load pulse 中文意思是什麼
load pulse
解釋
負載脈沖-
In the dissertation ' s chapter 3 to chapter 5, the mechanical and physical performances of the engineering plastics are analyzed, the failure mode and the designing computing methods of engineering plastics member suffering the static load, dynamic load, impact load, pulse load, are studied. by the practice application and ball firing experiment of the engineering plastics key piece in the weapons, the precious experiences, for engineering plastics application and confirmation of the material performances guideline in the weapons, are obtained
論文的第三章至第五章，分析了工程塑料物理機械性能，研究了受靜載荷、動載荷、沖擊載荷及脈沖載荷下工程塑料構件的失效模式和設計計算方法，通過工程塑料在槍械關鍵受力結構件上的實際應用和實彈射擊試驗，取得了寶貴的經驗，為高性能工程塑料在槍械上的應用和材料性能指標的確定奠定了基礎。 -
In the positioning servo - system, which generally is configured by the d. c. pulse width modulator ( pwm ) velocity governing system and position servo - loop, the parameter perturbance of pwm velocity loop really exist by reason of such as the load behavior ; power voltage supply ; operating setting value, etc. 1, 2 ， and it cannot be ignored. by using the identification technique to form the mathematical model of the system, authors have confirmed the facts. therefore, to design the discrete sliding mode controller ( dsmc ) of the positioning servo - system, the perturbed parameters value bounds of the pwm velocity loop, which is as the controlled plant of position servo - loop, should be accounted. consequently, the design principle of dsmc for accounting system with parameter perturbance is proposed by the authors. the proposed method can ensure the stability of system with parameter perturbance and the behavior of non - overshoot, fast precise positioning. in order to reveal the effects of the design method, the comparative research work is done by the authors. also, it has been tested in an industrial experiment, the results proved it is satisfactory
由直流脈寬調速系統（ pwm ）和位置環構成的定位系統中，速度環的參數隨負載特性；電網電壓；給定工況而攝動是不容忽視的.作者通過系統辨識建模也證實了這一事實1 ， 2 .因此在設計位置環的離散滑模控制時，必須針對速度環（即位置環的控制對象）的參數攝動范圍採用「對象參數攝動離散滑模控制器的設計方法」 ，以確保系統在參數攝動時的穩定性和快速、無超調、準確定位的優良動態品質.為剖析該設計方法的控制效果，本文作了對比性研究，並將該設計方法用於工業試驗中，取得了滿意的結果 -
A series of multi - pulse experiments are performed at breakdown voltage up to 400kv, peak current up to 30ka with an interval of 5ms, which shows spark gap switch could be obtained good insulation recovery in several milliseconds under the condition of water dielectric pulse power modulator with low load
在擊穿電壓400kv ，峰值電流30ka ，脈寬40ns的工作參數下，採用吹氣的辦法（氣流速度30m / s ） ，使氣體火花開關多脈沖運行間隔達到5ms ，實驗結果與理論估計相符。 -
Besides, practical load of the ghes varies with time. the variable load of ghes is decomposed as a series of pulse load, and the superimposition principle is employed to obtain the real temperature response of the ghes on basis of the theoretical solutions of a single borehole experiencing a constant heat flux
利用把具有摘要， . . . . . . . . . . . . . . .復雜邊界條件和熱源的問題分解為許多較簡單的問題的方法，把具有多個鉆孔的地熱換熱器溫度場化作許多單孔溫度場的益加，建立了多鉆孔地熱換熱器溫度場亞加模型。 -
Discharge the capacitor to a load after it has charged fully enough, and this produces an exponential decay pulse ( edp ) on the load
通過開關式穩壓電源產生高壓直流，並控制該電壓對電容器進行充放電就能輸出指數衰減陡脈沖波形。 -
Development of the digital dc - speed controller of the pulse load
脈動型負載的數字式直流調速器 -
The three - phase aviation static inverter with high frequency pulse dc link is made of three independent aviation static inverters and has the advantages such as strong function with unbalanced load and easy realization for module
三相高頻脈沖直流環節航空靜止變流器由三個獨立的航空靜止變流器構成，具有帶不平衡負載能力強、易於實現模塊化等優點。 -
The result indicates that the dynamic stress caused by hydraulic pulse at partial load is one of the important reason of the fatigue and cracks of the runner
結果表明由於水壓力脈動引起的轉輪葉片上的振動交變動應力是混流式水輪機疲勞破壞的主要原因之一。 -
In the master thesis, the fatigue characteristics of the ferroelectric films under thermal load and electrical load were investigated. the thermal load was induced by a pulse laser beam of nd : yag and the electrical load was made by rt6000s ferroelectric tester t o act on the films respectively. the effect of thermal or electric loads on the films properties was discussed
本文對鐵電薄膜在循環的熱載荷和電載荷作用下的疲勞特性進行了研究，分別用nd ： yag脈沖激光器模擬熱載荷、用rt6000s鐵電測試儀模擬電載荷作用於鐵電薄膜，根據實驗結果探討了這兩種載荷對鐵電薄膜性能的影響。 -
