load absorption 中文意思是什麼

load absorption 解釋
承載能力
  • load : n 1 裝載，擔子；負擔；工作（負荷）量。2 （車船等的）裝載量；一馱，一車，一飛機。3 【電、機】（機...
  • absorption : n. 1. 吸收，合併。2. 專心，一心不亂，熱中 （in）。3. 〈口語〉飲食。
  1. With its important functions as load - bearing, shock absorption, stabilization, lubrication and congruency, the meniscus plays an important part in the complex biomechanics of the knee joint

    摘要半月板是膝關節的重要組成部分，它能吸收震蕩、增加關節面的接觸面積和潤滑關節，在傳遞載荷、穩定關節和防止關節退變等方面起著重要作用。
  2. It ' s high - frequence noise absorption, absorption of noise caused by rapid rise of front and self - reset function have widespread application in imput of supply, for absorption of inductive load switching surge voltage and for protection of two - way thyristor switching device, bypass capacitors, micro - machines and the others

    它所具有的吸收高頻噪聲、前沿快脈沖上升噪聲及自復位功能，使其在電源輸入端、吸收電感性負載開關浪涌電壓、保護雙向可控開關器件、旁路電容器、微型電機等方面有著廣泛的用途。
  3. In the text thermodynamics and heat transfer calculation of the no - pump libr absorption refrigeration were performed, and carried out the values of various state point, the heat load and the areas of each apparatus

    文中對無泵溴化鋰吸收式空調器進行了傳熱與熱力計算，給出了各個狀態點的參數和換熱面積。
  4. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  5. If the pipe needs shock absorption or shockproof, shockproof hanger or support should be selected. the load should be equal to the loading capacity and rigidity of the shockproof spring hanger or rubber hanger

    3管道需要減震防震時，應選用防震吊掛或支座，支承的荷載應與防震用彈簧或橡膠的支承能力和剛度相匹配。
  6. In order to study the seismic behavior of this structure system, three frames are designed and they are subjected under cyclic reversed lateral load. we mainly study the strength, stiffness, ductility, energy absorption capacity and failure causation in the test

    為了探討該新型結構的抗震性能，本文設計並製作了三榀框架，進行了水平低周反復荷載試驗，重點研究了方鋼管砼框架以及方鋼管砼支撐框架的強度、剛度、延性、耗能能力及破壞機制。
  7. The effect of different additives on the properties of water and oil absorption as well as the maximum load of wheat flour tableware was studied by using liquid paraffin and stearic acid as waterproof agents, sodium alginate and carboxymethyl cellulose sodium ( cmc - na ) as intensifier

    摘要以液態石蠟和硬脂酸作為防水劑，以海藻酸鈉和羧甲基纖維素鈉作為補強劑，研究不同添加劑對小麥粉餐具的吸水性、吸油性和最大承載等使用性能的影響。
  8. The force - time curves are then converted to force - displacement curves to calculate the energy associated with different impact phase. the results show that the maximum load of the composites with non plasma treatment filament is low and the absorption is also low in the initial crack phase

    通過對載荷?位移曲線進行積分，可得到不同試樣在沖擊過程中吸收的總能量、裂紋起始區吸收的引發能以及裂紋擴展區吸收的擴展能，從而分析界面粘結強度對材料能量吸收能力的影響。
分享友人
分享到 Line

分享到臉書