magnetic maximum 中文意思是什麼

magnetic maximum 解釋
磁力高
  • magnetic : adj. 1. 磁（性）的；（可）磁化的。2. 吸引人心的；有魅力的。3. 催眠術的。
  • maximum : n （pl maximums ma ） 極點，最大，最高，最高額，最大值；最高點；最大限度；【數學】極大（值）（opp...
  1. The resistivity of the films drops compared with the as - grown films, but the temperature of maximum magnetoresistance reaches 287k, very close to the room temperature. therefore it is not only an important improvement to fabricate the cmr bolometer which can work near room temperature, but also a prospective research for other applications such as magnetic - sensors, spintronics devices and infrared detectors

    同時，退火后薄膜的電阻率明顯下降，外加5t磁場時，最大磁電阻率溫度點上升到287k ，接近於室溫，這不僅為製作室溫超巨磁電阻測輻射熱儀打下了堅實的基礎，也為其它許多器件的應用提供了可能。
  2. The influence of msfvw bandwidth on the diffraction efficiency is also considered. for the nonuniform bias magnetic field of u - type parabola profile, when the msw frequency is less than the cut - off frequency at the edge of mo film, the effective mo interaction length reduces. the edge cut - off frequency is determined by the maximum of the nonuniform field

    對于拋物型分佈（開口向上）的偏置磁場，當激發靜磁波的rf頻率小於邊緣截止頻率時，磁光作用的有效長度減小（與靜磁波頻率有關） ;邊緣截止頻率由不均勻磁場的最大值決定，靜磁波的下限截止頻率由不均勻場的最小值確定。
  3. When a ferromagnetism items is under the application of stress, the phenomenon that the tangential component of magnetic leakage field has maximum value and that the normal component of magnetic leakage field changes polarity and acquires zero value at the stress concentration zone will take place

    鐵磁性工件在受到應力作用時，在應力集中處會有漏磁場的切向分量出現最大值、同時法向分量改變符號且過零值點的現象。
  4. According to the effective field expression which has been derived in former, the phenomenon that the tangential component of magnetic leakage field has maximum value and the normal component of magnetic leakage field acquires zero value at the stress concentration zone of positive magnetostriction ferromagnetism materials under the application of tensile stress and negative magnetostriction ferromagnetism materials under the application of compressive stress is explained theoretically through analyzing and discussing

    根據所得到的地磁場中受力鐵磁性材料有效場表達式，通過分析討論，解釋了受拉力作用的正磁致伸縮鐵磁材料和受壓力作用的負磁致伸縮材料在應力集中處漏磁場切向分量出現最大值、同時法向分量為零值的現象。
  5. It is found from the experiment that under the conditions of peak magnetic field of 0. 57t, beam pulse fwhm ( full width of half maximum ) of 44ns, a microwave radiation pulse with fwhm 25ns and whole width of 35ns is produced, when the intensity of the guiding magnetic field rises, the peak microwave power changes little but the width of the pulse reduces. the a - k gap also has obvious influence on the microwave radiation, the stable and higher microwave output is obtained under suitable gap

    實驗中還發現，在峰值磁場0 . 57t和束流半高寬44ns情況下，得到了25ns半高寬和35ns底寬的微波脈沖信號，隨著導引磁場增加，微波信號幅值基本不變，但國防科學技術大學研究生院學位論文是微波脈沖寬度會逐步減少;實驗中還發現磁場線圈位置有一定的軸向調節范圍，說明在磁場軸向分佈的一定變化范圍內，器件都可以正常工作，這對以後的永磁場系統導引的微波實驗有利。
  6. Meanwhile the method of calculating the maximum and minimum inductance is programmed in visual c + + 6. 0 language. and an software which can check the characteristics of model srm only by the structure and magnetic field results is provided. the software has an interactive face that make the calculation direct

    採用visualc + + 6 . 0語言編制了計算最大和最小電感的磁化曲線的計算程序，並開發了一個利用srm幾何尺寸和磁場計算結果核算電機性能參數的軟體，軟體採用互動式用戶界面，使計算直觀化。
  7. The simulation results show the existence of both limits and optima for the studied parameters, related to the stable operation and the maximum efficiency, respectively. underlying the conditions that the longitudinal guiding magnetic field is 1. 8t, diode voltage is 250 kv, the impedance is 150, we got a peak power as high as 100 mw for the tm01 mode at 38ghz

    經優化設計，本文給出了一個相對論亞納秒毫米波返波振蕩器的物理模型，在引導磁場為1 . 8t 、二極體電壓為250kv 、阻抗為150的情況下得到了超輻射狀態下輸出微波峰值功率為100mw 、中心頻率為38ghz 、模式為tm _ （ 01 ）模的微波輻射。
  8. With the content of iron carbide in carbonyl iron decreasing, and rise, and shear stress ( at ) induced by magnetic field of mrs declines, the shear rate corresponding to the maximum at ( " y max ) heightens, and the response time of a t shortens. with the content of dmf increasing, the size of carbonyl iron reduces so that a t of mrs enhances, and increases with h more rapidly and " y max heightens

