mass heat transfer 中文意思是什麼

mass heat transfer 解釋
質量傳熱
  • mass : n 彌撒;彌撒的儀式[禱告、音樂];彌撒曲。 a high [solemn] Mass (有燒香、奏樂等的)大彌撒。 a low ...
  • heat : n 1 熱;熱力;熱度;熱量。2 體溫;發燒。3 (氣候的)高溫,暑氣。4 【冶金】熔煉的爐次;裝爐量;一...
  • transfer : n 1 移轉,轉送;調職;調任[轉學]證書;變換。2 (財產;權利等的)轉讓,讓與(證書),移轉,授受;...
  1. Experimental investigation on post - dryout heat transfer in narrow annuli at low mass velocity

    低質量流速下環形通道內乾涸后傳熱實驗研究
  2. Convection is heat transfer by mass motion of a fluid such as air or water when the heated fluid is caused to move away from the source of heat, carrying energy with it

    對流是傳熱集體議案的流體,如空氣或水,當加熱流體是造成搬離努力從源頭上的熱量,進行能量與它。
  3. The results indicate that : the high positioned air inflow do good to heat transfer in rotator disk ; different size of radial outflow have small effects on flow and heat transfer ; the heat transfer near rotating disk increases as rotating reynold number increases or non - dimensional mass flow rate increases

    結果表明,高位軸向進氣對轉盤換熱有利;不同的徑向出口大小對盤腔內的流動換熱影響不大;隨旋轉雷諾數和無量綱質量流量增加,轉盤盤面的換熱效果增強。
  4. By comparing the results with relative experiment data, it is shown that rng k - is more exactly than the other turbulent model. 2 ) the influences of axial inflow position, radial outflow size, rotating reynold number, non - dimensional mass flowrate and axial inflow angle on the flow and heat transfer characteristics were numerically investigated for a typical rotator - stator cavity with axial inflow, radial inflow and radial outflow. the correlations for average nusselt number vs rotating reynold number or non - dimensional mass flowrate were established

    ( 2 )針對一典型的徑向、軸向進氣,徑向出氣的轉-靜盤腔結構,系統研究軸向進氣位置、徑向出口大小、旋轉雷諾數、無量綱質量流量和軸向垂直預旋進氣等對盤腔內流動和換熱的影響,整理出轉-靜盤腔內轉盤平均努謝爾數與旋轉雷諾數無量綱質量流量之間的準則關聯式。
  5. 4 ) in a pre - swirl rotator - stator cavities with discrete pre - swirl nozzles and blade - cooling entry holes, the influences of pre - swirl angle and flow parameter on the flow and heat transfer characteristics were numerically investigated. the correlation for average nusselt number vs rotating reynold number or non - dimensional mass flowrate were established. the results show that : advantage of per - swirl inflow is the effect of cooling the blade - cooling entry holes ; pre - swirl inflow increases heat transfer in rotating disk of pre - swirl chamber ; as pre - swirl angle increases, local nusselt number decreases in pre - swirl chamber ; the temperature of stator of inner rotator - stator chamber and per - swirl chamber decreases as rotating reynold number increases ; when the axial mass flowrate maintains constant, heat transfer in the rotating disk of inner rotator - stator cavities does n ' t change as per - swirl mass flowrate increases, while heat transfer in the rotating disk of per - swirl chamber increases ; when the pre - swirl mass flowrate maintains constant, change of the axial mass flowrate has effect on the whole cavity

    結果表明,預旋進氣的優點在於增強了葉片冷卻孔附近的對流換熱效果,局部努謝爾數隨預旋角的增大而有所減小;隨旋轉雷諾數的增加,不論是內轉靜腔室還是預旋腔室的靜盤上的溫度都不同程度的降低:當軸向中心進氣質量流量不變時,隨預旋進氣的質量流量增加,內轉靜腔室的轉盤盤面上的換熱基本沒有變化,而預旋腔室的轉盤盤面上的換熱效果增強;當預旋進氣質量流量不變時,軸向中心進氣的質量流量的改變對整個盤腔都有影響。
  6. A brief introduction of vmd process is presented. mass and heat transfer behavior through hot side, membrane as well as cold side during vmd process is analyzed and derived

