magnetic annealing 中文意思是什麼
-
One is to improve the photoconductivity by annealing the mpc film under magnetic field ; the other is to form composite multi - layer film of zno / pbpc and sno / pbpc, to change the spectral response range of mpc films
一是通過磁場熱處理提高酞菁薄膜的光電導性能；二是通過將p型酞菁與n型材料異質復合，改變光譜響應范圍。 -
When the atomic ratio of nb is one, the structure is homogeneous and almost composed of the single sm2fe17 phase. it ' s nearly the same structure as that after annealing. so it can reduce the production cost and increase the stability of magnetic properties
當nb的原子比為1時的鑄態組織基本為均勻的接近單相的sm _ 2fe _ （ 17 ）組織，已接近於退火后的組織，從而可以避免冗長的均勻化退火化過程而直接用於製造永磁體，極大的降低了生產成本，並能有效的提高磁性能的穩定性。 -
Addition agent for mgo used on the silicon steel the agent can improve qualities of oriented silicon - steel coatings, enhance magnetic properties of silicon steel and decrease the finishing annealing emperature and time in manufacturing of oriented steel
作用：專用於取向硅鋼片高溫退火隔離塗層，是國內新的取向硅鋼塗層用氧化鎂，該塗層具有國內第二代硅鋼氧化鎂的透氣性，又具有納米氧化鎂的活性。 -
By sims method, we analyzed the profile distribution of mn and c, found that increasing the annealing temperature is beneficial to the diffusion of mn, but has no influence to c. mfm and squid measurements demonstrate that sub micron single - domain magnetic mnas particles found in sample annealing at 850 for 15s show ferromagnetism at room temperature and have a high curie temperature more than 300k
利用二次離子質譜方法對mn和c在樣品中的分佈進行了研究，發現退火溫度的上升，有利於mn的擴散；而對c的分佈影響較小。利用磁力顯微鏡和超導量子干涉儀對樣品的磁性質進行了研究。發現在850 + 15s退火處理的樣品中形成了亞微米級單疇磁性mnas粒子；經測試其在室溫下呈現出鐵磁性，居里溫度在300k以上。 -
At last, we observed the surface morphology and magnetism of the samples by atomic force microscopy ( afm ) and magnetic force microscopy ( mfm ), the formation of mnga and mnas magnetic precipitates was discovered and the precipitates were affected by the conditions of implantation and annealing
最後，通過原子力顯微鏡（ afm ）和磁力顯微鏡（ mfm ）觀察了樣品的表面形貌和磁特性，發現了退火樣品中形成了磁性第二相mnga或mnas粒子，並且這些磁性粒子的磁特性與注入條件和退火條件有關。 -
The effects of preparation conditions and thermal annealing on the microstructure, magnetic properties and magnetoresistance of fex 1 - x granular films
多晶鈣鈦礦錳氧化物中的巨磁電阻與磁場關系 -
The results indicate that the best annealing temperature is 1100 for 2h. a conclusion has been drawn that when the mol percent of iron is 60 %, the productions of powders and cycle samples have the best magnetic properties
通過對shs粉末樣品和磁環的磁性能測試發現：當反應產物中fe的摩爾分數為0 . 6時，粉末樣品粒徑大小均勻，產物具有較高的比飽和磁化強度和低的矯頑力。 -
The results showed that the microstructure of as - deposited tbdyfe ii 1ms were amorphous and the crystal of tbfe2 were found in films after annealing at 500. annealing films in vaccum could improve the saturation magnetization ms and the susceptibility, decrease the coercivity and the saturaion field, and make the direction of the magnetic moments parallel to the film plane
結果表明，制備態薄膜為非晶態結構，經過500真空退火熱處理后，薄膜出現了tbfe _ 2的結晶物，薄膜的矯頑力和外場的飽和磁場大大降低，飽和磁化強度增強，初始磁化率提高，易磁化軸轉向膜面。 -
This paper has first summarized the experiment of granular film and theoretical research progress and the present major problem to be solved, has discussed the purpose meaning of this paper on this foundation, has introduced us soon afterwards with magnetic metal - non - magnetic metal material adopt for studying object to co - vapored deposited system such as the fexcu1 - x of different fe content x granular film sample, carrying out annealing handling for some of samples, using x ray diffraction instrument xrd ), scanning electrical microscopic ( sem ), vibrating sample magnetometer ( vsm ) the tiny structure for sample, appearance and the magnetic result that can carry out detection
