lock-in circuit 中文意思是什麼
lock-in circuit
解釋
同步電路強制同步電路-
The instrument is integrated with a multi - channel high precision open circuit potential measurement system for the ion selective electrode and a potentiostat used in voltammetry, an analog lock - in amplifier is also presented to measure the response of light addressable potential sensor
對于不同的測量技術，儀器中集成了用於測量電極的多通道高精度開路電壓測量系統和用於溶出伏安法測量的多路電化學測量系統，以及用於測量光尋址電位傳感器的鎖相放大器。 -
6 type products whether one have whorl, card lock connection device of organization, it apply to post and telecommunications communication equipment, figure buy the line device extensively, the radio instrument waits until joining the coaxial cable of the radio frequency to use in the radio frequency return circuit, and can change each other with the products that iec60169 - 13 stipulate
型產品是一種具有螺紋、卡鎖機構的連接器，它廣泛應用於郵電通信設備、數字配線裝置，無線電儀器等射頻迴路中連接射頻同軸電纜用，並能與iec60169 - 13規定的產品相互換。 -
The single - chip microcomputer control technology has been applied in the system to carry out monitoring and protective functions for the asynchronous motors controlled. combined with suitable peripheral interface, disposition and flexible software, the mcs can measure the current and voltage signals of the motors. based on the measurements, the computation, judgment and decision are made to implement the phase sensitive short circuit, overload, supply over - voltage, supply under - voltage, over - thermal, leakage lock - out and loss of phase protective function
系統採用單片機控制技術，完成所控制電動機的控制功能，並對所控制電動機的電壓、電流等信號進行檢測、計算、判斷和處理，實現短路、斷相、過載、欠壓、過壓、過熱、漏電閉鎖等保護功能，並提供本質安全型輸入、輸出介面，能與煤礦井下監測監控系統聯網運行。 -
Arranged signal activating lock circuit and time - base control circuit in the sound wave receiving circuit to take the initial signal of back wave as the valid one in the cycle, thus to improve the ratio of signal vs. noise and detective precision
在超聲波接收電路中設有信號觸發鎖定電路和時基控制電路。實現以各探頭中最早收到的回波信號為本檢測單元的有效信號，有效提高信噪比和檢測精度； 4 -
At the same time, essential protective electro circuit is designed for safe. it chooses pc bus industry programmable computer and programmable controller as the host computer and designs two independent systems to control hoist or lower the stage and orchestra separately. for the sake of running safely, it applies ac motor with brake as the power device that adopt frequency conversion mode and inter lock and journey switch in electric circuit
設計中選擇了pc總線工業控制機和可編程序控制器作為控制系統的主機，設計了兩個獨立的系統分別控制升降舞臺和升降樂池，採用了制動電機作為舞臺升降的拖動裝置，電機的調速方法選擇了可以無級平滑調速、經濟節能的變頻調速方法，並在電氣上採用互鎖和行程開關來保證舞臺機械設備的安全運行。 -
Phase lock and multiple frequency circuit diminishes the influence from frequency fluctuation of electric net ; in addition, multiple channels simultaneous sampling, high - precision circuit decreases the error caused from the sampling tache
用鎖相倍頻跟蹤電路來提供采樣頻率，以減少頻率波動的影響，用多路同採的高精度采樣電路來減少採樣環節引入的誤差。 -
Firstly, computer model of mdrlg is set up for simulation purpose. by simulation about the two output signals of mdrlg, four basic waveforms between the two signals in lock - in area are found out and the fact is discovered that the old phase - demodulation circuit introduces errors when it is used for demodulating two of the four basic waveforms
本文首先建立了機抖陀螺的計算機模擬模型，利用該模型對陀螺兩路計數信號及原有鑒相電路進行了模擬，發現兩路計數信號過鎖區時存在四種基本波形，且原有鑒相電路對其中兩種波形產生鑒相誤差。 -
