load change 中文意思是什麼
load change
解釋
負荷變動-
Engine load simulated control system was consisted of two unattached parts of work resistance simulated control subsystem and electric bow wave dynamometer control subsystem. with the mathematic models of engine load simulation controller, which transferred the work resistance ' s change to engine load change immediately, the system can met the need of the simulation control system
發動機負荷模擬加載控制系統包括彼此獨立的作業阻力模擬控制子系統和電渦流測功機控制子系統兩部分，應用發動機負荷模擬控制器數學模型，使作業阻力的變化及時轉換為發動機負荷的變化，能夠滿足模擬系統的控制要求。 -
Subsequently, a distributary may again change course to debouch its load near the mouth of its older, abandoned channel.
后來，分流可再次改變河道，把它的負荷沉積在原來廢棄的較老的河口附近。 -
From analyzing the change of effective stress in the process of one - direction to two - direction load, it is founded that the evanescing process of pore water pressure proposed in the paper shows a better agreement to fact
從對單向荷載作用時地基的有效應力變化過程分析入手，引伸到對雙向荷載作用時地基的有效應力變化過程分析，提出與實際情況更為符合的孔隙水壓力消散過程。 -
To each increment of load they respond with a definite change of stress and deformation.
對荷載的每個增量，應力的變形都有確定的變化。 -
The paper analyzes the non - lineal relations of the quantity of heat exchange and water flux of coil exchanger in part - load operating condition, the shortage of deciding the water flux in bypass pipe, the disadvantage that the operating condition of pumps and chiller ca n ' t be met with the load change of the air conditioning system in different operating condition of using pressure - difference bypassing control in primary water pump system. using load control method in the change of the operating condition of primary water pump system can realize that the load change is small and reasonable in the on / off condition of pumps and m m chiller by comparing load control method in primary variable - flow water pump system with pressure - difference bypassing control method, back water temperature control method
本論文從目前空調工程中使用的變流量水系統入手，研究了盤管換熱器在部分負荷下水流量與換熱量的非線性關系，分析了文獻中介紹的旁通管通流能力選擇的不足之處和一次泵水系統採用壓差旁通控制時，工況轉換不能滿足系統控制要求的缺陷；比較了一次泵變流量水系統中壓差旁通控製法、回水溫度控製法、負荷控製法的精確性，並得出了在一次泵水系統的工況轉換時，採用負荷控製法能使冷水機組及其相應水泵在啟停時的負荷變化范圍較小，更符合建築物的冷量需求，節能效果較好的結論。 -
Model dqzj ? 20y hydrodynamic drive drilling rig, provided with hydraulic gearbox, possesses soft transmission and high adaptability to the load change, and can realize stepless speed and torque regulation and inverse - rotation brake
20y液力傳動鉆機採用液力機械變速箱，傳動柔和，適應外載荷變化的能力強，可實現無級變速變矩及反轉制動。 -
The basic agc roles include : ( 1 ) making generation follow the load change, and holding system frequency on fix value ; ( 2 ) dispatching power to each area, and holding exchanging power on fix value between each area
其主要功能是響應負荷和發電的隨機變化，維持電力系統頻率為規定值，響應各區域分配系統發電功率，維持區域間凈交換功率為計劃值。 -
Talking about the application of small coal feeder in belt straight across load change point
淺談小型給煤機在膠帶機轉載點的應用 -
Since it is immune to load change, immune to the value of grounded resistance change and its parameters can be easily measured, the fault location algorithm can be widely applied to the power distribution networks
基於此論文還編制了單相接地故障定位的計算機通用程序。該測距演算法不受負載參數變化的影響，不受接地過渡電阻值大小的影響。 -
Step load change
負荷階躍 -
The results show that it is possible to convert the present constant system to variable system technologically. as the reason of the high fist - cost, the economic analysis should be made seriously before the conversion. the larger of the system and load change, the more benefits from the conversion will be gotten and the fewer return years will be required
研究表明，將我國目前運行的定水量系統改造為變水量系統在技術上是可行的，但一次投資較大，因此改造前應該進行認真的經濟分析，系統越大，負荷變化越大，改造為變水量系統所獲得的收益也越大，回收年也就越小。 -
The proportional flow valve control system with speed - electric feedback applied in hydraulic elevators can eliminate disturbances of nonlinear source such as oil temperature and load change. in this system, the proportional valve plays a key role
採用轎廂速度一電大閉環反饋控制方法的電液比例閥控系統，可以排除油溫及負載變化等因素引起的非線性干擾，極大地提高了液壓電梯的工作性能。 -
First, n - degree of freedom robotic manipulator control problem is studied. on the basis of computed torque ( ct ), the uncertainty is learned by the neural network, and the output of the neural network is used as compensator. this approach overcome the deterioration of control performance due to the uncertainties including working circumstance and load change
針對計算力矩法對模型誤差敏感，魯棒性差的特點，文中將神經網路和計算力矩方法結合，首先根據標稱模型設計計算力矩控制器，然後採用神經網路來學習系統中的不確定性，神經網路的輸出作為補償控制器：有效的克服了機械手由於工作環境和負載變化等不確定性引起的控製品質的破壞。 -
In order to connect them and to let them dynamic response, mathematic models of engine load simulation controller were established, which transfer the work resistance ' s change to engine load change immediately, to meet the simulation control system
為了使它們有機地聯接、動態響應，本文建立了發動機負荷模擬控制器數學模型，使作業阻力的變化及時轉換為發動機負荷的變化，滿足了模擬系統的控制要求。 -
Sudden load change test
突變負荷試驗 -
However, due to the supplying air volume change corresponding to cooling or heating load change, such phenomena as uneven temperature and velocity distribution often take place, which lead to bad indoor air distribution and thermo - environment
然而在變風量空調室內，因為送風量隨著室內負荷的變化而變化，經常存在溫度和速度分佈不均勻現象，導致室內不良的氣流組織和不舒適的熱環境。 -
The contactless hall effect - based measuring principle gives the pressure switch extremely good repeatability and longevity, even with extremely high load change frequencies. the adjusting screws allow the switching points of the magswitch
符合無觸點霍耳效應測量原理使得這種壓力開關即使在極高負載變化頻率條件下也具有卓越的可重復性和壽命。 -
Reactive power optimization considered load change and based on improved genetic algorithm is applied to fujian province auto voltage control system, and the corresponding software is programmed
把考慮負荷變化和基於改進遺傳演算法的無功優化，編製成相應的無功優化計算軟體，應用於福建省網自動電壓控制系統中。 -
In some place of electric system, the load change wide range and the existing current transformers ca n ' t meet the measure request. on the base of consulting a great amount of materials, a deep research on wide range current transformer by active compensation was done in this paper
本文對電流互感器進行了深入研究，查閱了大量相關資料，針對目前電力系統中某些負荷點變化范圍較大，現有互感器不能滿足計量要求的情況，進行寬量程電流互感器有源補償方法的研究。 -
Less than 75 s for the output to recover to within 75 mv of nominal value following a load change within specifications
小於75 s輸出至恢復至75 mv額定值載入的變更范圍內規格
分享友人