load flow calculation 中文意思是什麼

load flow calculation 解釋
潮療算
  • load : n 1 裝載，擔子；負擔；工作（負荷）量。2 （車船等的）裝載量；一馱，一車，一飛機。3 【電、機】（機...
  • flow : vi 1 流，流動。2 （血液等）流通，循環。3 流過；川流不息；（時間）飛逝；（言語等）流暢。4 （衣服、...
  • calculation : n. 1. 計算，計演算法。2. 推定，預測。3. 深思熟慮，精打細算；慎重的計劃；算計。
  1. Through calculation and dynamic adjustment of the distribution factor for every power plant and tie line, more accurate load flow change can be obtained

    通過計算並動態調整各個調節電廠和聯絡線的調節分配因子，得到比單個鬆弛節點計算時更加實際的潮流變化。
  2. It is also pointed out that the shear stress along the flow - in direction existing near the junction of straight and curve edges is one of the major components of drawing pressure, and it is very important in the calculation of drawing load of non rotational symetrical drawing

    並且指出，法蘭直、曲邊交界附近存在的流入方向剪切力是拉深力的主要成分之一，在非回轉對稱拉深載荷的計算中非常重要。
  3. This temperature calculation method avoids the non - correspondence between the flow rate and heat flux, which may exists in that used by boiler manufactures, and was employed to calculate the tube temperature of dangerous position that concerns with the retrofit scheme of superheater 1 of tower type coal - fired 330 mw once - through boiler in pucheng power plant for 100 % and 50 % operation load

    針對蒲城電廠330mw塔式燃煤直流鍋爐1號過熱器的改造方案，利用本文提出的方法與電廠鍋爐常用的壁溫計算方法分別計算了100 %與50 %鍋爐運行負荷下危險部位的壁溫。
  4. 2. cluster of workstation ( cow ) has been established as a parallel computing platform. 3. a parallel computing program of two - dimension flow numerical calculation has been completed. some important techniques such as communication among nodes and load balancing are analyzed

    （ 2 ）利用以太網來連接一組微機，以linux操作系統和消息傳遞介面（ messagepassinginterface ， mpi ）為并行程序開發環境，建立了集群式的并行計算系統。
  5. Presently most of the theoretical method to predict the propeller - induced hull pressure fluctuation is based on the calculation method in which the pressure is induced by pulsating source in infinite flow. the calculation method is adopted and the corresponded computer program is complied. the propeller - induced hull pressure fluctuation due to blade thickness, blade load, cavity thickness and the change of the cavity volume can be analyzed respectively in the computer program

    目前，螺旋槳誘導的船體表面脈動壓力的理論預報方法，大多是以無限流場中點脈動源誘導的周圍流場的脈動壓力的計算方法為基礎的，本文採用該方法編制了計算程序，可以分別考慮槳葉厚度、槳葉負荷、槳葉上空泡厚度及其體積變化在船體表面指定位置上產生的脈動壓力。
  6. For the research requirement of the high g - load mobile missile srm, the work process of solid rocket motor under lateral overload is investigated by the use of theoretical analysis and numerical simulation methods involving the calculation of internal ballistics, the simulation of flow field and the analysis of structural integrity

    本文以高速機動防空導彈固體發動機研製需求為背景，採用理論分析和數值模擬方法，從內彈道計算、內流場模擬、結構完整性分析等幾個方面對橫向過載作用下固體火箭發動機工作過程進行了研究。
  7. According to the characteristic of the distribution network, based on thenewton - raphson method, used the object - oriented thought, bring forward an unite load node method for power flow calculation, and making a improvement of the node number method which is suitable for newton - raphson method, obtained a rapid convergence calculation method for power flow calculation

    根據配電網的特點，基於牛頓?拉夫遜法運用面向對象的思想，提出了負荷節點合併的潮流計算方法，並引入了改進的，適合於牛頓拉夫遜法的節點編號方案，得到了一個快速收斂的潮流演算法。
  8. On the base of the fujian power system that has the special configuration of " large power generator with small power system " in 2000, constructs power system models of fujian and fujian interconnected with other parts, does a lot of calculation and analysis and simulation, researches the security mechanism and rule of the fujian special power system interconnected with large power system. the above connection can keep security and stability and can make obvious benefits, but when the transmission power reach to excessive quantity the main power grid will increases interconnected flow - in or flow - out exchange power load. the power operation state tended to instability ; the infirmable interconnection make s the damp infirmable

    本文以2000年前後具有「大機組小電網」特殊結構的福建電力系統為背景，建立了福建電力系統及其與外部互聯的數學模型，開展大量的模擬計算分析，研究了「大帆組小電網」電力系統與大容量電力系統互聯偏弱的安全穩定性的機理和規律：前述互聯可以安全穩定運行，取得顯著效益，當傳輸功率達到一定量后，主網架增加了送出或吸收互聯交換功率的負載，系統運行狀態向穩定性水平有所下降的方向轉移；聯絡偏弱使阻尼偏弱，聯絡線小幅低頻振蕩和大幅低頻振蕩易被激發，聯絡線一旦重載斷開，系統高周或低調嚴重。
  9. The content including : ( 1 ) according to the radial structure and multilayer characteristic of distribution network, a novel layer - by - layer backward / forward sweep method id developed. the branch power / voltage loss of the same layer can be parallel computed without relabeling buses and branches, that greatly increases the speed of load flow calculation