（ 2 ） the major circuit has been established, composed of rectifier 、 buck - chopper 、 push - pull inverter and matching network, which realizes high - power supersonic ac output. to achieve maximal output power, the pulse frequency modulation ( pfm ) has been applied to auto - adjustment of output frequency, which corresponds to the load ' s resonant frequency
（ 2 ）建立了超聲電源主電路，其中包括：整流、直流斬波、推挽逆變器和匹配網路等部分，實現了大功率超聲頻交流電的輸出，輸出頻率的脈頻調制（ pfm ）和輸出功率的脈寬調制（ pwm ） 。 -
To put into operation a large amount of non - linear load, make in harmony wave of rural power grids serious becoming in pollution, pass to rural local electric wire netting main in harmony analysis of wave source, put forward in order to restrain from insert rural power grids in harmony wave source voltage total in harmony wave distortion rate and the containing rate change last device number pulsating for increase of goal, increase the pulse of the current change device and install light specified value electricity active wave filter mix with passive wave filter near the harmonics source to control the wave in harmony
摘要大量非線性負荷的投運，使農村電網的諧波污染日趨嚴重，通過對農村地方電網主要諧波源的分析，最終提出了以限制接入農村電網的諧波源的電壓總諧波畸變率和各次諧波電壓含有率為目標的增加換流裝置脈動數，以及在諧波源附近裝設小額定值的電力有源濾波器配以無源濾波器的混合型電力濾波方式，以進行諧波治理。 -
The equilibrium current in 24 - pulse traction rectifier system is analyzed. the relation between critical load and resistance of traction rectifier transformer is discussed
摘要分析了24脈波牽引整流系統中的均衡電流，討論了臨界負載與牽引整流變壓器阻抗參數的關系。 -
After investigating the relationship between generator measuring speed pulse and its on - load voltage at phase a, it is proposed in the thesis that we can obtained phasor of generators through messuring dividing frequency signal of generator measuring speed pulse
我們研究了發電機測速脈沖和其a相空載電勢相位的關系，提出了只需測量與發電機同軸的測速發電機發出的測速脈沖的分頻信號，經過計算就可以得出發電機相角的測量方法。 -
It comes to a pulse skipping mode in a low load condition to decrease power loss and increase the operation efficency
電路的另一個特點是在輕負載時進入跨周期調制模式以減小功耗並提高效率。 -
Among them, phase shifted ( ps ) full bridge ( fb ) zero - voltage - switched ( zvs ) pulse - width - modulated ( pwm ) dc / dc converter has strong competitive power in big power capacity fields. but it has some limitations such as smaller load range with zvs and larger circulation energy. the ps - fb - zvs - pwm dc / dc converter with a saturable inductor utilizes saturable inductor s critical saturable current characteristic and storage energy, to enlarge load range with zvs and improve output efficiency under light load
其中，移相控制零電壓開關脈寬調制dc / dc全橋變換器在大容量領域很有競爭力，但它具有實現零電壓開關負載范圍小，循環能量大等限制，帶飽和電感的移相控制零電壓開關全橋變換器利用飽和電感的臨界飽和電流特性及儲能，來擴大零電壓開關（ zvs ）的負載范圍，提高輕載時的輸出效率，具有非常重要的研究價值。 -
This converter is thermally protected and current limited, protecting the load and regulator during fault conditions. in the circuit design chapter, the basic charge pump operation principle and equivalent circuit model are given first. then two control modes, pulse skip mode and linear mode, are analyzed
在電路設計中，首先分析了跨周期調制的電荷泵dc / dc轉換電路的基本原理，然後推導出電荷泵等效模型，以此為理論依據分析了電荷泵的兩種控制模式:線性調制模式和跳周期調制模式。 -
Finally, a compact uwb pulse source composed of pzt95 / 5 ferroelectric ceramic, a 50 coaxial transmission line charged by a pulse transformer, a peaking - chopping switch, a coaxial matched load and a pulse diagnostic system was built and tested, which can produce pulse voltage on a matched 50 load with peaking voltage of 100kv, rising time of 870ps, falling time of 670ps, and fwhm of 1. 410ns
在上述工作的基礎上，我們研製了一臺以pzt95 5鐵電陶瓷沖擊去極化為能源的新型緊湊型脈沖發生器。該發生器由pzt9515爆電能源、空心脈沖變壓器、單同軸脈沖形成線、 pc開關、同軸匹配負載和脈沖診斷系統組成，能產生100kv 、上升前沿870ps 、后沿670ps 、脈寬1 4us的超寬帶脈沖。 -
The inductive voltage of the thunder and lightning and the produced disturbance voltage when the inductive load turns on or is separated from the power network is main disturbance pulse voltage
摘要雷電感應電壓和感性負載接入或脫離電源電路時所產生的干擾電壓是電源網主要的干擾脈沖電壓。 -
In order to drive a high impedance load such as hpm sources, it is necessary to commutate fcg ' s long pulse width, high - current and low voltage pulse to a short pulse with high voltage
為用fcg驅動象hpm源這樣較高阻抗的負載，必須使用脈沖功率調制電路把fcg產生的低電壓、大電流、上升時間長的電壓脈沖轉化為高電壓、上升時間短的脈沖。 -
The load characteristics of clearing wastewater by electrocoagulation with the pulse power supply was also analyzed
在直流負載特性的基礎上，進一步分析了脈沖電源作用下的負載特徵。
分享友人