本文首先綜述了顆粒膜的實驗和理論研究進展情況和目前待解決的主要問題，在此基礎上論述了本文的目的意義，隨后介紹了我們以磁性金屬?非磁性金屬材料為研究對象，採用共蒸發法制備不同fe含量x的fe _ xcu _ （ 1 - x ） ，顆粒膜樣品，對部分樣品進行退火處理。給出了用x射線衍射儀（ xrd ） 、掃描電鏡（ sem ） 、振動樣品磁強計（ vsm ）對樣品的微結構、形貌及磁性能進行檢測的結果。 -
With sem, x - ray diffraction analysis, magnetic measurement by magnetic property measurement system, the effects of growth and annealing conditions are analyzed
超導薄膜，採用磁測量m - t x射線衍射掃描電子顯微鏡技術分析了各種沉積及退火條件對mgb -
Influence of annealing temperatures on soft magnetic properties of nanocrystalline feconbvsibcu alloy
合金軟磁性能的影響 -
3 we use vsm, for annealing and do not annealing sample have gone on magnetic properties measure, combination origin software shows for the loop analysis of magnetic hysteresis : do not coercivity of annealing pellet membrane between38. 898oe and 96. 487oe, the coercivity of annealing sample between 30. 327oeand91. 591oe
3 、用vsm對退火和未退火樣品進行了磁性能測量，結合origin軟體對磁滯回線分析表明:未退火顆粒膜的矯頑力在38 . 898oe ~ % . 4870e之間，退火樣品的矯頑力在30 . 327oe ~引 -
High pressure gas - quenching of high - speed steel, tool and mould steel, alloy structure steel etc and annealing of magnetic materials
高速鋼工模具鋼合金結構鋼等材料的高壓氣淬，以及磁性材料的退火等工藝。 -
High pressure gas - quenching of work - pieces in the form of long pole made and high - speed steel, tool and mould steel, alloy structure steel etc. annealing of magnetic materials
實例：適合長桿類的高速鋼工模具鋼合金結構鋼等材料的高壓氣淬，以及磁性材料的退火等。 -
For example, the furnaces can be used for quenching of high - speed steel, mould steel, alloy structure steel, bearing steel, elastic alloy etc, sintering and annealing of magnetic materials, and so on
其它熱處理工藝根據用戶要求實例：高速鋼模具鋼合金結構鋼軸承鋼彈性合金等材料的淬火，以及磁性材料的燒結退火等。 -
In the making process we use hot - forging warm - forging cold extrusion forming and magnetic annealing processes to completely solve the problem of complex form hign precision dimensions difficult manufacturing lower power and so on. what s more, part surface is very smooth with no trimmed margin, continuous flowing metal fiber, high strength, lower noise. forged claw poles obviously increase generator s power and life, and also improve finished product rate of roughness
在製造過程中採用了熱鍛溫鍛冷擠壓成型及磁性退火等先進生產工藝徹底解決了精鍛「爪極」形狀復雜尺寸精度高製造難度大功率低等問題，且產品表面光潔無飛邊金屬流動纖維連續毛坯強度大噪音低，明顯提高了發電機的功率和壽命，並且提高了毛坯成品率。 -
In this paper, we implanted mn + ion of different dose into undoped semi - insulating ( 100 ) gaas substrate then performed rapid thermal annealing in different temperature and time. studied the different annealing condition dependence of the samples " structure, electrical and magnetic properties and the relation of the mn + forms and these properties
本課題採用離子注入的方法將不同劑量的mn ~ +注入到非摻雜半絕緣（ 100 ） gaas單晶襯底中，然後進行不同溫度和時間的快速熱退火處理，研究了不同的退火條件對樣品注入層的晶體結構、電特性和磁特性的影響以及mn ~ +在樣品中的存在狀態與這些性質之間的關系。 -
Zny, ni ( 1 - y ) fe2o4 and cobalt substituted ni - zn soft ferrite powders of zn0. 4ni ( 0. 6 - a ) coa fe2o4 are synthesized by shs. the shs powders and cycle samples are annealing in 1100 for 2h. their magnetic, and micro structural properties are studied using xrd, vsm and sem techniques. the studies reveal that the value of hc mr and ms of the powder of zn yni ( 1 - y ) fe2o4 are maximal when the value of y is 0. 4
研究發現：隨著zno含量（ y值）的增加，粉末產物的矯頑力（ hc ） 、飽和磁矩（ ms ）以及剩餘磁矩（ mr ）先增大（在y = 0 . 4時取得最大值）然後再下降；磁環表面顆粒逐漸長大，孔隙率減少，密度增加；磁環的bs與br先增大再減小，在y = 0 . 4時達到最大；磁環的矯頑力hc是遞減的。 -
Ptmn has practically been used as anti - ferromagnetic layer to pin ferromagnetic layers because of its large exchange bias, high blocking temperature and excellent thermal stability. on the other hand, ptmn films deposited by magnetron sputtering without substrate heating require a relatively high temperature post - deposition annealing in magnetic field to induce a unidirectional exchange field hes
由於ptmn反鐵磁材料具有大的交換偏置，比較高的blocking溫度和較好的熱穩定性，在自旋閥結構中ptmn已經在實際應用上用來釘扎鐵磁層。
分享友人