loss on heating 中文意思是什麼

loss on heating 解釋
加熱損失
  • loss : n. 1. 喪失；丟失，遺失。2. 減損，損失，虧損（額）；損耗；減少，下降。3. 失敗；輸掉。4. 錯過；浪費。5. 損毀；【軍事】傷亡；〈pl. 〉 傷亡及被俘人數。
  • on : adv 1 〈接觸、覆蓋〉上去；開（opp off）。 turn on the light [radio water gas] 開電燈[收音機、自來...
  • heating : adj. 1. 加熱的；供熱的。2. 刺激的。n. 1. 加熱；供暖；（建築物的）暖氣裝置。2. 白熾，灼熱。
  1. Standard test method for loss on heating of oil and asphaltic compounds

    油及瀝青混合物加熱損失標準試驗方法
  2. So, this paper researches the principle of measuring system of insulating oil dielectric loss and volume resistivity. during the measuring process, the insulating oil must be heated and kept at 90 in 15 minutes. medium - frequency induction heating method is presented to instead of the electrical resistance furnace heating method on chapter 2, and a kind of subdivision - controlled integral - separated digital pid algorithm is designed to control the medium - frequency induction heating apparatus

    本文對恆溫控制系統進行了研究，提出了以中頻感應加熱方式取代原有的電阻爐加熱方式，設計了一種分段控制的積分分離式數字pid控制器來控制中頻感應加熱裝置，並通過通信設計將恆溫控制系統與介損及體積電阻率測試系統有機結合為一體機，實驗結果表明該恆溫控制系統完全滿足介損及體積電阻率測試中的控溫要求。
  3. Test method of weight loss on heating for rubber antiager and vulcanizing accelerators

    橡膠防老劑硫化促進劑加熱減量的測定方法
  4. Test method of weight loss on heating for rubber antiagers and vulcanizing accelerators

    橡膠防老劑硫化促進劑加熱減量的測定方法
  5. Standard test method for weight loss of plasticizers on heating

    增塑劑受熱時重量損失的試驗方法
  6. Rubber compounding ingredients. silica, precipitated, hydrated. determination of loss on heating

    橡膠配合劑.沉澱水合二氧化硅.加熱減量的測定
  7. Results show that the specific maximum weight loss rate can be used as a commonality parameter to evaluate and distinguish the reactivity of different coal and char, and that the heating rate selected in tga experiment has no effect on the judgment

    結果表明，最大比失重速率作為比較物質反應性的判據具有一定的通用性，能夠較好地區分不同煤焦之間的反應性；熱天平試驗升溫速率對判斷結果沒有影響。
  8. Rubber compounding ingredients. carbon black. determination of loss on heating

    橡膠配合材料.炭黑.熱損失的測定
  9. The differences between small - scale thermal power units and small - scale combined heat and power generating units are explained according to domestic energy policies. the advantages of co - production of heat and power are analyzed. the social and economic profits due to co - production of heat and power in the fields of energy saving, loss decreasing, environment protection and peak - valley power load regulation are discussed. the check index of thermal power plants is explained and advice on improving construction and operation of small - scale heating and power plants is suggested with consideration of domestic practice

    依據我國的能源政策，闡述了小熱電機組與小火電機組的區別；分析了熱電聯產的優越性；論述了熱電聯產在節能降耗、環境保護及電網調峰中產生的社會效益和經濟效益，並結合我國的實際，對熱電廠的考核指標進行了探討，對改善小熱電的建設與運行提出了建議。
  10. To reduce heat loss, the insulation must be coated on the pipe and heating cable

    為減少熱損失，應在電熱帶外側加保溫層。
  11. Thermosetting powder paints. determination of the loss in mass on heating

    熱固性粉狀塗料.加熱質量損耗的測定
  12. Set up a mathematical model for indoor thermal environment on the base of analyzing enclosure heat gain and heat loss of each envelope. programs were developed for floor heating and radiator heating respectively. due on higher surface temperature ( or mrt ) in the same room, the calculation results shown the indoor mean air temperature of heating radiator room was 1 ~ 1. 3 c higher than floor heating room under operative temperature same

    對連續供暖房間的熱過程進行了分析，根據房間熱過程數學模型編程計算結果顯示：由於散熱器供暖房間各圍護結構內表面對人體的平均輻射溫度低於低溫地板輻射供暖房間，要達到相同的作用溫度，散熱器供暖室內空氣溫度應比低溫地板輻射供暖房間高1 . 0 1 . 3 。
  13. Carbon black for rubber industry - secondary characteristics - part 1 : determination of loss on heating

    橡膠業用炭黑.二級特徵.第1部分:熱損耗的測定
  14. Test methods for pigments - part 15 : loss on heating - section 2 : ignition residue

    顏料試驗方法.第15部分:加熱損耗.第2節:燃燒殘余物
  15. One is that output window is cracked by the arcing on the surface of output window resulted by the secondary - electron, the other is that the stresses result from intense local heating produced by the power dissipation due to the loss factor of dielectric of the output window cause the output window to rupture 2. the second problem is now discussed in this dissertation

    這就會導致輸出窗片溫度過高，熱應力過大。當窗片的熱應力超出它的承受能力時，窗片就會破裂。因此，有必要對輸出窗進行熱分析研究，為輸出窗的設計提供理論依據。
  16. Plasticizers - determination of mass loss on heating

    增塑劑加熱減量的測定
  17. Rubber compounding ingredients - carbon black - determination of high - temperature loss on heating by thermogravimetry

    橡膠配合劑.炭黑.熱重分析法測定加熱的高溫損失
  18. Methods of test for paints - testing of coating powders - determination of loss of mass of coating powders on heating

    塗料試驗方法.第j5部分:粉末塗層加熱質量損失測定
  19. This paper also studied effects of categories of semi - coke, total pressure, oxygen concentration, particle size and heating rate on maximum mass loss - rate, burning time, burn - out temperature, and described the dynamic transformation of combustion reactivity of semi - coke under different testing condition

    分析了半焦種類、實驗總壓、氧濃度、試樣粒徑和加熱速率對最大失重速率、最大失重峰溫、燃燒時間、燃燼溫度等的影響。
分享友人
分享到 Line

分享到臉書