The new unit has following technical features : ( 1 ) the unit ' s load is balanced by means of the accumulator and hydraulic cylinder with special structure ; ( 2 ) the installed power of the unit can be reduced greatly by adopting the accumulator ; ( 3 ) variable frequency speed regulation ensures good energy saving effect, and the closed oil circuit requires less hydraulic oil ; ( 4 ) a bi - directional hydraulic lock in the oil circuit ensures the stability and safety of the operation of the pumping unit
新型機具有4個技術特點： （ 1 ）由於活塞柱塞式液壓缸的特殊結構和液壓蓄能器的配合使用，在平衡抽油機大部分載荷時，不需另外增加配重，可減小抽油機體積、質量和佔地面積； （ 2 ）抽油機下沖程時，與活塞柱塞式液壓缸相連接的蓄能器吸收能量，上沖程時儲存在蓄能器中的能量補充載荷上行所需的能量，大幅度降低抽油機裝機功率； （ 3 ）利用變頻容積調速節能效率高，閉式油路節省液壓油，同時大大減小液壓泵站的體積； （ 4 ）在閉式油路中採用雙向液壓鎖可使抽油機的啟停更加平穩、迅速，其工作的穩定性和安全性更好。 -
The basic operation principle of phase - locked frequency synthesizer and the type of circuits are expatiated systematicly in this paper. the principle of operation on sampling phase detector and some characteristics including the linear tracking and phase noise in phase loop circuits are analyzed deeply. the research is emphased on the theory and design method of circuits in the sampling phase - locked frequency synthesizer. then, the expansion capturing circuit is analyzed and designed for better performance of capturing loop circuits. at last, the loop filter is also analyzed and contrived taking account of effection of additional phase shift by the sampling - holder. the general research on the theory and technology of sampling phase lock in the paper will make a basement for the development of new product
本文系統的闡述了鎖相頻率合成器的基本工作原理及電路類型；較深入地分析了取樣鑒相工作原理及電路、鎖相環路的線性跟蹤特性和相位噪聲特性；重點對取樣鎖相頻率合成器電路理論和設計方法進行了研究；為了改善環路的捕獲性能，對擴捕電路進行了分析和設計，並用wewb32軟體對電路進行了模擬；考慮到取樣保持器的附加相移影響，對環路濾波器進行了分析和設計。 -
Then according to the emphasis of the design, went deeply into the theory of pll frequency synthesizers widely used, described pll ’ s working principle, structure and several types in detail, and made research and analysis of pll frequency synthesizers ’ phase noise, including the effect of the active loop filter on the phase noise, and give some methods to make improvement as well, such as changing loop filter form, reducing divide number, and increase phase detector frequency, etc. then paper introduced the principle character and phase noise analysis of direct digital frequency synthesizer ( dds ) and injection phase lock circuit, which are also important circuits in the design
論文首先對幾十年頻率合成器的發展進行概述，而後針對本次設計的重點，對應用較為廣泛的鎖相頻率合成理論進行了深入的探討，詳細介紹了鎖相環的工作原理、組成結構和鎖相類型，並對鎖相頻率合成器的相噪特性進行了研究分析，包括有源環路濾波器對于相噪的影響，提出了改善相位噪聲的幾點措施:改善環路形式、降低分頻數、增大鑒相頻率等。接著介紹了直接數字頻率合成器（ dds ）和注入鎖相電路的原理特點以及相噪分析，它們也是本次設計的重要電路。 -
For the signals are very weak, the lock - in amplifier is employed to extract the signals in the circuit design. it can inhabit the noise in the most and maximize the signal - to - noise
因為信號十分微弱，所以在電路設計上採用鎖相放大器來提取信號，最大限度的抑制噪聲，提高系統的信噪比。 -
Photoelectric detecting circuit is constituted of four parts, i / v conversion, lock - in amplifier, low - pass filter and operation
光電檢測電路由四部分組成，分別是i / v轉換環節、鎖相放大環節、低通濾波環節、運算環節。 -