    其主要內容如下： （ 1 ）針對配電網路的樹狀結構和層次特性，研究了一種新穎的分層前推回代潮流演算法，該演算法不需要網路節點和支路的特殊編號，可以并行計算同一層次所有支路的功率損耗和電壓損耗，從而大幅度提高了潮流的計算速度。
  10. A hybrid algorithm for distribution power system load flow calculation

    一種配電網潮流計算混合演算法
  11. The study is very important for electric power system economic operation. load flow calculation is the basis of distribution power network analysis

    因此，研究配電網的優化運行方法，對提高配電網運行的經濟性具有重大意義。
  12. Therefore the traditional load flow calculation methods will fail to solve the distribution power networks. to compensate the defects, a new concise method is proposed to determine the current distributions in distribution power networks

    為此，本文給出了一種簡明近似的配電網電流分佈計算方法，同時很好地解決了配電網損耗的理論計算問題。
  13. As the essential electrical calculation means, load flow calculation provides important basis for power systems operation and studies, and is indispensable to advanced power systems application software. in this thesis, the development of methods for load flow solution of distribution networks at present have been fully analyzed and evaluated in the aspect of convergence. the algorithm for distribution power systems base on the complex matrix was proposed in this paper, the proposed methods is very efficient and required less computer memory storage observably

    潮流計算是電力系統中應用最廣泛、最基本，也是非常重要的一種電氣計算。它給電力系統的研究人員和實際運行人員提供了重要參考依據，也是許多電力系統高級應用軟體中不可缺少的一部分。本文針對配電網潮流計算的現狀進行了全面分析，深入討論了目前各方法的特點，並從收斂性能及各方面指標進行了比較分析，提出了基於復數矩陣的配電網潮流的原理、數學模型和實現方法，並通過編程于以實現。
  14. This paper analyses the type, function and characteristics of usual proportional control valves and raises a new modificative version in the light of their drawback. that is, basing on the principle of flow amplification and electrical feedback and throughout calculation and analysis on flow closed loop control and pressure flow combination., determination of the minimum controlled pressure difference as well as flow controlling range and structure of main valve and research of the dynamic and static characteristic, the paper puts forward control principle of " flow - load pressure change - displacement revision " and pressure / flow double closed loop, and further expounds that using a proportional controller and a electric mechanical transducer can separately serve the control function of pressure or flow as well as flow pressure combination

    本論文分析了目前常用比例閥的類型、功能、特性，並針對其不足提出新的改進方案，即：以流量放大，電反饋兩個原理為基礎，通過對流量閉環控制及壓力流量復合的計算分析、確定上最小控制壓差及流量控制范圍，確定主閥結構、功能特性研究等，提出了「流量? ?負載壓力變化? ?位移修正」的控制原理和壓力流量雙閉環控制原理，並進一步論述了利用一個比例控制器和一個「電?機械轉換器」就可完成獨立的壓力或流量控制功能以及流量壓力復合控制功能。
  15. To analyze economic compensations in the power market, the super decoupled load flow algorithm with distributed slack bus was adopted to conduct simulation analysis and calculation for power generation deviation

    摘要針對電力市場環境下經濟補償分析的需要，採用分散式鬆弛節點的超解耦潮流演算法對某實際電網發電偏離電量的現象進行了模擬分析計算。
  16. That is, through analysis of the principle on flow control and " hydraulic transistor ", design and calculation of flow control characteristic as well as main parts in valve inner chamber, a piloted reducing valve will be installed between main valve and pilot valve. after a pressure - difference compensating reducing valve was added in the non - pressure compensating piloted reducing valve of the flow control valve in vlalvistor valve, the calculation on control characteristic emulation and load characteristic emulation has been carried out. the result of the calculation shows that after pressure compensating reducing valve was added, the linearity of the control characteristics has been greatly improved thus eliminating influence upon outlet flow by load pressure - change of the hydraulic system and improving performance characteristics of the hydraulic component

    文章還在對瑞典valvistor閥的插裝比例閥研究的基礎上，提出了一種新的流量控制原理，即：通過對流量控制和「液壓晶體管」原理的分析、流量控制特性及閥內腔主要結構件的設計計算，在主閥和導閥之間增設先導減壓閥，並進一步對valvistor閥的流量控制閥之無壓力補償先導減壓閥、加入壓差補償減壓閥后的控制特性進行了模擬計算和負載特性模擬計算，結果表明：增設壓力補償先導增壓閥后，其控制特性曲線變得非常線性，從而消除了液壓系統負載壓力變化對主閥輸出流量的影響。
分享友人
分享到 Line

分享到臉書