    隨著羰基鐵粒子碳化物含量的減少， 、增加，而mrs的磁致剪切應力下降，最高剪切速率_ （ max ）增加，磁流變響應時間縮短；隨著dmf用量的增加，羰基鐵粒子的二次顆粒尺寸減小， mrs的增加，且隨外加磁場強度h增加的速率提高， _ （ max ）提高。
  9. The optimum condition in hydrogen desorption pressure is p = 800 - 100000pa. comparing the magnets prepared by traditional ball milling process, the magnets prepared by hydrogen desorption have lower residual magnetization and maximum magnetic energy product

    最佳的脫氫氣壓在800 - 100000pa之間hd法制備的燒結ndfeb永磁體的剩磁和最大磁能積比傳統bm工藝稍低。
  10. The maximum output of ion beam current is obtained at a charging voltage of 8 kv for the magnetic field power system, which is in accordance with the theory of magnetic insulation. the ion beam parameters are an accelerating voltage of 300 kv, an ion current density of 300 a / cm2 with beam pu lse width of 80 ns and with composition of 70 % proton and 30 % carbon ions

    在磁場電源電壓為8kv ，獲得了與磁絕緣理論相符的最大離子束流密度輸出，離子束參數為：加速電壓300kv ，離子束流密度300a cm ~ 2 ，離子束脈沖寬度80ns ，成分約為70 h離子和30 c離子。
  11. And flux distributions and radial force of an induction type bearingless motor is analyzed employing the finite element method. relationships between the radial force and radial force winding currents are influenced by magnetic saturation. it was shown that the generated radial force reaches its maximum value due to magnetic saturation

    首次運用有限元方法對該電機進行了深入的研究，充分展現了無軸承異步電機特有的氣隙磁場分佈、驗證了穩定磁懸浮力產生的條件、指出了磁飽和對磁懸浮力的影響、利用有限元方法修正了磁懸浮力數學模型。
  12. When the content of nife _ ( 2 ) o _ ( 4 ) reaches to 30 %, the maximum mr value gets to - 6 % at the temperature from 310k to 340k, and the resistivity ranges from 1354 to 646 cm, where applied magnetic field is 1. 8t. it is interesting that the mr value is negative which is different from that of the usual material ; 4. with the decreasing of sr contents, the resistivity of composite samples ( nd _ ( 1 - x ) sr _ ( x ) mno _ ( 3 ) ) _ ( 0. 7 ) / ( nife _ ( 2 ) o _ ( 4 ) ) _ ( 0. 3 ) changes apparently, at the same time, the mr gets worse ; 5

    3系列復合樣品的電阻率顯著變化，同時磁電阻性能逐漸變差; 5 .隨著cu含量的增大，伽嘶67sr033mnl一uyo3 ） 07 /困ifezo4 ） 03系列復合樣品的電阻率顯著變化，同時磁電阻性能得到明顯改善，當cu含量增大到y = 0 . 2時，樣品磁電阻值在293k到317k較寬的溫度范圍內基本保持在一13 . 6 % ，隨溫度變化很小，由於該溫區恰好在室溫范圍且溫區寬，因而具有很好的潛在應用價值。
  13. For the sample with the content of fe2o3 is 9 %, the maximum mr value of the composition ( lao9sroimno3 ) o9i ( fe2o3 ) oo9 increased in the negative direction, and get the maximum - 7 % at 337k ; with the content of feio increased, the mr of the composition increased also, when the content of fe2o3 is 17 %, the maximum mr value of the composition ( lao. gsro imno3 ) o. 83 ( feio o. n can reach - 30 % at 338k, where applied magnetic field is 1. 5t

    含量為9的樣品，樣品的磁電阻值在238k時隨溫度的升高而逐漸向負的方向增大，在337k時達到極值7 ；對于fe 。 oz含量為門的樣品，樣品的磁電阻值在265k時隨溫度的升高而逐漸增大，兩種不同比例的復合體系都在很寬的溫區內表現出較大的磁電阻，尤其後者，在1 st外場作用下， 338k時mr達到極值30 。
  14. We find a critical magnetic field at which the concurrence changes sharply from zero to maximum entanglement

    我們發現存在臨界磁場，在該磁場處，糾纏度迅速從0轉為1 。
  15. Its a high performance, low temperature coefficient permanent magnet with its high working temperature350 degree centigrade. when working above 180 degree centigrade, its maximum energy product bh and steady temperature are superior than ndfeb magnetic materials

    是由釤鈷和其它金屬稀土材料經配比，溶煉成合金，經粉碎壓型燒結后製成的一種磁性材料，具有高磁能積極低的溫度系數，最高工作溫度可達
分享友人
分享到 Line

分享到臉書