Function : power input : standard 220vac, 50hz ; power output : no load 12. 4 - 13. 63vdc, with load dc12v 13v standard current output : 10a moment current output : 10a control electric locks or bolts directly, reduce the load of access controller save project lines lower potential trouble have output nc no, control all kinds of electric locks has delay control circuit, unlock delay in 0 - 10s use exit button, press to 0pen the electric lock directly auto self - protection function : when short circle and other unexpected situation happen, the power supply can melt the fuse to protect itself
功能特性：交流輸入：標準ac220v 50hz直流輸出：空載輸出dc12 . 4v 13 . 63v負載輸出dc12v 13v標準輸出電流10a瞬間輸出電流10a直接控制電鎖：可減小門禁控制器的負荷，節省工程布線，減少故障隱患。設nc no輸出，可控制各種類型的電鎖。設延時控制電路，開鎖時間可在0 10秒。 -
Function : power input : standard 220vac, 50hz ; power output : no load 12. 4 - 13. 63vdc, with load dc12v 13v standard current output : 2. 5a moment current output : 2. 5a control electric locks or bolts directly, reduce the load of access controller save project lines lower potential trouble have output nc no, control all kinds of electric locks has delay control circuit, unlock delay in 0 - 10s use exit button, press to 0pen the electric lock directly auto self - protection function : when short circle and other unexpected situation happen, the power supply can melt the fuse to protect itself
功能特性：交流輸入：標準ac220v 50hz直流輸出：空載輸出dc12 . 4v 13 . 63v負載輸出dc12v 13v標準輸出電流2 . 5a瞬間輸出電流2 . 5a直接控制電鎖：可減小門禁控制器的負荷，節省工程布線，減少故障隱患。設nc no輸出，可控制各種類型的電鎖。設延時控制電路，開鎖時間可在0 10秒。 -
Function : power input : standard 220vac, 50hz ; power output : no load 12. 4 - 13. 63vdc, with load dc12v 13v standard current output : 5a moment current output : 5a control electric locks or bolts directly, reduce the load of access controller save project lines lower potential trouble have output nc no, control all kinds of electric locks has delay control circuit, unlock delay in 0 - 10s use exit button, press to 0pen the electric lock directly auto self - protection function : when short circle and other unexpected situation happen, the power supply can melt the fuse to protect itself
功能特性：交流輸入：標準ac220v 50hz直流輸出：空載輸出dc12 . 4v 13 . 63v負載輸出dc12v 13v標準輸出電流5a瞬間輸出電流5a直接控制電鎖：可減小門禁控制器的負荷，節省工程布線，減少故障隱患。設nc no輸出，可控制各種類型的電鎖。設延時控制電路，開鎖時間可在0 10秒。 -
Based the research on the laser beam drift feedback control technique, analysing the beam drift and its frequency components, a laser beam directional stability method is studied in the thesis in detail, with its measurement and control circuit system that combines the laser beam intensity modulation and the beam drift feedback control technique. in this method, at first the laser beam intensity is modulated with the acoustooptic modulator, then the lock - in amplifier is applied to detect and demodulate the modulating signal, at last a feedback control signal is generated by the dsp control circuit at last, including : 1
本文在原有的激光光束漂移量反饋控制準直技術的基礎上，對光束漂移量信號的數據和頻譜進行了分析，重點研究了一種集聲光調制光強與光束漂移量反饋控制準直技術於一體的激光光束方向穩定方法及其測控電路系統，該方法通過聲光調制實現光強調制，接著通過鎖相放大電路檢測並解調調制信號，然後通過dsp控制電路進一步對光束的漂移量進行反饋控制。 -
Chapter two addresses in details systematic design and related modules of stand - alone door - lock system. the modules include mcu, recognition module, power, lcd, guide voice, i / o decoding circuit, rtc, unlock circuit, power save and anti - interference design
第二部分著重介紹了指紋門禁單機系統的系統總體設計以及系統中涉及到的各模塊的基礎知識、設計思路和具體實現。
分享友人