low-energy circuit 中文意思是什麼

low-energy circuit 解釋
低能量電路
  • low : adj 1 低的；淺的，矮的。 low flight 低飛。 a low temperature 低溫。 low tide [water] 低潮。 The g...
  • energy : n. 1. 干勁，活力。2. （語言、行為等的）生動。3. 〈pl. 〉 （個人的）精力；能力。4. 【物理學】能，能量。
  • circuit : n 1 （某一范圍的）周邊一圈；巡迴，周遊；巡迴路線[區域]；迂路。2 巡迴審判（區）；巡迴律師會。3 【...
  1. And experiment was based on the simulation, the results show that charge circuit and uplifted circuit both was adopted the same circuit, which can realize energy bi - directional flow, also have low switch ullage and high dynamic response

    在此基礎上進行了實驗研究，模擬和實驗結果表明，該裝置升壓和降壓只採用同一個主電路，即可實現能量的雙向流動，且具有低開關損耗和較高的動態響應。
  2. The technology of alternating - current - boosting by way of constant current is successfully used to charge capacitors with 25 kilojoules of energy in only eight seconds. rail - gap switch with performances of long life and highly steady state are designed. and the high voltage pulse generator, which can produce low - excursion and fast - rise pulses, are designed by using double trigger circuit and hydro - thyristor as switch

    在大功率恆流充電技術上，成功的應用了交流調壓式恆流技術，可以在8s內讓電容器儲存25kj的能量;設計出了長壽命、高穩定的軌道開關;採用氫閘流管做開關，使用雙觸發電路，研製出了低抖動、快前沿的高壓脈沖發生器（點火機） ;採用單片機和pld ，研製出了精度為10ns的延時同步機。
  3. There are five parts are as follows : in part one, the concept of switching function is introduced first to establish the nonlinear mathematical model of the induction motor variable frequency speed adjustment system which is fed by a sine pulse width modulated ( spwm ) inverter and takes the effect of the main magnetic circuit saturation into consideration, then the low frequency oscillation of the system is simulated according to the model. next, from the view point of energy conversion of the inverter - induction system, a criterion for the low frequency oscillation is proposed to determine whether the system is in low frequency oscillation which is judged by whether the interval of the negative current component of the inverter input current is more than 1 / fc ( fc is the carrier wave frequency of the inverter ) or not

    首先引入開關函數概念，建立了正弦脈寬調制（ spwm ）逆變器供電異步電動機，考慮主磁路飽和時的變頻調速系統整體數學模型，模擬系統的低頻振蕩；其次從逆變器-異步電動機系統能量轉換角度出發，提出通過檢測逆變器輸入電流中負電流的間隔時間是否大於1 / f _ c （ f _ c為逆變器載波頻率）來判定系統是否出現低頻振蕩；最後的實驗結果驗證了系統低頻振蕩建模和判據的實用性和正確性。
  4. The variable polarity power supply circuit uses two stages full - bridge inverter, the former inverter is regarded as a constant - current source with fast dynamic response, and supplys energy for the second one, and the latter one is to produce variable polarity current excellently, and low - frequency pulse current by variable polarity power supply is used to reduce input energy and control the shape of weld bead while welding. a series of high - frequency pulse current is superposed on direct - current - electrode - negative ( dcen ) current through the high - frequency pulse power supply, which is used to compress the arc and improve process of crystallization

    其中變極性電源採用二次全橋逆變結構，一次逆變提供快速的響應速率並給二次逆變提供能量，二次逆變提供良好的變極性性能，使輸出能量最優化，並用其低頻電流特性減小電弧線能量，控制焊縫成形;高頻脈沖電源提供的高頻電流疊加在反極性電流dcen上，利用電流的高頻特性壓縮電弧，改善焊縫金屬結晶過程。
  5. With its high reliability, small area, high - speed performance and low power dissipation, the high voltage integrated circuit ( hvic ) has unchangeable effect in the area of military affairs, aviation and nuclear energy

