從而挖掘安全和經濟方面的巨大潛力。
  12. This load cell is used wherever measurements are to be taken directly in the line of force

    這款測壓元件用於任何需要直接測力的地方。
  13. Influence of load models in sending and receiving ends of henan power grid on tie - line stability limit of sending end

    河南電網送端和受端負荷模型對穩定極限的影響
  14. Nonlinear constitutive relations are discussed for analyzing the stress distribution, the appearance and development of the cracks, as well as the behavior of the boundary conditions of the two way slabs respectively. in the light of the experimental research on r. c. two way slabs under static loading, the behavior of yield line, the load deformation curves and the crack yield, plastic limit loads of slabs with different supporting conditions are studied

    根據反映雙向板混凝土材料非勻質性的本構關系，分析了雙向板在荷載作用下的變形、屈服、裂縫和破壞的形態特性，並對鋼筋混凝土雙向板在不同支承條件下的塑性極限荷載、正常使用撓度（曲線）和截面設計作了進一步研究。
  15. This thesis discussed the affection of all kinds of components contingency and the components " position in the line and other factors on the evaluation of load point reliability index. this thesis adopts a integrative method to deal with simple or complex distribution network with the system ' s practical operation characteristics and the results of the example reveal that it is feasible. the key to study the economics of power system reliability is outage costs

    在定量評估負荷點或系統可靠性指標的研究中，本文較全面地分析了各元件故障和元件在線路中的位置以及計劃檢修、臨時停電、天氣因素、負荷轉移等因素對估算負荷點可靠性指標的影響；研究了現有的可靠性評估模型，結合城市電網的實際運行特點，採用一種綜合的方法估算輻射型電網的可靠性指標，算例結果表明它是有效可行的。
  16. But often what is not obvious when reading a manufacturer ' s data sheet is how the initial accuracy of the device is affected by other key device parameters such as line regulation, load regulation, initial voltage error, output voltage temperature coefficient ( tc ), output voltage noise, turn - on settling time, thermal hyste - resis, quiescent supply current, and long - term stability

    但，人們閱讀廠家的數據手冊時，因受諸如（電源電壓）線性調整率、負載調整率、初始電壓誤差、輸出電壓溫度系數tc 、熱遲滯（系數） 、靜態電流和長期穩定度等參數的影響而使初始精度往往不明顯。
  17. The sinusoidal voltage and current distribution on the line of each frequency component is obtained by the phasor equation for the transmission line and the source and load impedances

    將傳輸線上不同位置電壓及電流之頻譜以快速富氏反轉換即得傳輸線上不同位置之近似電壓及電流脈波。
  18. In view of load transferring capability of rock - socketed piles, this paper compares rock - socketed piles with non - rock - socketed piles, analyzes influencing factors ( pilelengtru pile diameter pilemodulusx character of bearing stratuiru mud hull sediment of pile bottom and roughness ) on force character. with different load transferring functions, a set of analytical equation for single pile settlement calculation of rock - socketed piles are established : three stages of p - s curve from analytical equation are gained which are straight linex curve x straight line ; and relationship curves in different pile modulus and in different rock - socketed length

    根據所選用的不同的荷載傳遞函數，導出了嵌巖樁單樁沉降計算的一種解析演算法，分析得出嵌巖樁p ? s曲線按荷載變化分為直線?曲線?直線段三個階段，不同樁身模量下承載力的變化曲線，樁身模量、樁端巖石強度是影響單樁承載力的重要因素，不同嵌巖深度下端阻比的變化曲線。
  19. The sequence to solve a overcurrent line of a feeder is : load transference to another feeder, reduction the reactive power and finally increase the section of the cable

    規劃一個饋線線路（設備）的一條過流主幹路的順序是：了解負荷轉移至另一個饋線線路（設備）過程中，將無功功率降低最終就要增加電纜。
  20. This article has discussed the control problem in a distribution substation and on the distribution line respectively. reactive power / voltage control in a substation using general approach usually results in the voltage of the second side being too close to the boundary. it will make the ability of enduring the variation of load in a system decrease a lot and become the threat of the system

    本文分別對配電系統中的變電站及配電線路的無功電壓優化控制問題進行了研究，採用常規方法進行變電站電壓無功控制時，往往使二次側電壓過于接近邊界而導致系統承受負荷波動的能力大大下降，成為系統安全運行的隱患。
分享友人
分享到 Line

分享到臉書