    本文在評述真空膜蒸餾技術研究現狀的基礎上,對膜蒸餾過程熱側、膜內及冷側的質量傳輸和熱量傳輸行為進行了深入的分析與推導。
  7. Finally, by studying the heat transfer coefficient and the mechanism of mass transfer through the membrane pores, a complete mathematical model was proposed for the removal of voc from dilute aqueous solutions by vmd

    根據對傳熱系數和膜孔內傳質機理的研究,最後得到了真空膜蒸餾脫除水溶液中voc全過程的數學模型。
  8. The synergy of the gravitational field with the other fields influences the mass transfer, heat transfer and affinity adsorption in the tapered bed, and the transfer directions depend upon the synergy results

    上流錐形床親和層析在多場協同下,其傳質、傳熱以及吸附反應相互影響,過程的最終傳遞方向將取決于各場之間綜合作用的結果。
  9. Mass and heat transfer in air gap membrane distillation process

    氣隙式膜蒸餾傳遞過程的研究
  10. The investigation on the evaporation heat transfer characteristics in a horizontal micro - fin tube for r290 - 3gs mixture shows : a ) the average evaporation heat transfer coefficient of the mixture increase with the increasing of the mass flux

    R290含油混合物在水平微肋管內流動沸騰換熱特性的實驗研究表明: a )隨著質量流率的增加,含油混合物微肋管內的沸騰平均換熱系數增加。
  11. W. qu and i. mudawar, “ experimental and numerical study of pressure drop and heat transfer in a single - phase micro - channel heat sink, ” international journal of heat and mass transfer, vol. 45, pp. 2549 - 2565, 2002

    吳德洋, 「散熱座應用於水冷系統之效能評估」 ,大同大學機械工程研究所碩士學位?文, 2003年6月。
  12. Abstract : the transfer performance such as hydrodynamics, mass transfer, heat transfer and mixing in turbulent bed contactor were systematically presented, and the calculations on this equipment were also given

    文摘:系統地介紹了湍球塔的流體力學行為和傳質、傳熱、混合等傳遞過程及其工程設計計算。
  13. Column reactors are important facility in which the mass and heat transfer happens. since bubbly flow is a basic flow pattern of gas - liquid two - phase flow in the column, thorough study on bubbly flow is of great scientific significance and important value for practical industry application

    鼓泡塔反應器是重要的傳熱傳質設備,鼓泡塔泡狀流是氣液兩相流的一種基本流型,對泡狀流進行廣泛而深入的研究具有重要的科研價值和工業應用背景。
  14. On the basis of above theoretical derivation and analysis on experimental results, by correlating solvent ( water ) transfer with solute ( salt ) transfer on hot side and correlating mass transfer with heat transfer during vmd and introducing a contribution coefficient which can reflect the characteristics of mass transfer through membrane, a new model of mixed flow is presented

    在上述理論推導及實驗分析的基礎上,本文將熱側溶劑傳輸與溶質傳輸、膜蒸餾過程熱量傳輸與質量傳輸相關聯,並引入一個能夠反映膜內質量傳輸特徵的「貢獻系數」 ,將努森流模型與粘性流模型結合起來,從而提出了新的混合流模型。
  15. Behavior of flow and heat transfer in venturi tube was simulated numerically and the relationships of outlet temperature, mass fraction of vapor and pressure loss with spraying flow rate were obtained

    當噴射流量小於臨界噴射流量時,出口爐氣的溫度和水蒸氣質量分數隨噴射流量的增大分別呈線性下降和上升關系;當噴射流量大於臨界噴射流量時,爐氣降溫和水蒸氣質量分數增長不顯著。
  16. This paper introduces the measurement methods and results of cdq - boiler system for mass and energy balance diagnosis, analyses the technologic economic index at the different product rate, puts forward the measures of decreasing the ratio of coke burning, improving the heat transfer conditions and realizing the optimized control aftertime

