mass loss rate 中文意思是什麼
mass loss rate
解釋
質量損失率-
The bacilliform cell penetrate into interior of the fibre to degrade the cellulose strongly and produced a mass of sticky polysaccharides. after cultured 48 hours, the bacilliform cell ' s surface of sporocytophaga have a great change. at this stage the bacilliform produce a lot of sticky polysaccharides. these sticky polysaccharides associated with the sites where the filter paper was decomposed intensively and form thorns on the surface of the bacillium. at the same time, the filter - paper weight loss is the greatest and decomposing rate is the fastest, so we think that the sticky polysaccharides are produced during the cellulose degradation
培養48小時，桿狀細胞的表面結構發生很大的變化，此時的菌體表面已產生大量的粘性多糖，這些粘性多糖因菌體在纖維素表面滑動而在菌體表面形成突起，即在纖維素被旺盛降解部位的菌體表面產生了大量突起；而產生突起的菌體深入到纖維素分子內部，纖維素表面可以清晰地看到由於菌體嵌入纖維素分子內部而留下的凹陷。 -
( 2000 ). the neutron irradiation is assumed to derive primarily by the reaction 13c ( a, n ) i60 with a minor contribution from the marginal burning of 22ne through the channel 22ne ( a n ) 23mg in the final, high temprature phase of each flash. and we considered the influence of the various parameters such as the initial core mass, the envelope mass, the mass - loss rate, the overlap factor and the delution factor etc., and we vary their value with the pulse number
本文採用分叉s -過程反應通道，以~ （ 13 ） c （ ， n ） ~ （ 16 ） o 、 ~ （ 22 ） ne （ ， n ） ~ （ 25 ） mg為雙脈沖中子源，用最新的中子俘獲截面，利用gallino和busso等人給出的agb星三殼層核合成模型，考慮到核心質量、挖掘程度、重疊因子、稀釋因子及星風質量損失率隨脈沖數的變化，詳細計算和研究了各個金屬豐度情況下的3m 。 -
Mass loss rate
質量損失率 -
We observed that higher habitual calcium intake was associated with better bone mass and lower rate of bone loss
54 %和0 . 56 % 。而鈣質攝取量高者骨質流失率亦比較低。 -
Behavior of flow and heat transfer in venturi tube was simulated numerically and the relationships of outlet temperature, mass fraction of vapor and pressure loss with spraying flow rate were obtained
當噴射流量小於臨界噴射流量時，出口爐氣的溫度和水蒸氣質量分數隨噴射流量的增大分別呈線性下降和上升關系；當噴射流量大於臨界噴射流量時，爐氣降溫和水蒸氣質量分數增長不顯著。 -
In view of the poor thermal stability of polyoxymethylene ( pom ) induced by the residual catalyst and unstable end groups formed in the synthesis of pom. the pom was treated by amine, and the effects of the variety of amine compounds, treatment technology and water content on the thermal stability of pom were investigated ; the effect of triethanolamine on the thermal stability of pom was further studied by means of isothermal mass loss, isothermal mass loss rate, and formaldehyde emission amount
摘要針對聚甲醛由於合成中殘留催化劑及不穩定端基導致其熱穩定較差的問題，採用胺對聚甲醛進行處理，並考察了胺種類、胺處理工藝及水用量對聚甲醛熱穩定性能影響；採用等溫熱質量損失率、等溫熱質量損失速率、甲醛釋放量分析等方法對三乙醇胺對pom的熱穩定作用進行了進一步研究。 -
This paper also studied effects of categories of semi - coke, total pressure, oxygen concentration, particle size and heating rate on maximum mass loss - rate, burning time, burn - out temperature, and described the dynamic transformation of combustion reactivity of semi - coke under different testing condition
分析了半焦種類、實驗總壓、氧濃度、試樣粒徑和加熱速率對最大失重速率、最大失重峰溫、燃燒時間、燃燼溫度等的影響。
分享友人