    高壓集成電路hvic （ highvoltageintegratedcircuits ）具有可靠性高、體積小、速度快、功耗低等優點，在軍事、航空航天及核能等領域有著不可替代的作用。
  6. A new full - wave measurement circuit structure is put forward that would increase distribution automation system reliability and veracity. the distributed protection and monitoring unit in this paper can instead of general instruments of low voltage distribution system. it not only combines ampere meter, voltage meter, active power meter, reactive power meter and power meter, frequency meter into a meter, but also increases monitoring position switch, control bus switching alternately and monitoring energy

    本文研製的保護和測控單元，可替代低壓配電系統中所使用的常規儀表，將原來迴路需要的電流表、電壓表、有功功率表、無功功率表和功率因數表、頻率表簡化為一塊表，並增加了位置開關量檢測，控制母線投切和電度監測功能，從而極大的簡化了低壓配電二次儀表設計、安裝調試，提高了運行、維護和管理水平。
  7. Compared with the similar research results, the weighted control ic here has the following characteristics : ( 1 ) the circuit structure is simpler ; ( 2 ) the chip ' s fabrication is compatible with standard cmos process ; ( 3 ) n - mosfets with high w / l ratio and short channels are used for weighting and output to reduce the insertion loss ; ( 4 ) the weighting factor varies in a relatively wide range with the controlling signals ; ( 5 ) input and output impedance approach 50 in low frequency ( e. g. 50mhz ), while in higher frequency they slightly deviate from 50, hence the energy reflection lower than 0. 1 ; ( 6 ) it completes the functions of sampling, weighting, controlling and summing of high frequency analog signals

    它的加權控制電路與已報道的相關電路相比具有如下特點：電路結構簡單；製造工藝與普通cmos工藝兼容：短溝道，高寬長比的nmos晶體管具有低的通導電阻，將其作為加權、輸出器件可降低由電路引起的插入損耗；改變加權信號，可實現權值在較大范圍內的連續變化；輸入、輸出阻抗在低頻（如50mhz ）下接近50 ，而在高頻下略有偏離50 ，但反射系數均低於0 . 1 ；實現了對高頻信號的取樣、加權、控制、疊加功能的迭加。
  8. To comnter the problem of high grinding energy, rapid flow of material, low ratio of material to grinding media, and bad ball coating in common open circuit ferric oxide tube mill, ferric oxide superfine grinding technology markedly increase grinding efficiency and improve grinding status in the tube mill by setting high efficiency sifting equipment, material place regulating technology and subminiature cylpeb

    摘要針對普通開流氧化鐵管磨機在氧化鐵生產過程中存在電耗高，流速快，料球比低、嚴重糊磨等問題，通過在磨內設里高效篩分裝蘭，採用料位調節、微型鋼段等技術措施，極大地改善了磨內粉磨工況，提高了粉磨效率。
  9. Firstly, the basic theory of switch reluctance generator ( srg ) is discussed in detailed, based on the mechanism electric energy converting analysis, non - linear analysis and non - linear simulation. three control methods of srg ( angle position control method, current chopping control method, pulse width modulation control method ) are deeply studied and analyzed. the electronic controller, which controlled by dsp or by hardware circuit are developed for low - power switched reluctance generation system

    首先系統地研究了開關磁阻電機發電運行的基本理論，從機電能量變換的角度分析開關磁阻發電機的機電能量變化規律；通過非線性分析和非線性模擬方法，明晰開關磁阻電機發電本質，概括出開關磁阻電機發電運行的特點；系統、深入地研究了開關磁阻電機發電運行的控制方案（角度位置控制、電流斬波控制、脈寬調制控制） 。
  10. ( 2 ) the damping mechanism of multi - energy transitions takes effect when the vgcf content is among the semi - conductive area. when the vgcf content is low ( below 8 % ), the vgcf conductive circuit does not form and the heat loss is quite little. when the vgcf content is higher than 20 %, the transition efficiency between electric energy and heat is limited

    這是由於當vgcf含量太少時（低於8 ） ，復合材料中導電網路還沒有來得及形成，起不到能量損耗的目的；而當vgcf含量太高時（高於20 ） ，電導率太高，復合材料成為電的良導體，電能與熱能之間的轉換效率很低，能量損耗也不高。
分享友人
分享到 Line

分享到臉書