    摘要介紹了寶鋼三期干熄爐鍋爐系統質能診斷方案及其測試結果,分析了不同生產率下的主要技術經濟指標,提出了今後進一步降低焦炭燒損率,改善爐內傳熱和實現優化控制的技術措施。
  17. In this paper, we aim at establish heat and mass coupled transfer model in the building wall, the emphasis of this study lies in creating a coupled and non - linear diferential equation system for the heat air and moisture transfer in the wall, which can be described by means of continuum mechanics and irreversible thermodynamics, the most dominant factor is moisture conten 9la gas pressure pc and temperature t, for the description of heatair and moisture transport, the general mass balance equation can be expressed by the temporal change of moisture conten 9 l, gas pressure pc and temperature t that means, in order to create a closed solvable equation system, the other additional dependencies have to be found, which the other variable depending on the variables of the solution : moisture conten 6 l gas pressure pc and temperature to the model is verified by the numerical simulation software which has been developed about building wall.,

    根據節能設計要求,本文用熱力學的方法,並根據多孔介質中多相流體流動描述方面的最新研究成果? ?體積平均方程,建立了墻體熱、濕和空氣耦合熱質傳遞模型,並推導出熱、濕和空氣耦合傳遞等效擴散方程;找到建築墻體熱、濕及空氣耦合作用下熱質傳遞過程的主要影響因素濕容量_ l 、氣壓p _ c和溫度t 。開發了單體材料墻體熱質傳遞數值模擬軟體,用實測數據對軟體進行調試並對模擬計算結果進行了驗證。模擬出了單材料墻體在熱、濕和空氣耦合作用下建築墻體內的溫度和濕度分佈規律。
  18. Abstract : the paper firstly introduces three different approaches for the kinetic modeling of supercritical fluid extraction ( sfe ) ( empirical models, models based on the heat transfer analogy, and models based on differential mass balance ), and then models kinetic process of the sfe of flavonoid compounds from cedrela sinensis leaves in the presence of ultrasonic, at last shows the defects existed in most of the contemporary kinetic models through the example

    文摘:首先介紹了三種動力學模擬超臨界流體萃取的模型(經驗模型、基於熱傳遞類推的模型以及基於微分質量平衡的模型) ,然後模擬了在超聲存在的條件下超臨界流體從香椿葉中萃取黃酮類化合物的動力學過程,最後通過該例子展示了現有大多數動力學模型的缺點
  19. The paper firstly introduces three different approaches for the kinetic modeling of supercritical fluid extraction ( sfe ) ( empirical models, models based on the heat transfer analogy, and models based on differential mass balance ), and then models kinetic process of the sfe of flavonoid compounds from cedrela sinensis leaves in the presence of ultrasonic, at last shows the defects existed in most of the contemporary kinetic models through the example

    摘要首先介紹了三種動力學模擬超臨界流體萃取的模型(經驗模型、基於熱傳遞類推的模型以及基於微分質量平衡的模型) ,然後模擬了在超聲存在的條件下超臨界流體從香椿葉中萃取黃酮類化合物的動力學過程,最後通過該例子展示了現有大多數動力學模型的缺點。
  20. The influence of various waterpower and configuration parameters on heat transfer is analysed and the rules of convective heat transfer coefficient and the ratio of heat transfer enhancement with mass flux are obtained. at the same time, we gain important results as below : as for resonance chamber with certain configuration, self - oscillation can be generated under suitable configuration and waterpower parameters. for the same configuration resonance chamber, the intensity of the self - oscillation is changed by the waterpower parameters

    當流量及壓差降低至一定程度時,共振腔還可能削弱換熱;加熱功率的提高會增加流體(水)的溫度,流體的粘度會隨著降低,這會減少對流體脈動的阻礙,使脈動衰減得更慢,而脈動幅度的增加會增強換熱,故加熱功率對有脈動的對流換熱是有影響的;自振腔產生的流體脈動頻率是自振腔固有頻率或其整數倍,流體脈動頻率過高或過低都不利於對流換熱,存在一有利於強化換熱的頻率范圍。
分享友人